학지사 뉴논문

총 1,637건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

1111.

Synthesis and characterization of carbon doped TiO₂ photocatalysts supported on stainless steel mesh by sol-gel method

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 6 48-59 (12 pages)

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 저
...
- 4,100원
This study synthesized pure anatase carbon doped TiO₂ photocatalysts supported on a stainless steel mesh using a sol-gel solution of 8% polyacrylonitrile (PAN)/dimethylformamide (DMF)/TiCl₄. The influence of the pyrolysis temperature and holding time on the morphological characteristics, particle sizes and surface area of the prepared catalyst was investigated. The prepared catalysts were characterized by several analytical methods: high resolution scanning electron microscopy (HRSEM), energy...
1112.

Thermo-electrical properties of randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, N. Supriya 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 3 25-35 (11 pages)

Thakur Sudesh Kumar Raunija, N. Supriya 저
...
- 4,000원
The aim of the work was to investigate the thermo-electrical properties of low cost and rapidly produced randomly oriented carbon/carbon (C/C) composite. The composite body was fabricated by combining the high-pressure hot-pressing (HP) method with the lowpressure impregnation thermosetting carbonization (ITC) method. After the ITC method step selected samples were graphitized at 3000°C. Detailed characterization of the samples’ physical properties and thermal properties, including thermal...
1113.

Disorientation angle influence on the thermal residual stresses in carbon multilayered composite plates of different thicknesses

Olga Bitkina, Ki-Weon Kang, Jang-Ho Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 13 98-102 (5 pages)

Olga Bitkina, Ki-Weon Kang, Jang-Ho Lee 저
...
- 1,500원
One of the most acute problems in studying composite stress-strain states is determining the initial residual stresses during the design of layered construction elements. The full stress?strain state of composite constructions consists of the initial (generated during the manufacturing process) and operating (generated during the working period) stages. A thorough investigation of the initial stage of the stress-strain state is very important to finding the total stresses and deformations, and...
1114.

Effect of carbonization temperature on crystalline structure and properties of isotropic pitch-based carbon fiber

Jung Dam Kim, Jae-Seung Roh, Myung-Soo Kim 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 6 51-60 (10 pages)

Jung Dam Kim, Jae-Seung Roh, Myung-Soo Kim 저
...
- 3,000원
Isotropic pitch-based fibers produced from coal tar pitch with the melt-blowing method were carbonized at temperatures ranging from 800 to 1600oC to investigate their crystalline structure and physical properties as a function of the carbonization temperature. The in-plane crystallite size (La) of the carbonized pitch fiber from X-ray diffraction increased monotonously by increasing the carbonization temperature resulting in a gradual increase in the electrical conductivity from 169 to 3800...
1115.

Preparation of gold nanoparticle/single-walled carbon nanotube nanohybrids using biologically programmed peptide for application of flexible transparent conducting films

MinHo Yang, Bong Gill Choi 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 4 26-31 (6 pages)

MinHo Yang, Bong Gill Choi 저
...
- 3,000원
In this study, we report a general method for preparation of a one-dimensional (1D) arrangement of Au nanoparticles on single-walled carbon nanotubes (SWNTs) using biologically programmed peptides as structure-guiding 1D templates. The peptides were designed by the combination of glutamic acid (E), glycine (G), and phenylalanine (F) amino acids; peptides efficiently debundled and exfoliated the SWNTs for stability of the dispersion and guided the growth of the array of Au nanoparticles in a...
1116.

The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 저
...
- 3,000원
Taguchi’s experimental design was employed in the melt spinning of molten mesophase pitch to produce carbon fibers. The textures of the obtained carbon fibers were radial with varied crack angles, as observed by scanning electron microscopy and polarized optical imaging. The diameter, crack angle, preferred orientation, and tensile modulus of the produced samples were examined to investigate the influence of four spinning variables. The relative importance of the variables has been emphasized...
1117.

Yield enhancement of matrix precursor in short carbon fiber reinforced randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 7 57-65 (9 pages)

Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 저
...
- 3,000원
real system was studied. The fourier transform infrared spectrometry (FTIR), thermogravimetric analysis (TGA), yield, yield rate, and yield impact were used to check the effect of stabilization and pressure on the yield of the matrix precursor and the end properties of the composite thereafter. The results showed that the yield increased with stabilization duration up to 20 h whereas it decreased for stabilization duration beyond 20 h. Further results showed that the stabilized matrix precursor...
1118.

Effect of fiber-matrix adhesion on the fracture behavior of a carbon fiber reinforced thermoplastic-modified epoxy matrix

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 6 47-56 (10 pages)

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 저
...
- 3,000원
known silane, (3-glycidoxy propyl trimethoxysilane) coupling agent. Toughness was determined using the double cantilever test, together with surface analysis after failure using scanning electron microscope. The presence of polysulfone particles improved the fracture behavior of the composite, but fiber-matrix adhesion seemed to play a very important role in the performance of the composite material. There appeared to be a synergy between the matrix modifier and the fibermatrix adhesion coupling...
1119.

Adsorption of lisinopril and chlorpheniramine from aqueous solution on dehydrated and activated carbons

El-Said I. El-Shafey, Haider A. J. Al-Lawati, Wafa S. H. Al-Saidi 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 2 12-22 (11 pages)

El-Said I. El-Shafey, Haider A. J. Al-Lawati, Wafa S. H. Al-Saidi 저
...
- 4,000원
Date palm leaflets were used as a precursor to prepare dehydrated carbon (DC) via phosphoric acid treatment at 150°C. DC, acidified with H3PO4, was converted to activated carbon (AC) at 500°C under a nitrogen atmosphere. DC shows very low surface area (6.1 m2/g) while AC possesses very high surface area (829 m2/g). The removal of lisinopril (LIS) and chlorpheniramine (CP) from an aqueous solution was tested at different pH, contact time, concentration, and temperature on both carbons. The...
1120.

Phenylethynyl-terminated polyimide, exfoliated graphite nanoplatelets, and the composites: an overview

Donghwan Cho, Lawrence T. Drzal 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 1 1-11 (11 pages)

Donghwan Cho, Lawrence T. Drzal 저
...
- 4,000원
In efforts to characterize and understand the properties and processing of phenylethynyl-terminated imide (LaRC PETI-5, simply referred to as PETI-5) oligomers and polymers as a high-temperature sizing material for carbon fiber-reinforced polymer matrix composites, PETI-5 imidization and thermal curing behaviors have been extensively investigated based on the phenylethynyl end-group reaction. These studies are reviewed here. In addition, the use of PETI-5 to enhance interfacial adhesion between...

한주간 이슈검색어