자료유형
발행기관
- 한국식물병리학회(104)
- 한국탄소학회(101)
- 대한생리학회-대한약리학회(27)
- 대한수의학회(25)
- 대한치과이식임플란트학회(6)
- 인문사회과학기술융합학회(5)
- 한방비만학회(4)
- 대한약리학회(3)
- 한국기초간호학회(3)
- 환태평양유아교육연구학회(2)
- 은행법학회(1)
- 한국미술치료학회(1)
- 한국식품위생안전성학회(1)
- 한국열환경공학회(1)
간행물
- CARBON LETTERS(101)
- THE PLANT PATHOLOGY JOURNAL (90)
- THE KOREAN JOURNAL OF PHYSIOLOGY & PHARMACOLOGY(27)
- JOURNAL OF VETERINARY SCIENCE(18)
- 식물병연구(14)
- KOREAN JOURNAL OF VETERINARY RESEARCH(구 대한수의학회지)(7)
- JOURNAL OF DENTAL IMPLANT RESEARCH(6)
- 예술인문사회융합멀티미디어논문지(5)
- 대한한방비만학회지(4)
- JOURNAL OF KOREAN BIOLOGICAL NURSING SCIENCE(3)
- 대한약리학잡지(3)
- ASIA-PACIFIC JOURNAL OF RESEARCH IN EARLY CHILDHOOD EDUCATION(2)
- 미술치료연구(1)
- 열환경공학(1)
- 은행법연구(1)
- 한국식품위생안전성학회지(1)
전체 선택해제
총 284건 검색
본문검색 결과만 보기
-
Study of complex electrodeposited thin film with multi-layer graphene-coated metal nanoparticles
Young-Lae Cho, Jung-woo Lee, Chan Park, Young-il Song, Su-Jeong Suh 한국탄소학회 Carbon Letters 6 Pages
한국탄소학회 Carbon Letters 2017, Vol.21 8 68-73 (6 pages)
We have demonstrated the production of thin films containing multilayer graphene-coated copper nanoparticles (MGCNs) by a commercial electrodeposition method. The MGCNs were produced by electrical wire explosion, an easily applied technique for creating hybrid metal nanoparticles. The nanoparticles had average diameters of 10?120 nm and quasispherical morphologies. We made a complex-electrodeposited copper thin film (CETF) with a thickness of 4.8 μm by adding 300 ppm MGCNs to the electrolyte... -
Effect of carbonization temperature on crystalline structure and properties of isotropic pitch-based carbon fiber
Jung Dam Kim, Jae-Seung Roh, Myung-Soo Kim 한국탄소학회 Carbon Letters 10 Pages
한국탄소학회 Carbon Letters 2017, Vol.21 6 51-60 (10 pages)
from 800 to 1200oC probably due to randomization through the process of gas evolution; however, structural ordering eventually occurred at around 1400oC. For the carbonized pitch powder without stabilization, structural ordering perpendicular to the graphene planes occurred at around 800?900oC indicating that oxygen was inserted during the stabilization process. Additionally, the shear stress that occurred during the melt-blowing process might interfere with the crystallization of the CPF. -
Synthesize multi-walled carbon nanotubes via catalytic chemical vapour deposition method on Fe-Ni bimetallic catalyst supported on kaolin
Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 한국탄소학회 Carbon Letters 18 Pages
한국탄소학회 Carbon Letters 2017, Vol.21 5 33-50 (18 pages)
In this study, Fe-Ni bimetallic catalyst supported on kaolin is prepared by a wet impregnation method. The effects of mass of kaolin support, pre-calcination time, pre-calcination temperature and stirring speed on catalyst yields are examined. Then, the optimal supported Fe-Ni catalyst is utilised to produce multi-walled carbon nanotubes (MWCNTs) using catalytic chemical vapour deposition (CCVD) method. The catalysts and MWCNTs prepared using the optimal conditions are characterized using high... -
Mechanical properties of epoxy composites reinforced with ammonia-treated graphene oxides
Mi-Seon Park, Sangmin Lee, Young-Seak Lee 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2017, Vol.21 1 1-7 (7 pages)
The effects of ammonia-treated graphene oxide (GO) on composites based on epoxy resin were investigated. Ammonia solutions of different concentrations (14?28%) were used to modify GO. Nitrogen functional groups were introduced on the GO surfaces without significant structural changes. The ammonia-treated GO-based epoxy composites exhibited interesting changes in their mechanical properties related to the presence of nitrogen functional groups, particularly amine (C-NH2) groups on the GO... -
Activating needle coke to develop anode catalyst for direct methanol fuel cell
Young Hun Park, Ui-Su Im, Byung-Rok Lee, Dong-Hyun Peck, Sang-Kyung Kim, Young Woo Rhee, Doo-Hwan Jung 한국탄소학회 Carbon Letters 6 Pages
한국탄소학회 Carbon Letters 2016, Vol.20 7 47-52 (6 pages)
Physical and electrochemical qualities were analyzed after KOH activation of a direct methanol fuel cell using needle coke as anode supporter. The results of research on support loaded with platinum-ruthenium suggest that an activated KOH needle coke container has the lowest onset potential and the highest degree of catalyst activity among all commercial catalysts. Through an analysis of the CO stripping voltammetry, we found that KOH activated catalysis showed a 21% higher electrochemical... -
Yield enhancement of matrix precursor in short carbon fiber reinforced randomly oriented carbon/carbon composite
Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 9 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 7 57-65 (9 pages)
Isroaniso matrix precursor synthesized from commercially available petroleum pitch was stabilized in air. The influence of oxygen mass gain during stabilization on the yield of matrix precursor was studied. Additionally, the influence of pressure on the yield of the stabilized matrix precursor in a real system was studied. The fourier transform infrared spectrometry (FTIR), thermogravimetric analysis (TGA), yield, yield rate, and yield impact were used to check the effect of stabilization and... -
Study on urea precursor effect on the electroactivities of nitrogen-doped graphene nanosheets electrodes for lithium cells
Ki-Yong Kim, Yongju Jung, Seok Kim 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 5 40-46 (7 pages)
Nitrogen-atom doped graphene oxide was considered to prevent the dissolution of polysulfide and to guarantee the enhanced redox reaction of sulfur for good cycle performance of lithium sulfur cells. In this study, we used urea as a nitrogen source due to its low cost and easy preparation. To find the optimum urea content, we tested three different ratios of urea to graphene oxide. The morphology of the composites was examined by field emission scanning electron microscope. Functional groups and... -
Carbon rich fly ash and their nanostructures
Numan Salah, Sami S. Habib, Zishan H. Khan, Ahmed Alshahrie, Adnan Memic, Attieh A. Al-ghamdi 한국탄소학회 Carbon Letters 9 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 3 23-31 (9 pages)
precursor and catalyst for carbon nanotube growth. This fly ash powder is mostly composed of pure carbon, predominantly present as sp2. In this work, the effect of sonication time on the morphology and structural properties of carbon rich fly ash particles is reported. The obtained results show that ultrasound treatment is an effective tool for producing ultrafine particles/fragments with higher porosity, which might be suitable for the adsorption of gasses. Moreover, carbon nanoparticles (CNPs)... -
Photocatalytic degradation and antibacterial investigation of nano synthesized Ag₃VO₄ particles @PAN nanofibers
Prem Singh Saud, Zafar Khan Ghouri, Bishweshwar Pant, Taehee An, Joong Hee Lee, Mira Park, Hak-Yong Kim 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2016, Vol.18 5 30-36 (7 pages)
Well-dispersed Ag₃VO₄ nanoparticles @polyacrylonitrile (PAN) nanofibers were synthesized by an easily controlled, template-free method as a photo-catalyst for the degradation of methylene blue. Their structural, optical, and photocatalytic properties have been studied by X-ray diffraction, transmission electron microscopy, field-emission scanning electron microscopy equipped with rapid energy dispersive analysis of X-ray, photoluminescence, and ultraviolet?visible spectroscopy. The... -
Monolithic porous carbon materials prepared from polyurethane foam templates
Jo?o Pires, Andr? Janeiro, Filipe J. Oliveira, Alexandre C. Bastos, Mois?s L. Pinto 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2016, Vol.18 2 11-17 (7 pages)
Monolithic carbon foams with hierarchical porosity were prepared from polyurethane templates and resol precursors. Mesoporosity was achieved through the use of soft templating with surfactant Pluronic F127, and macroporosity from the polyurethane foams was retained. Conditions to obtain high porosity materials were optimized. The best materials have high specific surface areas (380 and 582 m2 g?1, respectively) and high electrical conductivity, which make them good candidates for supports in...
