학지사 뉴논문

총 521건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

161.

Dispersions of partially reduced graphene oxide in various organic solvents and polymers

Hye Min Kim, Seo Gyun Kim, Heon Sang Lee 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 8 55-62 (8 pages)

Hye Min Kim, Seo Gyun Kim, Heon Sang Lee 저
...
- 3,000원
We report on the dispersion state of partially reduced graphene oxide (PRGO) in organic solvents, namely methyl ethyl ketone, ethyl acetate, methylene chloride, toluene, and xylene, by controlling the carbon to oxygen (C/O) atomic ratio of the PRGOs. A two-phase solvent exchange method is also proposed to transfer PRGO from water to an aprotic solvent, such as methyl ethyl ketone. We achieve relatively good dispersion in aprotic and non-polar solvents by controlling the C/O atomic ratio of the...
162.

Electrochemical determination of chloramphenicol using a glassy carbon electrode modified with dendrite-like Fe₃O₄ nanoparticles

Krishnan Giribabu, Sung-Chan Jang, Yuvaraj Haldorai, Muruganantham Rethinasabapathy, Seo Yeong Oh, Arunkumar Rengaraj, Young-Kyu Han 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 6 38-47 (10 pages)

Krishnan Giribabu, Sung-Chan Jang, Yuvaraj Haldorai, Muruganantham Rethinasabapathy, Seo Yeong Oh, Arunkumar Rengaraj, Young-Kyu Han 저
...
- 3,000원
-1.3 V for 180 s. Scanning electron microscopy revealed that dendrite-like Fe3O4 nanoparticles with a mean size of < 80 nm were electrodeposited on a glassy carbon electrode (GCE). The Fe3O4/GCE was utilized for sensing chloramphenicol (CAP) by cyclic voltammetry and square wave voltammetry. A reduction peak of CAP at the Fe3O4/GCE was observed at 0.62 V, whereas the uncoated GCE exhibited a very small response compared to that of the Fe3O4/GCE. The electrocatalytic ability of Fe3O4 was mainly...
163.

Synthesis, characterization, and antibacterial performance of Ag-modified graphene oxide reinforced electrospun polyurethane nanofibers

Bishweshwar Pant, Mira Park, Rae-Sang Jang, Woo-Cheol Choi, Hak-Yong Kim, Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 3 17-21 (5 pages)

Bishweshwar Pant, Mira Park, Rae-Sang Jang, Woo-Cheol Choi, Hak-Yong Kim, Soo-Jin Park 저
...
- 1,500원
distribution of GO sheets along with Ag nanoparticle in the nano?bers was investigated by scanning electron microscopy and the elemental mapping technique. X-ray diffraction and thermal gravimetric analysis veri?ed the presence of GO and Ag in the bicomposite nano?brous mats. Antibacterial tests against Escherichia coli demonstrated that the addition of GO and Ag-RGO to the PU nano?ber greatly enhanced bactericidal efficiency. Overall, these features of the synthesized nano?bers make them a...
164.

Li-ion battery anodes from ginkgo leaf-derived nanoporous carbons rich in redox-active heteroatoms

Na Rae Kim, Hong Joo An, Young Soo Yun, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 13 110-114 (5 pages)

Na Rae Kim, Hong Joo An, Young Soo Yun, Hyoung-Joon Jin 저
...
- 1,500원
Lithium-ion batteries (LIBs) have attracted increasing attention as a sustainable power source due to the rapid growth in mobile electronics and electric automobile markets, driven by increasing environmental awareness [1-4]. The electrochemical performance of LIBs is strongly dependent on the active electrode materials. Therefore, their continuing advanced development is of key importance to meet the expectations of the market [5-7]. Graphite, commonly used in LIB anodes, forms binary graphite...
165.

Adsorption characteristics of heavy metals ions by physical activation on coal tar pitch-based activated carbon fibers

Bo-kyung Choi, Jae-Kyoung Ko, Soo-Jin Park, Min-Kang Seo 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 10 96-100 (5 pages)

Bo-kyung Choi, Jae-Kyoung Ko, Soo-Jin Park, Min-Kang Seo 저
...
- 1,500원
Due to the increasing population growth of modern society, along with rapid industrial development and urbanization, environmental pollution continues to worsen and has become an important issue, not only domestically but also worldwide. In particular, toxic substances such as heavy metal ions are present in the wastewater produced by various industries. This wastewater flows into rivers, pollutes water supplies, and can contaminate the drinking water supplied to people [1-3]. Powder or...
166.

Nitrogen-doped carbon nanosheets from polyurethane foams and removal of Cr(VI)

Jiaqi Duan, Baohua Zhang, Huailin Fan, Wenzhong Shen, Shijie Qu 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 7 60-69 (10 pages)

Jiaqi Duan, Baohua Zhang, Huailin Fan, Wenzhong Shen, Shijie Qu 저
...
- 3,000원
hydrothermal carbonization following ZnCl2 chemical activation. Scanning electron microscopy, thermogravimetric analysis, Fourier transform infrared spectroscopy, solid state 13C nuclear magnetic resonance (NMR) spectra and X-ray photoelectron spectroscopy were used to characterize the nitrogen-doped carbon nanosheet structure and composition. The removal of Cr(VI) by the N-doped carbon nanosheets was investigated. The results showed that the maximum removal capacity for chromium of 188 mg/g was...
167.

Synthesis and characterization of carbon doped TiO₂ photocatalysts supported on stainless steel mesh by sol-gel method

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 6 48-59 (12 pages)

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 저
...
- 4,100원
several analytical methods: high resolution scanning electron microscopy (HRSEM), energy dispersive spectroscopy (EDS), X-ray diffraction (XRD), Brunauer-Emmett-Teller (BET), and X-ray photoelectron spectroscopy (XPS). The XRD patterns showed that the supported TiO₂ nanocrystals are typically anatase, polycrystalline and body-centered tetragonal in structure. The EDS and XPS results complemented one another and confirmed the presence of carbon species in or on the TiO₂ layer, and the XPS data...
168.

Graphene accelerates osteoblast attachment and biomineralization

Jia Ren, Xiaogang Zhang, Yao Chen 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 5 42-47 (6 pages)

Jia Ren, Xiaogang Zhang, Yao Chen 저
...
- 3,000원
In this paper, the in vitro biocompatibility of graphene film (GF) with osteoblasts was evaluated through cell adhesion, viability, alkaline phosphatase activity, F-actin and vinculin expressions, versus graphite paper as a reference material. The results showed that MG-63 cells exhibited stronger cell adhesion, better proliferation and viability on GF, and osteoblasts cultured on GF exhibited vinculin expression throughout the cell body. The rougher and wrinkled surface morphology, higher...
169.

Three-dimensional porous graphene materials for environmental applications

Muruganantham Rethinasabapathy, Sung-Min Kang, Sung-Chan Jang, Yun Suk Huh 한국탄소학회 Carbon Letters 13 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 1 1-13 (13 pages)

Muruganantham Rethinasabapathy, Sung-Min Kang, Sung-Chan Jang, Yun Suk Huh 저
...
- 4,200원
Porous materials play a vital role in science and technology. The ability to control their pore structures at the atomic, molecular, and nanometer scales enable interactions with atoms, ions and molecules to occur throughout the bulk of the material, for practical applications. Three-dimensional (3D) porous carbon-based materials (e.g., graphene aerogels/hydrogels, sponges and foams) made of graphene or graphene oxide-based networks have attracted considerable attention because they offer low...
170.

The effects of carbon coating onto graphite filler on the structure and properties of carbon foams

Ji-Hyun Kim, Do Young Kim, Young-Seak Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 16 111-115 (5 pages)

Ji-Hyun Kim, Do Young Kim, Young-Seak Lee 저
...
- 1,500원
Carbon foams (CFms) are of crucial importance in electrical and mechanical devices due to their high thermal conductivity used for eliminating high heat flow and maintaining low temperatures [1]. The most common CFms are types of aluminum alloys, copper and diamond. However, the mechanical properties of metal-based heat sink materials are difficult to control at temperatures over 550°C [2,3]. Thus, CFms are actively investigated as heat sink materials because of their good properties, such as...

한주간 이슈검색어