학지사 뉴논문

총 521건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

211.

Conducting and interface characterization of carbonate-type organic electrolytes containing EMImBF4 as an additive against activated carbon electrode

Mingyeong Kim, Kyungmin Kim and Seok Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 8 51-56 (6 pages)

Mingyeong Kim, Kyungmin Kim and Seok Kim 저
...
- 3,000원
salts, and by adding different contents of 1-ethyl-3-methyl imidazolium tetrafluoroborate (EMImBF4). Cyclic voltammetry and linear sweep voltammetry were performed to analyze conducting behaviors. The surface characterizations were analyzed by scanning electron microscopy method and X-ray photoelectron spectroscopy. From the experimental results, increasing the EMImBF4 content increased the ionic conductivity and reduced bulk resistance and interfacial resistance. In particular, after adding 15...
212.

Effect of surface treatment of graphene nanoplatelets for improvement of thermal and electrical properties of epoxy composites

Minjae Kim, Yeongseon Kim, Sung Hyeon Baeck and Sang Eun Shim 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 5 34-40 (7 pages)

Minjae Kim, Yeongseon Kim, Sung Hyeon Baeck and Sang Eun Shim 저
...
- 3,000원
(GPTS), and 3-glycidoxypropyltrimethoxysilane (GPTMS), were used. Among theses, GPTMS exhibits the best modification performance for fabricating GNP-incorporated epoxy composites. The effect of the silanization is evaluated using transmission electron microscopy (TEM), scanning electron microscopy, thermogravimetric analysis, and energy dispersive X-ray spectroscopy. The electrical and thermal conductivities are characterized. The epoxy/silanized GNPs exhibits higher thermal and electrical...
213.

Influence of hot-pressing pressure on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 4 25-33 (9 pages)

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 저
...
- 3,000원
The prime objective of this research was to study the influence of hot-pressing pressure and matrix-to-reinforcement ratio on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon-composite. Secondary objectives included determination of the physical and mechanical properties of the resulting composite. The ‘hybrid carbon-fiberreinforced mesophase-pitch-derived carbon-matrix’ composite was fabricated by hot pressing. During hot pressing, pressure was varied from 5...
214.

Thermal properties in strong hydrogen bonding systems composed of poly(vinyl alcohol), polyethyleneimine, and graphene oxide

Sua Choi, Duck Kun Hwang and Heon Sang Lee 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 8 282-289 (8 pages)

Sua Choi, Duck Kun Hwang and Heon Sang Lee 저
...
- 3,000원
Blends of poly(vinyl alcohol) (PVA), polyethyleneimine (PEI), and graphene oxide (GO) were prepared by solution casting method. Calorimetric thermal properties of the blends were investigated. The Tgs of PVA/PEI blends were higher than the Tgs of either of the component polymers at low concentrations of PEI. These abnormal increases of Tgs may be due to the negative entropy of mixing which is associated with strong hydrogen bonding between PVA and PEI. The degree of depression of s was not...
215.

Effects of phosphorus content and operating temperature on the electrochemical performance of phosphorus-doped soft carbons

Eun Hee Kim and Yongju Jung 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 7 277-281 (5 pages)

Eun Hee Kim and Yongju Jung 저
...
- 1,500원
A series of high capacity soft carbons with different phosphorus contents were successfully prepared by carbonizing petroleum cokes treated with hypophosphorous acid at 900°C. The effect of phosphorus content on the electrochemical performance of the soft carbons was extensively investigated. The P-doped soft carbons exhibited greatly enhanced discharge capacities and outstanding rate capabilities with increasing phosphorus content. In addition, the influence of temperature on the...
216.

Properties of multi-walled carbon nanotube reinforced epoxy composites fabricated by using sonication and shear mixing

Min Ye Koo, Hon Chung Shin, Won-Seok Kim and Gyo Woo Lee 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 4 255-261 (7 pages)

Min Ye Koo, Hon Chung Shin, Won-Seok Kim and Gyo Woo Lee 저
...
- 3,000원
Multi-walled carbon nanotube reinforced epoxy composites were fabricated using shear mixing and sonication. The mechanical, viscoelastic, thermal, and electrical properties of the fabricated specimens were measured and evaluated. From the images and the results of the measurements of tensile strengths, the specimens having 0.6 wt% nanotube content showed better dispersion and higher strength than those of the other specimens. The Young’s moduli of the specimens increased as the nanotube filler...
217.

Modification of isotropic coal-tar pitch by acid treatments for carbon fiber melt-spinning

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 3 247-254 (8 pages)

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 저
...
- 3,000원
In this work, thermal treatment accompanied with different acid treatments was applied to a commercial coal tar pitch (CTP) to obtain a spinnable precursor pitch for carbon fiber. In the case of thermal treatment only, a relatively high reaction temperature of between 380°C and 400°C was required to obtain a softening point (SP) range of 220°C-260°C and many meso-phase particles were created during the application of high reaction temperature. When nitric acid or sulfuric acid treatment was...
218.

Carbon-allotropes: synthesis methods, applications and future perspectives

P. S. Karthik, A. L. Himaja and Surya Prakash Singh 한국탄소학회 Carbon Letters 19 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 1 219-237 (19 pages)

P. S. Karthik, A. L. Himaja and Surya Prakash Singh 저
...
- 4,800원
The element carbon has been used as a source of energy for the past few hundred years, and now in this era of technology, carbon has played a significant and very prominent role in almost all fields of science and technology. So as an honour to this marvellous element, we humans should know about its various forms of existence. In this review article, we shed light on all possible carbon-allotropes; similarities in their synthesis techniques and the starting materials; their wide range of...
219.

Excellent field emission properties from carbon nanotube field emitters fabricated using a filtration-taping method

Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 10 214-217 (4 pages)

Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 저
...
- 1,500원
A filtration-taping method was demonstrated to fabricate carbon nanotube (CNT) emitters. This method shows many good features, including high mechanical adhesion, good electrical contact, low temperature, organic-free, low cost, large size, and suitability for various CNT materials and substrates. These good features promise an advanced field emission performance with a turn-on field of 0.88 V/mm at a current density of 0.1 mA/cm2, a threshold field of 1.98 V/mm at a current density of 1 mA/cm2,...
220.

Carbon nanospheres synthesized via solution combustion method: their application as an anode material and catalyst for hydrogen production

Vivek Dhand, M Venkateswer Rao, J. S. Prasad, Garima Mittal, Kyong Yop Rhee, Hyeon Ju Kim, Dong Ho Jung 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 7 198-202 (5 pages)

Vivek Dhand, M Venkateswer Rao, J. S. Prasad, Garima Mittal, Kyong Yop Rhee, Hyeon Ju Kim, Dong Ho Jung 저
...
- 1,500원
range of 10-50 nm were synthesized using the solution combustion method. High-resolution transmission electron microscopy (HRTEM) revealed a densely packed high surface area of SP2-hybridized carbon; however, there were no crystalline structural components, as can be seen from the scanning electron microscopy, HRTEM, X-ray diffraction, Raman spectroscopy, and thermal gravimetric analyses. Electrochemical and thermo catalytic decomposition study results show that the material can be used as a...

한주간 이슈검색어