학지사 뉴논문

총 2,683건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

2201.

Activating needle coke to develop anode catalyst for direct methanol fuel cell

Young Hun Park, Ui-Su Im, Byung-Rok Lee, Dong-Hyun Peck, Sang-Kyung Kim, Young Woo Rhee, Doo-Hwan Jung 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 7 47-52 (6 pages)

Young Hun Park, Ui-Su Im, Byung-Rok Lee, Dong-Hyun Peck, Sang-Kyung Kim, Young Woo Rhee, Doo-Hwan Jung 저
...
- 3,000원
Physical and electrochemical qualities were analyzed after KOH activation of a direct methanol fuel cell using needle coke as anode supporter. The results of research on support loaded with platinum-ruthenium suggest that an activated KOH needle coke container has the lowest onset potential and the highest degree of catalyst activity among all commercial catalysts. Through an analysis of the CO stripping voltammetry, we found that KOH activated catalysis showed a 21% higher electrochemical...
2202.

Effects of maleic anhydride content on mechanical properties of carbon fibers-reinforced maleic anhydride-grafted-polypropylene matrix composites

Hyun-Il Kim, Woong Han, Woong-Ki Choi, Soo-Jin Park, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 6 39-46 (8 pages)

Hyun-Il Kim, Woong Han, Woong-Ki Choi, Soo-Jin Park, Kay-Hyeok An, Byung-Joo Kim 저
...
- 3,000원
In this work, the effects of maleic anhydride (MA) content on mechanical properties of chopped carbon fibers (CFs)-reinforced MA-grafted-polypropylene (MAPP) matrix composites. A direct oxyfluorination on CF surfaces was applied to increase the interfacial strength between the CFs and MAPP matrix. The mechanical properties of the CFs/MAPP composites are likely to be different in terms of MA content. Surface characteristics were observed by scanning electron microscope, Fourier transform infrared...
2203.

Nanoporous carbon synthesized from grass for removal and recovery of hexavalent chromium

Shahin A. Pathan, Nancy S. Pandita 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 2 10-18 (9 pages)

Shahin A. Pathan, Nancy S. Pandita 저
...
- 3,000원
initial concentration, pH, contact time, temperature, and interfering ions. The experimental equilibrium data fits well to Langmuir isotherm model with maximum monolayer adsorption capacity of 35.335 mg/g. The results indicated that removal obeys a pseudo-second-order kinetic model, and that equilibrium was reached in 10 min. A desorption study was done using NaOH. The results of the present study imply that acid functionalized nanoporous carbon synthesized from grass is an efficient, renewable,...
2204.

Adsorption capability of activated carbon synthesized from coconut shell

Md Shariful Islam, Bee Chin Ang, Samira Gharehkhani, Amalina Binti, Muhammad Afifi 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 1 1-9 (9 pages)

Md Shariful Islam, Bee Chin Ang, Samira Gharehkhani, Amalina Binti, Muhammad Afifi 저
...
- 3,000원
Activated carbon was synthesized from coconut shells. The Brunauer, Emmett and Teller surface area of the synthesized activated carbon was found to be 1640 m2/g with a pore volume of 1.032 cm3/g. The average pore diameter of the activated carbon was found to be 2.52 nm. By applying the size-strain plot method to the X-ray diffraction data, the crystallite size and the crystal strain was determined to be 42.46 nm and 0.000489897, respectively, which indicate a perfect crystallite structure. The...
2205.

Thermoelectric properties of carbonaceous solids

Francesco Miccio 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 14 107-111 (5 pages)

Francesco Miccio 저
...
- 1,500원
2206.

The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 저
...
- 3,000원
Taguchi’s experimental design was employed in the melt spinning of molten mesophase pitch to produce carbon fibers. The textures of the obtained carbon fibers were radial with varied crack angles, as observed by scanning electron microscopy and polarized optical imaging. The diameter, crack angle, preferred orientation, and tensile modulus of the produced samples were examined to investigate the influence of four spinning variables. The relative importance of the variables has been emphasized...
2207.

Adsorptive removal of atmospheric pollutants over Pyropia tenera chars

Heejin Lee, Rae-su Park, Hyung Won Lee, Yeojin Hong, Yejin Lee, Sung Hoon Park, Sang-Chul Jung, Kyung-Seun Yoo, Jong-Ki Jeon, Young-Kwon 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 10 79-88 (10 pages)

Heejin Lee, Rae-su Park, Hyung Won Lee, Yeojin Hong, Yejin Lee, Sung Hoon Park, Sang-Chul Jung, Kyung-Seun Yoo, Jong-Ki Jeon, Young-Kwon 저
...
- 3,000원
As a replacement for activated carbon, biochar was synthesized and used for the adsorptive removal of formaldehyde and nitrogen oxide. Biochar was produced from the fast pyrolysis of the red marine macro alga, Pyropia tenera. The P. tenera char was then activated with steam, ammonia and KOH to alter its characteristics. The adsorption of formaldehyde, which is one of the main indoor air pollutants, onto the seaweed char was performed using 1-ppm formaldehyde and the char was activated using a...
2208.

Study on urea precursor effect on the electroactivities of nitrogen-doped graphene nanosheets electrodes for lithium cells

Ki-Yong Kim, Yongju Jung, Seok Kim 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 5 40-46 (7 pages)

Ki-Yong Kim, Yongju Jung, Seok Kim 저
...
- 3,000원
Nitrogen-atom doped graphene oxide was considered to prevent the dissolution of polysulfide and to guarantee the enhanced redox reaction of sulfur for good cycle performance of lithium sulfur cells. In this study, we used urea as a nitrogen source due to its low cost and easy preparation. To find the optimum urea content, we tested three different ratios of urea to graphene oxide. The morphology of the composites was examined by field emission scanning electron microscope. Functional groups and...
2209.

Effects of electrochemical oxidation of carbon fibers on interfacial shear strength using a micro-bond method

Dong-Kyu Kim, Kay-Hyeok An, Yun Hyuk Bang, Lee-Ku Kwac, Sang-Yub Oh, Byung-Joo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 4 32-39 (8 pages)

Dong-Kyu Kim, Kay-Hyeok An, Yun Hyuk Bang, Lee-Ku Kwac, Sang-Yub Oh, Byung-Joo Kim 저
...
- 3,000원
In this work, we studied the effects of electrochemical oxidation treatments of carbon fibers (CFs) on interfacial adhesion between CF and epoxy resin with various current densities. The surface morphologies and properties of the CFs before and after electrochemical-oxidation-treatment were characterized using field emission scanning electron microscopy, atomic force microscopy, Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, and single-fiber contact angle. The...
2210.

Carbon rich fly ash and their nanostructures

Numan Salah, Sami S. Habib, Zishan H. Khan, Ahmed Alshahrie, Adnan Memic, Attieh A. Al-ghamdi 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 3 23-31 (9 pages)

Numan Salah, Sami S. Habib, Zishan H. Khan, Ahmed Alshahrie, Adnan Memic, Attieh A. Al-ghamdi 저
...
- 3,000원
Carbon rich fly ash was recently reported to have compositions that are ideal for use as a precursor and catalyst for carbon nanotube growth. This fly ash powder is mostly composed of pure carbon, predominantly present as sp2. In this work, the effect of sonication time on the morphology and structural properties of carbon rich fly ash particles is reported. The obtained results show that ultrasound treatment is an effective tool for producing ultrafine particles/fragments with higher porosity,...

한주간 이슈검색어