학지사 뉴논문

총 3,214건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

2261.

Biocomposite membranes based on poly(3-hydroxybutyrate-co-3-hydroxyvalerate) and multiwall carbon nanotubes for gas separation

Mongyoung Huh, Hye Min Lee, Young Soo Park, Seok Il Yun 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 17 116-121 (6 pages)

Mongyoung Huh, Hye Min Lee, Young Soo Park, Seok Il Yun 저
...
- 3,000원
The development of gas separation membranes is currently an active research area because of the rapidly increasing interest in carbon dioxide capture and hydrogen recovery, which are two of the most important solutions for problems related to energy and the environment [1-4]. Polymer membranes show selectivity in the separation of gases due to differences in the permeability of individual gases through the polymer film [3,4]. Even though advantageous in terms of low cost, the segmental...
2262.

Tribological properties of carbon fiber-reinforced aluminum composites processed by spark plasma sintering

Ki Hoon Jung, Seungjin Nam, Sung-Soo Kang, Bon-Cheol Ku, Yun Hyuk Bang, Jun Yeon Hwang 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 14 103-106 (4 pages)

Ki Hoon Jung, Seungjin Nam, Sung-Soo Kang, Bon-Cheol Ku, Yun Hyuk Bang, Jun Yeon Hwang 저
...
- 1,500원
The development of light-weight and high-strength materials have gained attention to meet the evergrowing demands for safer and fuel-efficient automobiles. Thus, the importance and applications of composite materials are gradually increasing [1]. In the field of metal-matrix composite manufacturing, reinforcing agents are added to the metal matrix in the form of powders, whiskers, and fibers to improve the mechanical properties of metals [2]. Fibers have been used since the 1950s as structural...
2263.

A facile green reduction of graphene oxide using Annona squamosa leaf extract

Basavaiah Chandu, Venkata Sai Sriram Mosali, Bhanu Mullamuri, Hari Babu Bollikolla 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 9 74-80 (7 pages)

Basavaiah Chandu, Venkata Sai Sriram Mosali, Bhanu Mullamuri, Hari Babu Bollikolla 저
...
- 3,000원
A highly facile and eco-friendly green synthesis of Annona squamosa (custard apple) leaf extract reduced graphene oxide (CRG) nanosheets was achieved by the reduction of graphene oxide (GO). The as-prepared CRG was characterized with X-ray diffraction (XRD), transmission electron microscope (TEM), Fourier-transform infrared spectroscopy (FT-IR), ultraviolet-visible (UV-Vis), X-ray photoelectron spectroscopy (XPS) and Raman spectroscopic techniques. Removal of oxygen containing moieties from the...
2264.

Study of complex electrodeposited thin film with multi-layer graphene-coated metal nanoparticles

Young-Lae Cho, Jung-woo Lee, Chan Park, Young-il Song, Su-Jeong Suh 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 8 68-73 (6 pages)

Young-Lae Cho, Jung-woo Lee, Chan Park, Young-il Song, Su-Jeong Suh 저
...
- 3,000원
We have demonstrated the production of thin films containing multilayer graphene-coated copper nanoparticles (MGCNs) by a commercial electrodeposition method. The MGCNs were produced by electrical wire explosion, an easily applied technique for creating hybrid metal nanoparticles. The nanoparticles had average diameters of 10?120 nm and quasispherical morphologies. We made a complex-electrodeposited copper thin film (CETF) with a thickness of 4.8 μm by adding 300 ppm MGCNs to the electrolyte...
2265.

Effect of carbonization temperature on crystalline structure and properties of isotropic pitch-based carbon fiber

Jung Dam Kim, Jae-Seung Roh, Myung-Soo Kim 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 6 51-60 (10 pages)

Jung Dam Kim, Jae-Seung Roh, Myung-Soo Kim 저
...
- 3,000원
Isotropic pitch-based fibers produced from coal tar pitch with the melt-blowing method were carbonized at temperatures ranging from 800 to 1600oC to investigate their crystalline structure and physical properties as a function of the carbonization temperature. The in-plane crystallite size (La) of the carbonized pitch fiber from X-ray diffraction increased monotonously by increasing the carbonization temperature resulting in a gradual increase in the electrical conductivity from 169 to 3800...
2266.

Synthesize multi-walled carbon nanotubes via catalytic chemical vapour deposition method on Fe-Ni bimetallic catalyst supported on kaolin

Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 한국탄소학회 Carbon Letters 18 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 5 33-50 (18 pages)

Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 저
...
- 4,700원
In this study, Fe-Ni bimetallic catalyst supported on kaolin is prepared by a wet impregnation method. The effects of mass of kaolin support, pre-calcination time, pre-calcination temperature and stirring speed on catalyst yields are examined. Then, the optimal supported Fe-Ni catalyst is utilised to produce multi-walled carbon nanotubes (MWCNTs) using catalytic chemical vapour deposition (CCVD) method. The catalysts and MWCNTs prepared using the optimal conditions are characterized using high...
2267.

Effects of coal tar pitch addition on the wear behavior of carbon/carbon composites

Young Chan Jung, Duk Soo Kang, Kyong Yop Rhee, Soo Jin Park, David Hui 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 9 62-65 (4 pages)

Young Chan Jung, Duk Soo Kang, Kyong Yop Rhee, Soo Jin Park, David Hui 저
...
- 1,500원
Carbon/carbon (C/C) composites are acknowledged as high performance materials because of their good mechanical properties such as wear resistance, even at the higher temperature, due to their low thermal expansion [1-5]. Their hardness and light weight in addition to their superior mechanical properties at high temperature make C/C composites the best material to make brakes for aircrafts and other high weight vehicles. Accordingly, a number of studies have been conducted on the performance of...
2268.

Morphologies and surface properties of cellulose-based activated carbon nanoplates

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 5 32-38 (7 pages)

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 저
...
- 3,000원
In this study, cellulose nanoplates (CNPs) were fabricated using cellulose nanocrystals obtained from commercial microcrystalline cellulose (MCC). Their pyrolysis behavior and the characteristics of the product carbonaceous materials were investigated. CNPs showed a relatively high char yield when compared with MCC due to sulfate functional groups introduced during the manufacturing process. In addition, pyrolyzed CNPs (CCNPs) showed more effective chemical activation behavior compared with...
2269.

Nanoporous carbon synthesized from grass for removal and recovery of hexavalent chromium

Shahin A. Pathan, Nancy S. Pandita 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 2 10-18 (9 pages)

Shahin A. Pathan, Nancy S. Pandita 저
...
- 3,000원
Nanoporous carbon structures were synthesized by pyrolysis of grass as carbon precursor. The synthesized carbon has high surface area and pore volume. The carbon products were acid functionalized and characterized by Fourier transform infrared spectroscopy, X-ray diffraction, Brunauer?Emmett?Teller, transmission electron microscopy, and Energy Dispersive X-ray microanalysis. Acid functionalized nanoporous carbon was explored for use in removal of toxic Cr(VI) ions from aqueous media. An...
2270.

Adsorption capability of activated carbon synthesized from coconut shell

Md Shariful Islam, Bee Chin Ang, Samira Gharehkhani, Amalina Binti, Muhammad Afifi 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 1 1-9 (9 pages)

Md Shariful Islam, Bee Chin Ang, Samira Gharehkhani, Amalina Binti, Muhammad Afifi 저
...
- 3,000원
Activated carbon was synthesized from coconut shells. The Brunauer, Emmett and Teller surface area of the synthesized activated carbon was found to be 1640 m2/g with a pore volume of 1.032 cm3/g. The average pore diameter of the activated carbon was found to be 2.52 nm. By applying the size-strain plot method to the X-ray diffraction data, the crystallite size and the crystal strain was determined to be 42.46 nm and 0.000489897, respectively, which indicate a perfect crystallite structure. The...

한주간 이슈검색어