학지사 뉴논문

총 399건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

241.

Effects of cross-linking methods for polyethylene-based carbon fibers: review

Kwan-Woo Kim, Hye-Min Lee, Jeong-Hun An, Byoung-Suhk Kim, Byung-Gak Min, Shin-Jae Kang, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 24 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 2 147-170 (24 pages)

Kwan-Woo Kim, Hye-Min Lee, Jeong-Hun An, Byoung-Suhk Kim, Byung-Gak Min, Shin-Jae Kang, Kay-Hyeok An, Byung-Joo Kim 저
...
- 5,300원
In recent decades, there has been an increasing interest in the use of carbon fiber reinforced plastic (CFRP) in aerospace, renewable energy and other industries, due to its low weight and relatively good mechanical properties compared with traditional metals. However, due to the high cost of petroleum-based precursors and their associated processing costs, CF remains a specialty product and as such has been limited to use in high-end aerospace, sporting goods, automotive, and specialist...
242.

Stabilization of pitch-based carbon fibers accompanying electron beam irradiation and their mechanical properties

Mi-Seon Park, Yoonyoung Ko, Min-Jung Jung, Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 8 121-126 (6 pages)

Mi-Seon Park, Yoonyoung Ko, Min-Jung Jung, Young-Seak Lee 저
...
- 3,000원
Carbon fibers are prepared by stabilizing pitch fibers accompanying electron beam (E-beam) irradiation. The carbon fibers pretreated by E-beam irradiation achieve a higher stabilization index than the carbon fibers that are only heat-stabilized. In addition, the carbon fibers subjected to E-beam irradiation in the stabilization step exhibit a comparable tensile strength to that of general purpose carbon fibers. The carbon fibers pretreated with an absorbed dose of 3000 kGy have a tensile...
243.

The effects of stacking sequence on the penetration-resistant behaviors of T800 carbon fiber composite plates under low-velocity impact loading

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 6 107-115 (9 pages)

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 저
...
- 3,000원
Impact damages induced by a low-velocity impact load on carbon fiber reinforced polymer (CFRP) composite plates fabricated with various stacking sequences were studied experimentally. The impact responses of the CFRP composite plates were significantly affected by the laminate stacking sequences. Three types of specimens, specifically quasi-isotropic, unidirectional, and cross-ply, were tested by a constant impact carrying the same impact energy level. An impact load of 3.44 kg, corresponding to...
244.

Influence of Nitrogen moieties on CO2 capture of Carbon Aerogel

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 9 57-61 (5 pages)

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 저
...
- 1,500원
a porous carbon material possessing high porosity and high specific surface area. Nitrogen doping reduced the specific surface area and micropores, but it furnished basic sites to improve the CO2 selectivity. In this work, N-doped carbon aerogels were prepared with different ratios of resorcinol/melamine by using the sol-gel method. The morphological properties were characterized by scanning electron microscopy (SEM). Nitrogen content was studied by X-ray photoelectron spectroscopy (XPS) and the...
245.

Modification of isotropic coal-tar pitch by acid treatments for carbon fiber melt-spinning

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 3 247-254 (8 pages)

Mi Jung Yoo, Hyo Jun Ko, Yun-Soo Lim and Myung-Soo Kim 저
...
- 3,000원
In this work, thermal treatment accompanied with different acid treatments was applied to a commercial coal tar pitch (CTP) to obtain a spinnable precursor pitch for carbon fiber. In the case of thermal treatment only, a relatively high reaction temperature of between 380°C and 400°C was required to obtain a softening point (SP) range of 220°C-260°C and many meso-phase particles were created during the application of high reaction temperature. When nitric acid or sulfuric acid treatment was...
246.

Enhanced electrocapacitive performance and high power density of polypyrrole/graphene oxide nanocomposites prepared at reduced temperature

Harish Mudila, Varsha Joshi, Sweta Rana, Mohmd. Ghulam Haider Zaidi, Sarfaraz Alam 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 3 171-179 (9 pages)

Harish Mudila, Varsha Joshi, Sweta Rana, Mohmd. Ghulam Haider Zaidi, Sarfaraz Alam 저
...
- 3,000원
An attempt was made to investigate the effect of the preparation temperature on the electrocapacitive performance of polypyrrole (PPY)/graphene oxide (GO) nanocomposites (PNCs). For this purpose, a series of PNCs were prepared at various temperatures by the cetyltrimethylammonium bromide-assisted dilute-solution polymerization of pyrrole in presence of GO (wt%) ranging from 1.0 to 4.0 with ferric chloride as an oxidant. The formation of the PNCs was ascertained through Fourier-transform infrared...
247.

Preparation of pitch from pyrolized fuel oil by electron beam radiation and its melt-electrospinning property

Jin-Young Jung, oung-Seak Lee 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 10 129-135 (7 pages)

Jin-Young Jung, oung-Seak Lee 저
...
- 3,000원
Spinnable pitch for melt-electrospinning was obtained from pyrolized fuel oil by electron beam (E-beam) radiation treatment. The modified pitch was characterized by measuring its elemental composition, softening point, viscosity, molecular weight, and spinnability. The softening point and viscosity properties of the modified pitch were influenced by reforming types (heat or E-beam radiation treatment) and the use of a catalyst. The softening point and molecular weight were increased in...
248.

Superhydrophobic carbon-based materials: a review of synthesis, structure, and applications

Long-Yue Meng, Soo-Jin Park 한국탄소학회 Carbon Letters 16 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 5 89-104 (16 pages)

Long-Yue Meng, Soo-Jin Park 저
...
- 4,500원
Materials with appropriate surface roughness and low surface energy can form superhydrophobic surfaces, displaying water contact angles greater than 150°. Superhydrophobic carbon-based materials are particularly interesting due to their exceptional physicochemical properties. This review discusses the various techniques used to produce superhydrophobic carbon-based materials such as carbon fibers, carbon nanotubes, graphene, amorphous carbons, etc. Recent advances in emerging fields such as...
249.

Effects of pore structures on electrochemical behaviors of polyacrylonitrile-based activated carbon nanofibers by carbon dioxide activation

Hye-Min Lee, Hong-Gun Kim, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 10 71-76 (6 pages)

Hye-Min Lee, Hong-Gun Kim, Kay-Hyeok An, Byung-Joo Kim 저
...
- 3,000원
Activated carbon nanofibers (ACNF) were prepared from polyacrylonitrile (PAN)-based nanofibers using CO2 activation methods with varying activation process times. The surface and structural characteristics of the ACNF were observed by scanning electron microscopy and X-ray diffraction, respectively. N2 adsorption isotherm characteristics at 77 K were confirmed by Brunauer-Emmett-Teller and Dubinin-Radushkevich equations. As experimental results, many holes or cavernous structures were found on...
250.

Carbon nanotubes–properties and applications

Khalid Saeed Ibrahim 한국탄소학회 Carbon Letters 14 Pages

한국탄소학회 Carbon Letters 2013, Vol.14 No.3 1 131-144 (14 pages)

Khalid Saeed Ibrahim 저
- 4,300원

한주간 이슈검색어