학지사 뉴논문

총 437건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

321.

The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 저
...
- 3,000원
Taguchi’s experimental design was employed in the melt spinning of molten mesophase pitch to produce carbon fibers. The textures of the obtained carbon fibers were radial with varied crack angles, as observed by scanning electron microscopy and polarized optical imaging. The diameter, crack angle, preferred orientation, and tensile modulus of the produced samples were examined to investigate the influence of four spinning variables. The relative importance of the variables has been emphasized...
322.

Yield enhancement of matrix precursor in short carbon fiber reinforced randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 7 57-65 (9 pages)

Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 저
...
- 3,000원
Isroaniso matrix precursor synthesized from commercially available petroleum pitch was stabilized in air. The influence of oxygen mass gain during stabilization on the yield of matrix precursor was studied. Additionally, the influence of pressure on the yield of the stabilized matrix precursor in a real system was studied. The fourier transform infrared spectrometry (FTIR), thermogravimetric analysis (TGA), yield, yield rate, and yield impact were used to check the effect of stabilization and...
323.

Cellulose-based carbon fibers prepared using electron-beam stabilization

Min Il Kim, Mi-Seon Park, Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 9 56-61 (6 pages)

Min Il Kim, Mi-Seon Park, Young-Seak Lee 저
...
- 3,000원
Cellulose fibers were stabilized by treatment with an electron-beam (E-beam). The properties of the stabilized fibers were analyzed by scanning electron microscopy, Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, and thermogravimetric analysis. The E-beam-stabilized cellulose fibers were carbonized in N₂ gas at 800°C for 1 h, and their carbonization yields were measured. The structure of the cellulose fibers was determined to have changed to hemicellulose and...
324.

A review: role of interfacial adhesion between carbon blacks and elastomeric materials

Min-Joo Kang, Young-Jung Heo, Fan-Long Jin, Soo-Jin Park 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 1 1-10 (10 pages)

Min-Joo Kang, Young-Jung Heo, Fan-Long Jin, Soo-Jin Park 저
...
- 3,000원
Carbon blacks (CBs) have been widely used as reinforcing materials in advanced rubber composites. The mechanical properties of CB-reinforced rubber composites are mostly controlled by the extent of interfacial adhesion between the CBs and the rubber. Surface treatments are generally performed on CBs to introduce chemical functional groups on its surface. In this study, we review the effects of various surface treatment methods for CBs. In addition, the preparation and properties of CB-reinforced...
325.

Mesophase formation behavior in petroleum residues

Subhash Kumar, Manoj Srivastava 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 3 171-182 (12 pages)

Subhash Kumar, Manoj Srivastava 저
...
- 4,100원
Mesophase pitch is an important starting material for making a wide spectrum of industrial and advanced carbon products. It is produced by pyrolysis of petroleum residues. In this work, mesophase formation behavior in petroleum residues was studied to prepare environmentally- benign mesophase pitches, and the composition of petroleum residues and its influence on the mesophase formation was investigated. Two petroleum residues, i.e., clarified oil s (CLO-1, CLO-2) obtained from fluid catalytic...
326.

Effects of cross-linking methods for polyethylene-based carbon fibers: review

Kwan-Woo Kim, Hye-Min Lee, Jeong-Hun An, Byoung-Suhk Kim, Byung-Gak Min, Shin-Jae Kang, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 24 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 2 147-170 (24 pages)

Kwan-Woo Kim, Hye-Min Lee, Jeong-Hun An, Byoung-Suhk Kim, Byung-Gak Min, Shin-Jae Kang, Kay-Hyeok An, Byung-Joo Kim 저
...
- 5,300원
In recent decades, there has been an increasing interest in the use of carbon fiber reinforced plastic (CFRP) in aerospace, renewable energy and other industries, due to its low weight and relatively good mechanical properties compared with traditional metals. However, due to the high cost of petroleum-based precursors and their associated processing costs, CF remains a specialty product and as such has been limited to use in high-end aerospace, sporting goods, automotive, and specialist...
327.

Stabilization of pitch-based carbon fibers accompanying electron beam irradiation and their mechanical properties

Mi-Seon Park, Yoonyoung Ko, Min-Jung Jung, Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 8 121-126 (6 pages)

Mi-Seon Park, Yoonyoung Ko, Min-Jung Jung, Young-Seak Lee 저
...
- 3,000원
Carbon fibers are prepared by stabilizing pitch fibers accompanying electron beam (E-beam) irradiation. The carbon fibers pretreated by E-beam irradiation achieve a higher stabilization index than the carbon fibers that are only heat-stabilized. In addition, the carbon fibers subjected to E-beam irradiation in the stabilization step exhibit a comparable tensile strength to that of general purpose carbon fibers. The carbon fibers pretreated with an absorbed dose of 3000 kGy have a tensile...
328.

Preparation and characterization of carbon fiber-reinforced thermosetting composites: a review

Fan-Long Jin, Soo-Jin Park 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 1 67-77 (11 pages)

Fan-Long Jin, Soo-Jin Park 저
...
- 4,000원
Carbon fibers (CFs) have a unique combination of properties which allow them to be widely used as reinforcing materials in advanced polymer composites. The mechanical properties of CF-reinforced polymer composites are governed mainly by the quality of interfacial adhesion between the CFs and the polymer matrix. Surface treatments of CFs are generally carried out to introduce chemical functional groups on the fiber surfaces, which provide the ability to control the surface characteristics of CFs....
329.

Influence of hot-pressing pressure on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 4 25-33 (9 pages)

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 저
...
- 3,000원
The prime objective of this research was to study the influence of hot-pressing pressure and matrix-to-reinforcement ratio on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon-composite. Secondary objectives included determination of the physical and mechanical properties of the resulting composite. The ‘hybrid carbon-fiberreinforced mesophase-pitch-derived carbon-matrix’ composite was fabricated by hot pressing. During hot pressing, pressure was varied from 5...
330.

Effects of comonomer with carboxylic group on stabilization of high molecular weight polyacrylonitrile nanofibrous copolymers

Danyun Lei, Kesavan Devarayan1, Xiang-Dan Li, Woong-Ki Choi, Min-Kang Seo and Byoung-Suhk Kim 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 9 290-294 (5 pages)

Danyun Lei, Kesavan Devarayan1, Xiang-Dan Li, Woong-Ki Choi, Min-Kang Seo and Byoung-Suhk Kim 저
...
- 1,500원
New precursors, poly(acrylonitrile-co-crotonic acid) (poly(AN-CA)) and poly(acrylonitrile-co-itaconic acid-co-crotonic acid) (poly(AN-IA-CA)) copolymers, for the preparation of carbon fibers, were explored in this study. The effects of comonomers with acidic groups, such as crotonic acid (CA) and/or itaconic acid (IA), on the stabilization of nanofibrous polyacrylonitrile (PAN) copolymers were studied. The extent of stabilization, evaluated by Fourier transform infrared spectroscopy, revealed...

한주간 이슈검색어