학지사 뉴논문

총 687건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

471.

Effects of carbonization temperature on pore development in polyacrylonitrile-based activated carbon nanofibers

Hye-Min Lee, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 13 146-150 (5 pages)

Hye-Min Lee, Kay-Hyeok An, Byung-Joo Kim 저
...
- 1,500원
In this work, activated carbon nanofiber (ACNF) electrodes with high double-layer capacitance and good rate capability were prepared from polyacrylonitrile nanofibers by optimizing the carbonization temperature prior to H2O activation. The morphology of the ACNFs was observed by scanning electron microscopy. The elemental composition was determined by analysis of X-ray photoelectron spectroscopy. N2-adsorption-isotherm characteristics at 77 K were confirmed by Brunauer-Emmett-Teller and...
472.

Preparation of pitch from pyrolized fuel oil by electron beam radiation and its melt-electrospinning property

Jin-Young Jung, oung-Seak Lee 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 10 129-135 (7 pages)

Jin-Young Jung, oung-Seak Lee 저
...
- 3,000원
Spinnable pitch for melt-electrospinning was obtained from pyrolized fuel oil by electron beam (E-beam) radiation treatment. The modified pitch was characterized by measuring its elemental composition, softening point, viscosity, molecular weight, and spinnability. The softening point and viscosity properties of the modified pitch were influenced by reforming types (heat or E-beam radiation treatment) and the use of a catalyst. The softening point and molecular weight were increased in...
473.

Double-walled carbon nanotubes: synthesis, structural characterization, and application

Yoong Ahm Kim, Kap-Seung Yang, Hiroyuki Muramatsu, Takuya Hayashi, Morinobu Endo, Mauricio Terrones, Mildred S. Dresselhaus 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 4 77-88 (12 pages)

Yoong Ahm Kim, Kap-Seung Yang, Hiroyuki Muramatsu, Takuya Hayashi, Morinobu Endo, Mauricio Terrones, Mildred S. Dresselhaus 저
...
- 4,100원
Double walled carbon nanotubes (DWCNTs) are considered an ideal model for studying the coupling interactions between different concentric shells in multi-walled CNTs. Due to their intrinsic coaxial structures they are mechanically, thermally, and structurally more stable than single walled CNTs. Geometrically, owing to the buffer-like function of the outer tubes in DWCNTs, the inner tubes exhibit exciting transport and optical properties that lend them promise in the fabrication of field-effect...
474.

Effects of pore structures on electrochemical behaviors of polyacrylonitrile-based activated carbon nanofibers by carbon dioxide activation

Hye-Min Lee, Hong-Gun Kim, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 10 71-76 (6 pages)

Hye-Min Lee, Hong-Gun Kim, Kay-Hyeok An, Byung-Joo Kim 저
...
- 3,000원
Activated carbon nanofibers (ACNF) were prepared from polyacrylonitrile (PAN)-based nanofibers using CO2 activation methods with varying activation process times. The surface and structural characteristics of the ACNF were observed by scanning electron microscopy and X-ray diffraction, respectively. N2 adsorption isotherm characteristics at 77 K were confirmed by Brunauer-Emmett-Teller and Dubinin-Radushkevich equations. As experimental results, many holes or cavernous structures were found on...
475.

Preparation and characterization of microporous NaOH activated carbons from hydrofluoric acid leached rice husk and its application for lead(II) adsorption

A. F. Hassan, A. M. Youssef 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 8 57-66 (10 pages)

A. F. Hassan, A. M. Youssef 저
...
- 3,000원
Three activated carbons (ACs) were prepared using NaOH (N) as an activating agent. Hydrofluoric acid pre-leached rice husk was used as a precursor. After leaching, the precursor was washed with distilled water, dried, crushed, and then sieved; a size fraction of 0.3-0.5 mm was selected for carbonization in the absence of air at 600°C. The carbonization product (LC) was mixed with NaOH at ratios of 1:2, 1:3, and 1:4 (wt of LC: wt of NaOH) and the produced ACs after activation at 800°C were...
476.

Study on effect of chemical impregnation on the surface and porous characteristics of activated carbon fabric prepared from viscose rayon

Surendra Bhati, J.S. Mahur, Savita Dixit, O. N. Chobey 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 6 45-49 (5 pages)

Surendra Bhati, J.S. Mahur, Savita Dixit, O. N. Chobey 저
...
- 1,500원
pore volume, chemical composition and morphology of ACF were studied. Experimental results revealed that both Brunauer-Emmett- Teller surface area and micropore volume increased with increasing H3PO4 concentration; however, the weight yield and microporosity (%) decreased. It was observed that samples impregnated at 70°C (AC-70) give higher yield and higher microporosity as compared to 30°C (AC-30). The average pore size of the ACF also gradually increases from 18.2 to 19 and 16.7 to 20.4 ?...
477.

Mechanical and thermal properties of MWCNT-reinforced epoxy nanocomposites by vacuum assisted resin transfer molding

Si-Eun Lee, Seho Cho, Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 4 32-37 (6 pages)

Si-Eun Lee, Seho Cho, Young-Seak Lee 저
...
- 3,000원
Multi-walled carbon nanotube (MWCNT)/epoxy composites are prepared by a vacuum assisted resin transfer molding (VARTM) method. The mechanical properties, fracture surface morphologies, and thermal stabilities of these nanocomposites are evaluated for epoxy resins with various amounts of MWCNTs. Composites consisting of different amounts of MWCNTs displayed an increase of the work of adhesion between the MWCNTs and the matrix, which improved both the tensile and impact strengths of the...
478.

Morphological optimization of process parameters of randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, Sushant Krunal Manwatkar, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 3 25-31 (7 pages)

Thakur Sudesh Kumar Raunija, Sushant Krunal Manwatkar, Sharad Chandra Sharma, Anil Verma 저
...
- 3,000원
shows a lack of densification. The compacts with low matrix precursor to reinforcement weight ratios have insufficient bonding agent to bind the reinforcement whereas the higher matrix precursor to reinforcement weight ratio results in a plaster-like structure. Based on the microstructure analysis, a heating rate of 0.2°C/min, pressure of 15 MPa, and a matrix precursor to reinforcement ratio of 50:50 are found to be optimum w.r.t attaining bloating-free densification and processing time.
479.

Hierarchical porous carbon nanofibers via electrospinning

Aikifa Raza, Jiaqi Wang, Shan Yang, Yang Si, Bin Ding 한국탄소학회 Carbon Letters 14 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 1 1-14 (14 pages)

Aikifa Raza, Jiaqi Wang, Shan Yang, Yang Si, Bin Ding 저
...
- 4,300원
Carbon nanofibers (CNFs) with diameters in the submicron and nanometer range exhibit high specific surface area, hierarchically porous structure, flexibility, and super strength which allow them to be used in the electrode materials of energy storage devices, and as hybrid-type filler in carbon fiber reinforced plastics and bone tissue scaffold. Unlike catalytic synthesis and other methods, electrospinning of various polymeric precursors followed by stabilization and carbonization has become a...
480.

Removal of deltamethrin insecticide over highly porous

A. F. Hassan, A.M. Youssef, P. Priecel 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2013, Vol.14 No.4 6 234-242 (9 pages)

A. F. Hassan, A.M. Youssef, P. Priecel 저
...
- 3,000원

한주간 이슈검색어