학지사 뉴논문

총 975건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

641.

Electrochemical determination of chloramphenicol using a glassy carbon electrode modified with dendrite-like Fe₃O₄ nanoparticles

Krishnan Giribabu, Sung-Chan Jang, Yuvaraj Haldorai, Muruganantham Rethinasabapathy, Seo Yeong Oh, Arunkumar Rengaraj, Young-Kyu Han 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 6 38-47 (10 pages)

Krishnan Giribabu, Sung-Chan Jang, Yuvaraj Haldorai, Muruganantham Rethinasabapathy, Seo Yeong Oh, Arunkumar Rengaraj, Young-Kyu Han 저
...
- 3,000원
a mean size of < 80 nm were electrodeposited on a glassy carbon electrode (GCE). The Fe3O4/GCE was utilized for sensing chloramphenicol (CAP) by cyclic voltammetry and square wave voltammetry. A reduction peak of CAP at the Fe3O4/GCE was observed at 0.62 V, whereas the uncoated GCE exhibited a very small response compared to that of the Fe3O4/GCE. The electrocatalytic ability of Fe3O4 was mainly attributed to the formation of Fe(VI) during the anodic scan, and its reduction to Fe(III) on the...
642.

Mechanical and electrical properties of cement paste incorporated with pitch-based carbon fiber

Inkyu Rhee, Jin Hee Kim, Sang Hee Park, Sungho Lee, Bong Ryeul Ryu, Yoong Ahm Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 4 22-29 (8 pages)

Inkyu Rhee, Jin Hee Kim, Sang Hee Park, Sungho Lee, Bong Ryeul Ryu, Yoong Ahm Kim 저
...
- 3,000원
The compressive strength and electrical resistance of pitch-based carbon fiber (CF) in cementitious materials are explored to determine the feasibility of its use as a functional material in construction. The most widely used CFs are manufactured from polyacrylonitrile (PAN-based CF). Alternatively, short CFs are obtained in an economical way using pitch as a precursor in a melt-blown process (pitch-based CF), which is cheaper and more eco-friendly method because this pitch-based CF is basically...
643.

Li-ion battery anodes from ginkgo leaf-derived nanoporous carbons rich in redox-active heteroatoms

Na Rae Kim, Hong Joo An, Young Soo Yun, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 13 110-114 (5 pages)

Na Rae Kim, Hong Joo An, Young Soo Yun, Hyoung-Joon Jin 저
...
- 1,500원
Lithium-ion batteries (LIBs) have attracted increasing attention as a sustainable power source due to the rapid growth in mobile electronics and electric automobile markets, driven by increasing environmental awareness [1-4]. The electrochemical performance of LIBs is strongly dependent on the active electrode materials. Therefore, their continuing advanced development is of key importance to meet the expectations of the market [5-7]. Graphite, commonly used in LIB anodes, forms binary graphite...
644.

Synthesis and characterization of carbon doped TiO₂ photocatalysts supported on stainless steel mesh by sol-gel method

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 6 48-59 (12 pages)

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 저
...
- 4,100원
This study synthesized pure anatase carbon doped TiO₂ photocatalysts supported on a stainless steel mesh using a sol-gel solution of 8% polyacrylonitrile (PAN)/dimethylformamide (DMF)/TiCl₄. The influence of the pyrolysis temperature and holding time on the morphological characteristics, particle sizes and surface area of the prepared catalyst was investigated. The prepared catalysts were characterized by several analytical methods: high resolution scanning electron microscopy (HRSEM), energy...
645.

Biocomposite membranes based on poly(3-hydroxybutyrate-co-3-hydroxyvalerate) and multiwall carbon nanotubes for gas separation

Mongyoung Huh, Hye Min Lee, Young Soo Park, Seok Il Yun 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 17 116-121 (6 pages)

Mongyoung Huh, Hye Min Lee, Young Soo Park, Seok Il Yun 저
...
- 3,000원
The development of gas separation membranes is currently an active research area because of the rapidly increasing interest in carbon dioxide capture and hydrogen recovery, which are two of the most important solutions for problems related to energy and the environment [1-4]. Polymer membranes show selectivity in the separation of gases due to differences in the permeability of individual gases through the polymer film [3,4]. Even though advantageous in terms of low cost, the segmental...
646.

Formation of nanojoints between carbon nanotubes and copper nanoparticles

Jagjiwan Mittal, Kwang Lung Lin 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 11 86-92 (7 pages)

Jagjiwan Mittal, Kwang Lung Lin 저
...
- 3,000원
Exceptional properties and a one dimensional structure make carbon nanotubes (CNTs) a promising candidate for future applications in the electronic industry [1-3]. Because of their smaller dimensions and higher conductivity as compared to copper, multi-walled carbon nanotubes (MWCNT) may increase the bandwidth density of global interconnects [4]. They demonstrate charge carrier mean free paths between 500 nm and 10 μm as compared to 40 nm in metals. CNTs can carry exceptionally high current...
647.

Morphologies and surface properties of cellulose-based activated carbon nanoplates

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 5 32-38 (7 pages)

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 저
...
- 3,000원
In this study, cellulose nanoplates (CNPs) were fabricated using cellulose nanocrystals obtained from commercial microcrystalline cellulose (MCC). Their pyrolysis behavior and the characteristics of the product carbonaceous materials were investigated. CNPs showed a relatively high char yield when compared with MCC due to sulfate functional groups introduced during the manufacturing process. In addition, pyrolyzed CNPs (CCNPs) showed more effective chemical activation behavior compared with...
648.

Sorption behavior of slightly reduced, three-dimensionally macroporous graphene oxides for physical loading of oils and organic solvents

Ho Seok Park, Sung Oong Kang 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 4 24-29 (6 pages)

Ho Seok Park, Sung Oong Kang 저
...
- 3,000원
High pollutant-loading capacities (up to 319 times its own weight) are achieved by three-dimensional (3D) macroporous, slightly reduced graphene oxide (srGO) sorbents, which are prepared through ice-templating and consecutive thermal reduction. The reduction of the srGO is readily controlled by heating time under a mild condition (at 1 10?2 Torr and 200°C). The saturated sorption capacity of the hydrophilic srGO sorbent (thermally reduced for 1 h) could not be improved further even though the...
649.

Synthesis, characterization, and toxicity of multi-walled carbon nanotubes functionalized with 4-hydroxyquinazoline

Hasan Tahermansouri, Atieh Mirosanloo, Saeed Heidari Keshel, Mossa Gardaneh 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 7 45-52 (8 pages)

Hasan Tahermansouri, Atieh Mirosanloo, Saeed Heidari Keshel, Mossa Gardaneh 저
...
- 3,000원
The attachment of 2-aminobenzamide to carboxylated multi-wall carbon nanotubes (MWCNTs)- COOH was achieved through the formation of amide bonds. Then, the functionalized MWCNTs, MWCNT-amide, were treated by phosphoryl chloride to produce MWCNT-quin. The products were characterized by Fourier transform infrared spectroscopy, Raman spectroscopy, scanning electron microscopy, thermogravimetric analysis, derivative thermogravimetric, steady-state fluorescence spectroscopy, and solubility testing....
650.

Microwave-assisted pretreatment technologies for the conversion of lignocellulosic biomass to sugars and ethanol: a review

Pradeep Puligundla, Sang-Eun Oh, Chulkyoon Mok 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 1 1-10 (10 pages)

Pradeep Puligundla, Sang-Eun Oh, Chulkyoon Mok 저
...
- 3,000원
Lignocellulosic biomass conversion to biofuels such as ethanol and other value-added bio-products including activated carbons has attracted much attention. The development of an efficient, cost-effective, and eco-friendly pretreatment process is a major challenge in lignocellulosic biomass to biofuel conversion. Although several modern pretreatment technologies have been introduced, few promising technologies have been reported. Microwave irradiation or microwave-assisted methods (physical and...

한주간 이슈검색어