The Korea inshore fishing boats are the size up to 30G.T., and their construction commonly employs the traditional wide wooden planking. Nevertheless, the hull forms have been developed with chine-type straight-framed sections which give developable surface party, but not on the whole: especially not on the whole portion of the hull are preferable for them. Considering many merits in the boat construction, the author, excluding cases of the FRP construction by hand lay-up or spray-up method and of the ferro-cement construction, finds out no reasons to depart from the chine-type hull forms of a developable surface in future development of their hull forms, too. In this report, the author proposed new designs of the developable hull surface for four typical boats forming the main structure of Korean inshore fishing fleets; 5G.T.-class multi-purpose boat, 10G.T.-class angling and longlining boat, 20G.T.-class drift and gill netters, and 27G.T.-class stow netters, and presented the tank test results on their propulsion resistance. The tank test had two purposes; one is to present the powering schedule of the new designs and the other to investigate the resistance characteristics of this kinds of boat in comparision with those of equivalent round-type boats at operational speed ranges. Between the both types of the boat no material differences in powering are expected. Hence, the author is confident of that saving in the construction cost of the developable hull over that of the round-type boat may result in considerable contribution to the over-all boat economy.