발행기관
- 한국탄소학회(14)
- 물리치료재활과학회(6)
- 환태평양유아교육연구학회(5)
- 이화여자대학교 교과교육연구소(2)
- 한국세라믹학회(2)
- 한국헬스커뮤니케이션학회(2)
- 대한기계학회(1)
- 대한문학치료학회(1)
- 대한수의학회(1)
- 대한신경계작업치료학회(1)
- 대한신경정신의학회(1)
- 한국경호경비학회(1)
- 한국광고PR실학회(1)
- 한국교원교육학회(1)
- 한국교육방법학회(1)
- 한국보건기초의학회(1)
- 한국섬유공학회(1)
- 한국자기학회(1)
- 한국해양공학회(1)
간행물
- CARBON LETTERS(14)
- PHYSICAL THERAPY REHABILITATION SCIENCE(6)
- ASIA-PACIFIC JOURNAL OF RESEARCH IN EARLY CHILDHOOD EDUCATION(4)
- 교과교육학연구(2)
- 한국세라믹학회지(2)
- 헬스커뮤니케이션연구(2)
- FIBERS AND POLYMERS(1)
- JOURNAL OF MAGNETICS(1)
- JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY(1)
- JOURNAL OF VETERINARY SCIENCE(1)
- PACIFIC EARLY CHILDHOOD EDUCATION RESEARCH ASSOCIATION ANNUAL CONFERENCE(1)
- 광고PR실학연구(1)
- 교육방법연구(1)
- 대한문학치료연구(1)
- 시큐리티연구(1)
- 신경정신의학(1)
- 재활치료과학(1)
- 한국교원교육연구(1)
- 한국보건기초의학회지(1)
- 한국해양공학회지(1)
전체 선택해제
총 44건 검색
본문검색 결과만 보기
-
Thermo-electrical properties of randomly oriented carbon/carbon composite
Thakur Sudesh Kumar Raunija, N. Supriya 한국탄소학회 Carbon Letters 11 Pages
한국탄소학회 Carbon Letters 2017, Vol.22 3 25-35 (11 pages)
The aim of the work was to investigate the thermo-electrical properties of low cost and rapidly produced randomly oriented carbon/carbon (C/C) composite. The composite body was fabricated by combining the high-pressure hot-pressing (HP) method with the lowpressure impregnation thermosetting carbonization (ITC) method. After the ITC method step selected samples were graphitized at 3000°C. Detailed characterization of the samples’ physical properties and thermal properties, including thermal... -
Influence of hot-pressing pressure on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon composite
Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 한국탄소학회 Carbon Letters 9 Pages
한국탄소학회 Carbon Letters 2015, Vol.16 No.1 4 25-33 (9 pages)
The prime objective of this research was to study the influence of hot-pressing pressure and matrix-to-reinforcement ratio on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon-composite. Secondary objectives included determination of the physical and mechanical properties of the resulting composite. The ‘hybrid carbon-fiberreinforced mesophase-pitch-derived carbon-matrix’ composite was fabricated by hot pressing. During hot pressing, pressure was varied from 5... -
Thermal analysis of randomly oriented carbon nanotube reinforced functionally graded timoshenko beam
Thomas. Benedict, Inamdar. Prasad K., Roy. Tarapada 대한기계학회 Journal of mechanical science and technology 10 Pages
대한기계학회 Journal of mechanical science and technology 2014, Vol.28 No.5 1779-1788 (10 pages)
-
Yield enhancement of matrix precursor in short carbon fiber reinforced randomly oriented carbon/carbon composite
Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 9 Pages
한국탄소학회 Carbon Letters 2016, Vol.19 7 57-65 (9 pages)
Isroaniso matrix precursor synthesized from commercially available petroleum pitch was stabilized in air. The influence of oxygen mass gain during stabilization on the yield of matrix precursor was studied. Additionally, the influence of pressure on the yield of the stabilized matrix precursor in a real system was studied. The fourier transform infrared spectrometry (FTIR), thermogravimetric analysis (TGA), yield, yield rate, and yield impact were used to check the effect of stabilization and... -
Morphological optimization of process parameters of randomly oriented carbon/carbon composite
Thakur Sudesh Kumar Raunija, Sushant Krunal Manwatkar, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2014, Vol.15 No.1 3 25-31 (7 pages)
A microstructure analysis is carried out to optimize the process parameters of a randomly oriented discrete length hybrid carbon fiber reinforced carbon matrix composite. The composite is fabricated by moulding of a slurry into a preform, followed by hot-pressing and carbonization. Heating rates of 0.1, 0.2, 0.3, 0.5, 1, and 3.3°C/min and pressures of 5, 10, 15, and 20 MPa are applied during hot-pressing. Matrix precursor to reinforcement weight ratios of 70:30, 50:50, and 30:70 are also... -
Effects of task-oriented training for Gross Motor Function Measure, balance and gait function in persons with cerebral palsy
Hyun-Kyung Han, Yi-jung Chung 물리치료재활과학회 Physical Therapy Rehabilitation Science 6 Pages
물리치료재활과학회 Physical Therapy Rehabilitation Science 2016, 제 5권 제 1호 2 9-14 (6 pages)
Objective: This study was to investigate the effects of Task-oriented training for Gross Motor Function Measure (GMFM), gait and balance function in cerebral palsy. Design: Randomized controlled trials. Methods: Twenty four subjects were recruited by means of a convenience sampling from Kangseo-Gu G rehabilitation center. Subjects were 24 inpatients and were randomly divided into a task-oriented training group and a conventional group. Twelve patients were experimental group who executed the... -
Excellent field emission properties from carbon nanotube field emitters fabricated using a filtration-taping method
Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 한국탄소학회 Carbon Letters 4 Pages
한국탄소학회 Carbon Letters 2014, Vol.15 No.3 10 214-217 (4 pages)
A filtration-taping method was demonstrated to fabricate carbon nanotube (CNT) emitters. This method shows many good features, including high mechanical adhesion, good electrical contact, low temperature, organic-free, low cost, large size, and suitability for various CNT materials and substrates. These good features promise an advanced field emission performance with a turn-on field of 0.88 V/mm at a current density of 0.1 mA/cm2, a threshold field of 1.98 V/mm at a current density of 1 mA/cm2,...
