학지사 뉴논문

총 212건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

91.

Tribological properties of carbon fiber-reinforced aluminum composites processed by spark plasma sintering

Ki Hoon Jung, Seungjin Nam, Sung-Soo Kang, Bon-Cheol Ku, Yun Hyuk Bang, Jun Yeon Hwang 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 14 103-106 (4 pages)

Ki Hoon Jung, Seungjin Nam, Sung-Soo Kang, Bon-Cheol Ku, Yun Hyuk Bang, Jun Yeon Hwang 저
...
- 1,500원
The development of light-weight and high-strength materials have gained attention to meet the evergrowing demands for safer and fuel-efficient automobiles. Thus, the importance and applications of composite materials are gradually increasing [1]. In the field of metal-matrix composite manufacturing, reinforcing agents are added to the metal matrix in the form of powders, whiskers, and fibers to improve the mechanical properties of metals [2]. Fibers have been used since the 1950s as structural...
92.

Synthesize multi-walled carbon nanotubes via catalytic chemical vapour deposition method on Fe-Ni bimetallic catalyst supported on kaolin

Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 한국탄소학회 Carbon Letters 18 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 5 33-50 (18 pages)

Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 저
...
- 4,700원
In this study, Fe-Ni bimetallic catalyst supported on kaolin is prepared by a wet impregnation method. The effects of mass of kaolin support, pre-calcination time, pre-calcination temperature and stirring speed on catalyst yields are examined. Then, the optimal supported Fe-Ni catalyst is utilised to produce multi-walled carbon nanotubes (MWCNTs) using catalytic chemical vapour deposition (CCVD) method. The catalysts and MWCNTs prepared using the optimal conditions are characterized using high...
93.

In-situ magnetization measurements and ex-situ morphological analysis of electrodeposited cobalt onto chemical vapor deposition graphene/SiO₂/Si

Vin?cius C. De Franco, Gustavo M. B. Castro, Jeaneth Corredor, Daniel Mendes, Jo?o E. Schmidt 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 3 16-22 (7 pages)

Vin?cius C. De Franco, Gustavo M. B. Castro, Jeaneth Corredor, Daniel Mendes, Jo?o E. Schmidt 저
...
- 3,000원
Cobalt was electrodeposited onto chemical vapor deposition (CVD) graphene/Si/SiO2 substrates, during different time intervals, using an electrolyte solution containing a low concentration of cobalt sulfate. The intention was to investigate the details of the deposition process (and the dissolution process) and the resulting magnetic properties of the Co deposits on graphene. During and after electrodeposition, in-situ magnetic measurements were performed using an (AGFM). These were followed by...
94.

Morphologies and surface properties of cellulose-based activated carbon nanoplates

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 5 32-38 (7 pages)

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 저
...
- 3,000원
In this study, cellulose nanoplates (CNPs) were fabricated using cellulose nanocrystals obtained from commercial microcrystalline cellulose (MCC). Their pyrolysis behavior and the characteristics of the product carbonaceous materials were investigated. CNPs showed a relatively high char yield when compared with MCC due to sulfate functional groups introduced during the manufacturing process. In addition, pyrolyzed CNPs (CCNPs) showed more effective chemical activation behavior compared with...
95.

Waste coffee grounds-derived nanoporous carbon nanosheets for supercapacitors

Min Hong Park, Young Soo Yun, Se Youn Cho, Na Rae Kim, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 8 66-71 (6 pages)

Min Hong Park, Young Soo Yun, Se Youn Cho, Na Rae Kim, Hyoung-Joon Jin 저
...
- 3,000원
The development of nanostructured functional materials derived from biomass and/or waste is of growing importance for creating sustainable energy-storage systems. In this study, nanoporous carbonaceous materials containing numerous heteroatoms were fabricated from waste coffee grounds using a top-down process via simple heating with KOH. The nanoporous carbon nanosheets exhibited notable material properties such as high specific surface area (1960.1 m2 g?1), numerous redox-active heteroatoms...
96.

Effect of fiber-matrix adhesion on the fracture behavior of a carbon fiber reinforced thermoplastic-modified epoxy matrix

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 6 47-56 (10 pages)

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 저
...
- 3,000원
In this study, the fracture behavior of a thermoplastic-modified epoxy resin reinforced with continuous carbon fibers for two levels of fiber-matrix adhesion was performed. A carbon fiber with commercial sizing was used and also treated with a known silane, (3-glycidoxy propyl trimethoxysilane) coupling agent. Toughness was determined using the double cantilever test, together with surface analysis after failure using scanning electron microscope. The presence of polysulfone particles improved...
97.

Cu²? ion reduction in wastewater over RDF-derived char

Hyung Won Lee, Rae-su Park, Sung Hoon Park, Sang-Chul Jung, Jong-Ki Jeon, Sang Chai Kim, Jin Do Chung, Won Geun Choi, Young-Kwon Park 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 8 49-55 (7 pages)

Hyung Won Lee, Rae-su Park, Sung Hoon Park, Sang-Chul Jung, Jong-Ki Jeon, Sang Chai Kim, Jin Do Chung, Won Geun Choi, Young-Kwon Park 저
...
- 3,000원
Refuse-derived fuel (RDF) produced using municipal solid waste was pyrolyzed to produce RDF char. For the first time, the RDF char was used to remove aqueous copper, a representative heavy metal water pollutant. Activation of the RDF char using steam and KOH treatments was performed to change the specific surface area, pore volume, and the metal cation quantity of the char. N2 sorption, Inductively Coupled Plasma-Atomic Emission Spectrometer (ICP-AES), and Fourier transform infrared spectroscopy...
98.

Synthesis, characterization, and toxicity of multi-walled carbon nanotubes functionalized with 4-hydroxyquinazoline

Hasan Tahermansouri, Atieh Mirosanloo, Saeed Heidari Keshel, Mossa Gardaneh 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 7 45-52 (8 pages)

Hasan Tahermansouri, Atieh Mirosanloo, Saeed Heidari Keshel, Mossa Gardaneh 저
...
- 3,000원
The attachment of 2-aminobenzamide to carboxylated multi-wall carbon nanotubes (MWCNTs)- COOH was achieved through the formation of amide bonds. Then, the functionalized MWCNTs, MWCNT-amide, were treated by phosphoryl chloride to produce MWCNT-quin. The products were characterized by Fourier transform infrared spectroscopy, Raman spectroscopy, scanning electron microscopy, thermogravimetric analysis, derivative thermogravimetric, steady-state fluorescence spectroscopy, and solubility testing....
99.

Experimental study on synthesis of Co/CeO₂-doped carbon nanofibers and its performance in supercapacitors

Jongwan Kim, Zafar Khan Ghouri, Rabia Zafar Khan, Taehee An, Mira Park, Hak-Yong Kim 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.4 8 270-274 (5 pages)

Jongwan Kim, Zafar Khan Ghouri, Rabia Zafar Khan, Taehee An, Mira Park, Hak-Yong Kim 저
...
- 1,500원
100.

Manufacturing and characteristics of PAN-based composite carbon fibers containing cellulose particles

Jee-Woo Yang, Da Young Jin, Ji Eun Lee, Seung Goo Lee, Won Ho Park 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 7 203-210 (8 pages)

Jee-Woo Yang, Da Young Jin, Ji Eun Lee, Seung Goo Lee, Won Ho Park 저
...
- 3,000원
This study fabricated low thermal conductive polyacrylonitrile (PAN)-based carbon fibers containing cellulose particles while maintaining their mechanical properties. The high thermal conductivity of carbon fibers limits their application as a high temperature insulator in various systems such as an insulator for propulsion parts in aerospace or missile systems. By controlling process parameters such as the heat treatment temperature of the cellulose particles and the amount of cellulose added,...

한주간 이슈검색어