자료유형
발행기관
- 한국탄소학회(49)
- 대한수의학회(40)
- 한국식물병리학회(23)
- 대한생리학회-대한약리학회(14)
- 대한약리학회(5)
- 대한신경정신의학회(4)
- 대한치과이식임플란트학회(4)
- 인문사회과학기술융합학회(4)
- 대한치과교정학회(3)
- 대한신경계작업치료학회(2)
- 한국청각언어재활학회(2)
- 대한구순구개열학회(1)
- 물리치료재활과학회(1)
- 서강대학교 철학연구소(1)
- 한국경호경비학회(1)
- 한국기업교육학회(1)
- 한국기초간호학회(1)
- 한국어업기술학회(1)
- 한국여가문화학회(1)
- 한국정밀공학회(1)
- 한방비만학회(1)
간행물
- CARBON LETTERS(49)
- JOURNAL OF VETERINARY SCIENCE(25)
- THE PLANT PATHOLOGY JOURNAL (19)
- THE KOREAN JOURNAL OF PHYSIOLOGY & PHARMACOLOGY(14)
- 대한수의학회 학술대회발표집(10)
- KOREAN JOURNAL OF VETERINARY RESEARCH(구 대한수의학회지)(5)
- 대한약리학잡지(5)
- JOURNAL OF DENTAL IMPLANT RESEARCH(4)
- 식물병연구(4)
- 신경정신의학(4)
- 예술인문사회융합멀티미디어논문지(4)
- THE KOREAN JOURNAL OF ORTHODONTICS(3)
- AUDIOLOGY AND SPEECH RESEARCH(2)
- 재활치료과학(2)
- JOURNAL OF KOREAN BIOLOGICAL NURSING SCIENCE(1)
- PHYSICAL THERAPY REHABILITATION SCIENCE(1)
- 기업교육과 인재연구(1)
- 대한구순구개열학회지(1)
- 대한한방비만학회지(1)
- 시큐리티연구(1)
- 여가학연구(1)
- 철학논집(1)
- 한국어업기술학회지(1)
- 한국정밀공학회지(1)
-
Thermal properties in strong hydrogen bonding systems composed of poly(vinyl alcohol), polyethyleneimine, and graphene oxide
Sua Choi, Duck Kun Hwang and Heon Sang Lee 한국탄소학회 Carbon Letters 8 Pages
한국탄소학회 Carbon Letters 2014, Vol.15 No.4 8 282-289 (8 pages)
Blends of poly(vinyl alcohol) (PVA), polyethyleneimine (PEI), and graphene oxide (GO) were prepared by solution casting method. Calorimetric thermal properties of the blends were investigated. The Tgs of PVA/PEI blends were higher than the Tgs of either of the component polymers at low concentrations of PEI. These abnormal increases of Tgs may be due to the negative entropy of mixing which is associated with strong hydrogen bonding between PVA and PEI. The degree of depression of s was not... -
Properties of multi-walled carbon nanotube reinforced epoxy composites fabricated by using sonication and shear mixing
Min Ye Koo, Hon Chung Shin, Won-Seok Kim and Gyo Woo Lee 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2014, Vol.15 No.4 4 255-261 (7 pages)
Multi-walled carbon nanotube reinforced epoxy composites were fabricated using shear mixing and sonication. The mechanical, viscoelastic, thermal, and electrical properties of the fabricated specimens were measured and evaluated. From the images and the results of the measurements of tensile strengths, the specimens having 0.6 wt% nanotube content showed better dispersion and higher strength than those of the other specimens. The Young’s moduli of the specimens increased as the nanotube filler... -
Excellent field emission properties from carbon nanotube field emitters fabricated using a filtration-taping method
Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 한국탄소학회 Carbon Letters 4 Pages
한국탄소학회 Carbon Letters 2014, Vol.15 No.3 10 214-217 (4 pages)
A filtration-taping method was demonstrated to fabricate carbon nanotube (CNT) emitters. This method shows many good features, including high mechanical adhesion, good electrical contact, low temperature, organic-free, low cost, large size, and suitability for various CNT materials and substrates. These good features promise an advanced field emission performance with a turn-on field of 0.88 V/mm at a current density of 0.1 mA/cm2, a threshold field of 1.98 V/mm at a current density of 1 mA/cm2,... -
Fabrication of isotropic bulk graphite using artificial graphite scrap
Sang-Min Lee, Dong-Su Kang, Woo-Seok Kim, Jea-Seung Roh 한국탄소학회 Carbon Letters 4 Pages
한국탄소학회 Carbon Letters 2014, Vol.15 No.2 12 142-145 (4 pages)
pore distribution before and after impregnation were easily confirmed by observing the microstructure. In addition, by using an X-ray diffractometer, the degrees-of-alignment (Da) were obtained for one side perpendicular to the direction of compression molding of the bulk graphite (the “top-face”), and one side parallel to the direction of compression molding (the “side-face”). The anisotropy ratio calculated from the Da-values obtained was 1.13, which indicates comparatively good isotropy. -
Effect of stacking sequence on the flexural and fracture properties of carbon/basalt/epoxy hybrid composites
Jae Il Lim, Kyong Yop Rhee, Hyun Ju Kim, Dong Ho Jung 한국탄소학회 Carbon Letters 4 Pages
한국탄소학회 Carbon Letters 2014, Vol.15 No.2 9 125-128 (4 pages)
tests were conducted and the fracture surfaces of the carbon/basalt/epoxy hybrid composites were then examined using scanning electron microscopy (SEM). The results showed that the flexural strength and flexural modulus of the CSBC specimen respectively were ~32% and ~245% greater than those of the BSCC specimen. However, the interlaminar fracture toughness of the CSBC specimen was ~10% smaller than that of the BSCC specimen. SEM results on the fracture surface showed that matrix cracking is a... -
Water and oxygen permeation through transparent ethylene vinyl alcohol/(graphene oxide) membranes
Hye Min Kim, Heon Sang Lee 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2014, Vol.15 No.1 7 50-56 (7 pages)
We prepared ethylene vinyl alcohol (EVOH)/graphene oxide (GO) membranes by solution casting method. X-ray diffraction analysis showed that GOs were fully exfoliated in the EVOH/GO membrane. The glass transition temperatures of EVOH were increased by adding GOs into EVOH. The melting temperatures of EVOH/GO composites were decreased by adding GOs into EVOH, indicating that GOs may inhibit the crystallization of EVOH during non-isothermal crystallization. However, the equilibrium melting... -
Morphological optimization of process parameters of randomly oriented carbon/carbon composite
Thakur Sudesh Kumar Raunija, Sushant Krunal Manwatkar, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2014, Vol.15 No.1 3 25-31 (7 pages)
analysis of the carbon/ carbon compacts is performed for each variant. Higher heating rates give bloated compacts whereas low heating rates give bloating-free, fine microstructure compacts. The compacts fabricated at higher pressure have displayed side oozing of molten pitch and discrete length carbon fibers. The microstructure of the compacts fabricated at low pressure shows a lack of densification. The compacts with low matrix precursor to reinforcement weight ratios have insufficient bonding... -
Graphene growth from polymers
Hong-Kyu Seo, Tae-Woo Lee 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2013, Vol.14 No.3 2 145-151 (7 pages)
-
Carbon nanotubes–properties and applications
Khalid Saeed Ibrahim 한국탄소학회 Carbon Letters 14 Pages
한국탄소학회 Carbon Letters 2013, Vol.14 No.3 1 131-144 (14 pages)
-
Graphene: an emerging material for biological tissue engineering
SangKyu Lee, Hyun Kim, BongSup Shim 한국탄소학회 Carbon Letters 13 Pages
한국탄소학회 Carbon Letters 2013, Vol.14 No.2 1 63-75 (13 pages)


전체 선택해제

총


