학지사 뉴논문

총 167건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

121.

Green synthesis of fluorescent carbon dots from carrot juice for in vitro cellular imaging

Yang Liu, Yanan Liu, Mira Park, Soo-Jin Park, Yifan Zhang, Md Rashedunnabi Akanda, Byung-Yong Park, Hak Yong Kim 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 7 61-67 (7 pages)

Yang Liu, Yanan Liu, Mira Park, Soo-Jin Park, Yifan Zhang, Md Rashedunnabi Akanda, Byung-Yong Park, Hak Yong Kim 저
...
- 3,000원
quantum dots for bioimaging application. The as-derived CDs possessing down and up-conversion photoluminescence features were obtained from carrot juice by commonly used hydrothermal treatment. The corresponding physiochemical and optical properties were investigated by electron microscopy, fluorescent spectrometry, and other spectroscopic methods. The surfaces of obtained CDs were highly covered with hydroxyl groups and nitrogen groups without further modification. The quantum yield of...
122.

Effects of heat treatment time on aromatic yield of pyrolysis fuel oil-derived pitches

Hye Kyoung Shin, Min-Kang Seo, Yun Hyuk Bang, Soo-Jin Park 한국탄소학회 Carbon Letters 3 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 13 104-106 (3 pages)

Hye Kyoung Shin, Min-Kang Seo, Yun Hyuk Bang, Soo-Jin Park 저
...
- 1,500원
123.

The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 저
...
- 3,000원
Taguchi’s experimental design was employed in the melt spinning of molten mesophase pitch to produce carbon fibers. The textures of the obtained carbon fibers were radial with varied crack angles, as observed by scanning electron microscopy and polarized optical imaging. The diameter, crack angle, preferred orientation, and tensile modulus of the produced samples were examined to investigate the influence of four spinning variables. The relative importance of the variables has been emphasized...
124.

Effects of electrochemical oxidation of carbon fibers on interfacial shear strength using a micro-bond method

Dong-Kyu Kim, Kay-Hyeok An, Yun Hyuk Bang, Lee-Ku Kwac, Sang-Yub Oh, Byung-Joo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 4 32-39 (8 pages)

Dong-Kyu Kim, Kay-Hyeok An, Yun Hyuk Bang, Lee-Ku Kwac, Sang-Yub Oh, Byung-Joo Kim 저
...
- 3,000원
(CFs) on interfacial adhesion between CF and epoxy resin with various current densities. The surface morphologies and properties of the CFs before and after electrochemical-oxidation-treatment were characterized using field emission scanning electron microscopy, atomic force microscopy, Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, and single-fiber contact angle. The mechanical interfacial shear strength of the CFs/epoxy matrix composites was investigated by using a...
125.

Photocatalytic degradation and antibacterial investigation of nano synthesized Ag₃VO₄ particles @PAN nanofibers

Prem Singh Saud, Zafar Khan Ghouri, Bishweshwar Pant, Taehee An, Joong Hee Lee, Mira Park, Hak-Yong Kim 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 5 30-36 (7 pages)

Prem Singh Saud, Zafar Khan Ghouri, Bishweshwar Pant, Taehee An, Joong Hee Lee, Mira Park, Hak-Yong Kim 저
...
- 3,000원
methylene blue. Their structural, optical, and photocatalytic properties have been studied by X-ray diffraction, transmission electron microscopy, field-emission scanning electron microscopy equipped with rapid energy dispersive analysis of X-ray, photoluminescence, and ultraviolet?visible spectroscopy. The characterization procedures revealed that the obtained material is PAN nanofibers decorated by Ag₃VO₄ nanoparticles. Photocatalytic degradation of methylene blue investigated in an aqueous...
126.

Mechanical interfacial adhesion of carbon fibers-reinforced polarized-polypropylene matrix composites: effects of silane coupling agents

Woong-Ki Choi, Hyun-Il Kim, Shin-Jae Kang, Young Sil Lee, Jong Hun Han, Byung-Joo Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 12 79-84 (6 pages)

Woong-Ki Choi, Hyun-Il Kim, Shin-Jae Kang, Young Sil Lee, Jong Hun Han, Byung-Joo Kim 저
...
- 3,000원
127.

Experimental study on synthesis of Co/CeO₂-doped carbon nanofibers and its performance in supercapacitors

Jongwan Kim, Zafar Khan Ghouri, Rabia Zafar Khan, Taehee An, Mira Park, Hak-Yong Kim 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.4 8 270-274 (5 pages)

Jongwan Kim, Zafar Khan Ghouri, Rabia Zafar Khan, Taehee An, Mira Park, Hak-Yong Kim 저
...
- 1,500원
128.

Effects of cross-linking methods for polyethylene-based carbon fibers: review

Kwan-Woo Kim, Hye-Min Lee, Jeong-Hun An, Byoung-Suhk Kim, Byung-Gak Min, Shin-Jae Kang, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 24 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 2 147-170 (24 pages)

Kwan-Woo Kim, Hye-Min Lee, Jeong-Hun An, Byoung-Suhk Kim, Byung-Gak Min, Shin-Jae Kang, Kay-Hyeok An, Byung-Joo Kim 저
...
- 5,300원
interest in the use of carbon fiber reinforced plastic (CFRP) in aerospace, renewable energy and other industries, due to its low weight and relatively good mechanical properties compared with traditional metals. However, due to the high cost of petroleum-based precursors and their associated processing costs, CF remains a specialty product and as such has been limited to use in high-end aerospace, sporting goods, automotive, and specialist industrial applications. The high cost of CF is a...
129.

Characterization and influence of shear flow on the surface resistivity and mixing condition on the dispersion quality of multi-walled carbon nanotube/polycarbonate nanocomposites

Young Sil Lee, Kwan Han Yoon 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 3 86-92 (7 pages)

Young Sil Lee, Kwan Han Yoon 저
...
- 3,000원
Multi-walled carbon nanotube (MWCNT)/polycarbonate (PC) nanocomposite was prepared by direct melt mixing to investigate the effect of the shear rate on the surface resistivity of the nanocomposites. In this study, an experiment was carried out to observe the shear induced orientation of the MWCNT in the polymer matrix using a very simple melt flow indexer with various loads. The compression-molded, should be eliminated. MWCNT/PC nanocomposite sample exhibited lower percolation thresholds (at 0.8...
130.

Effects of comonomer with carboxylic group on stabilization of high molecular weight polyacrylonitrile nanofibrous copolymers

Danyun Lei, Kesavan Devarayan1, Xiang-Dan Li, Woong-Ki Choi, Min-Kang Seo and Byoung-Suhk Kim 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 9 290-294 (5 pages)

Danyun Lei, Kesavan Devarayan1, Xiang-Dan Li, Woong-Ki Choi, Min-Kang Seo and Byoung-Suhk Kim 저
...
- 1,500원
New precursors, poly(acrylonitrile-co-crotonic acid) (poly(AN-CA)) and poly(acrylonitrile-co-itaconic acid-co-crotonic acid) (poly(AN-IA-CA)) copolymers, for the preparation of carbon fibers, were explored in this study. The effects of comonomers with acidic groups, such as crotonic acid (CA) and/or itaconic acid (IA), on the stabilization of nanofibrous polyacrylonitrile (PAN) copolymers were studied. The extent of stabilization, evaluated by Fourier transform infrared spectroscopy, revealed...

한주간 이슈검색어