학지사 뉴논문

총 246건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

141.

Mechanical and electrical properties of cement paste incorporated with pitch-based carbon fiber

Inkyu Rhee, Jin Hee Kim, Sang Hee Park, Sungho Lee, Bong Ryeul Ryu, Yoong Ahm Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 4 22-29 (8 pages)

Inkyu Rhee, Jin Hee Kim, Sang Hee Park, Sungho Lee, Bong Ryeul Ryu, Yoong Ahm Kim 저
...
- 3,000원
The compressive strength and electrical resistance of pitch-based carbon fiber (CF) in cementitious materials are explored to determine the feasibility of its use as a functional material in construction. The most widely used CFs are manufactured from polyacrylonitrile (PAN-based CF). Alternatively, short CFs are obtained in an economical way using pitch as a precursor in a melt-blown process (pitch-based CF), which is cheaper and more eco-friendly method because this pitch-based CF is basically...
142.

Synthesis, characterization, and antibacterial performance of Ag-modified graphene oxide reinforced electrospun polyurethane nanofibers

Bishweshwar Pant, Mira Park, Rae-Sang Jang, Woo-Cheol Choi, Hak-Yong Kim, Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 3 17-21 (5 pages)

Bishweshwar Pant, Mira Park, Rae-Sang Jang, Woo-Cheol Choi, Hak-Yong Kim, Soo-Jin Park 저
...
- 1,500원
Polyurethane (PU) nanofibers containing graphene oxide (GO) and Ag doped functionalized reduced graphene oxide (Ag-RGO) were successfully prepared via the electrospinning technique. The uniform distribution of GO sheets along with Ag nanoparticle in the nano?bers was investigated by scanning electron microscopy and the elemental mapping technique. X-ray diffraction and thermal gravimetric analysis veri?ed the presence of GO and Ag in the bicomposite nano?brous mats. Antibacterial tests against...
143.

Li-ion battery anodes from ginkgo leaf-derived nanoporous carbons rich in redox-active heteroatoms

Na Rae Kim, Hong Joo An, Young Soo Yun, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 13 110-114 (5 pages)

Na Rae Kim, Hong Joo An, Young Soo Yun, Hyoung-Joon Jin 저
...
- 1,500원
Lithium-ion batteries (LIBs) have attracted increasing attention as a sustainable power source due to the rapid growth in mobile electronics and electric automobile markets, driven by increasing environmental awareness [1-4]. The electrochemical performance of LIBs is strongly dependent on the active electrode materials. Therefore, their continuing advanced development is of key importance to meet the expectations of the market [5-7]. Graphite, commonly used in LIB anodes, forms binary graphite...
144.

High-energy-density activated carbon electrode for organic electric-double-layer-capacitor using carbonized petroleum pitch

Poo Reum Choi, Sang-Gil Kim, Ji Chul Jung, Myung-Soo Kim 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 8 70-80 (11 pages)

Poo Reum Choi, Sang-Gil Kim, Ji Chul Jung, Myung-Soo Kim 저
...
- 4,000원
Activated carbons (ACs) have been used as electrode materials of electric double-layer capacitors (EDLC) due to their high specific surface areas (SSA), stability, and ecological advantages. In order to make high-energy-density ACs for EDLC, petroleum pitch (PP) precarbonized at 500?1000°C in N2 gas for 1 h was used as the electrode material of the EDLC after KOH activation. As the pre-carbonization temperature increased, the SSA, pore volume and gravimetric capacitance tended to decrease, but...
145.

Synthesis and characterization of carbon doped TiO₂ photocatalysts supported on stainless steel mesh by sol-gel method

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 6 48-59 (12 pages)

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 저
...
- 4,100원
This study synthesized pure anatase carbon doped TiO₂ photocatalysts supported on a stainless steel mesh using a sol-gel solution of 8% polyacrylonitrile (PAN)/dimethylformamide (DMF)/TiCl₄. The influence of the pyrolysis temperature and holding time on the morphological characteristics, particle sizes and surface area of the prepared catalyst was investigated. The prepared catalysts were characterized by several analytical methods: high resolution scanning electron microscopy (HRSEM), energy...
146.

EMI shielding effectiveness and mechanical properties of MWCNTs-reinforced biodegradable epoxy matrix composites

Yoon-Ji Yim, Dong Chul Chung, Soo-Jin Park 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 4 36-41 (6 pages)

Yoon-Ji Yim, Dong Chul Chung, Soo-Jin Park 저
...
- 3,000원
Biodegradable epoxy (B-epoxy) was prepared from diglycidyl ether of bisphenol A and epoxidized linseed oil. The mechanical properties of B-epoxy composites reinforced with multi-walled carbon nanotubes (MWCNTs/B-epoxy) were examined by employing dynamic mechanical analysis, critical stress intensity factor (KIC) tests, and impact strength tests. The electromagnetic interference shielding effectiveness (EMI-SE) of the composites was evaluated using reflection and absorption methods. Mechanical...
147.

Effects of coal tar pitch addition on the wear behavior of carbon/carbon composites

Young Chan Jung, Duk Soo Kang, Kyong Yop Rhee, Soo Jin Park, David Hui 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 9 62-65 (4 pages)

Young Chan Jung, Duk Soo Kang, Kyong Yop Rhee, Soo Jin Park, David Hui 저
...
- 1,500원
Carbon/carbon (C/C) composites are acknowledged as high performance materials because of their good mechanical properties such as wear resistance, even at the higher temperature, due to their low thermal expansion [1-5]. Their hardness and light weight in addition to their superior mechanical properties at high temperature make C/C composites the best material to make brakes for aircrafts and other high weight vehicles. Accordingly, a number of studies have been conducted on the performance of...
148.

Effects of maleic anhydride content on mechanical properties of carbon fibers-reinforced maleic anhydride-grafted-polypropylene matrix composites

Hyun-Il Kim, Woong Han, Woong-Ki Choi, Soo-Jin Park, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 6 39-46 (8 pages)

Hyun-Il Kim, Woong Han, Woong-Ki Choi, Soo-Jin Park, Kay-Hyeok An, Byung-Joo Kim 저
...
- 3,000원
In this work, the effects of maleic anhydride (MA) content on mechanical properties of chopped carbon fibers (CFs)-reinforced MA-grafted-polypropylene (MAPP) matrix composites. A direct oxyfluorination on CF surfaces was applied to increase the interfacial strength between the CFs and MAPP matrix. The mechanical properties of the CFs/MAPP composites are likely to be different in terms of MA content. Surface characteristics were observed by scanning electron microscope, Fourier transform infrared...
149.

NO gas sensing ability of activated carbon fibers modified by an electron beam for improvement in the surface functional group

Mi-Seon Park, Sangmin Lee, Min-Jung Jung, Hyeong Gi Kim, Young-Seak Lee 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 3 19-25 (7 pages)

Mi-Seon Park, Sangmin Lee, Min-Jung Jung, Hyeong Gi Kim, Young-Seak Lee 저
...
- 3,000원
Activated carbon fiber (ACF) surfaces are modified using an electron beam under different aqueous solutions to improve the NO gas sensitivity of a gas sensor based on ACFs. The oxygen functional group on the ACF surface is changed, resulting in an increase of the number of non-carbonyl (-C-O-C-) groups from 32.5% for pristine ACFs to 39.53% and 41.75% for ACFs treated with hydrogen peroxide and potassium hydroxide solutions, respectively. We discover that the NO gas sensitivity of the gas sensor...
150.

Effect of fiber-matrix adhesion on the fracture behavior of a carbon fiber reinforced thermoplastic-modified epoxy matrix

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 6 47-56 (10 pages)

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 저
...
- 3,000원
In this study, the fracture behavior of a thermoplastic-modified epoxy resin reinforced with continuous carbon fibers for two levels of fiber-matrix adhesion was performed. A carbon fiber with commercial sizing was used and also treated with a known silane, (3-glycidoxy propyl trimethoxysilane) coupling agent. Toughness was determined using the double cantilever test, together with surface analysis after failure using scanning electron microscope. The presence of polysulfone particles improved...

한주간 이슈검색어