학지사 뉴논문

총 275건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

161.

Adsorption of Nile Blue A from aqueous solution by different nanostructured carbon adsorbents

Shahryar Abbasi, Hadi Noorizadeh 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 5 30-37 (8 pages)

Shahryar Abbasi, Hadi Noorizadeh 저
...
- 3,000원
Dyes are widely used in various industries including textile, cosmetic, paper, plastics, rubber, and coating, and their discharge into waterways causes serious environmental and health problems. Four different carbon nanostructures, graphene oxide, oxidized multi-walled carbon nanotubes, activated carbon and multi-walled carbon nanotubes, were used as adsorbents for the removal of Nile Blue A (NBA) dye from aqueous solution. The four carbon nanostructures were characterized by scanning electron...
162.

Li-ion battery anodes from ginkgo leaf-derived nanoporous carbons rich in redox-active heteroatoms

Na Rae Kim, Hong Joo An, Young Soo Yun, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 13 110-114 (5 pages)

Na Rae Kim, Hong Joo An, Young Soo Yun, Hyoung-Joon Jin 저
...
- 1,500원
Lithium-ion batteries (LIBs) have attracted increasing attention as a sustainable power source due to the rapid growth in mobile electronics and electric automobile markets, driven by increasing environmental awareness [1-4]. The electrochemical performance of LIBs is strongly dependent on the active electrode materials. Therefore, their continuing advanced development is of key importance to meet the expectations of the market [5-7]. Graphite, commonly used in LIB anodes, forms binary graphite...
163.

Fabrication of carbon fiber SMC composites with vinyl ester resin and effect of carbon fiber content on mechanical properties

Haksung Lee, Mongyoung Huh, Jaeyoung Yoon, Dasom Lee, Seonyul Kim, Shinjae Kang 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 11 101-104 (4 pages)

Haksung Lee, Mongyoung Huh, Jaeyoung Yoon, Dasom Lee, Seonyul Kim, Shinjae Kang 저
...
- 1,500원
strength and weight reduction make fiber composite materials an attractive replacement for metal components. The development of composites like carbon fiber reinforced plastic and related production technologies have contributed to the increasing application of fiber composite materials. Many new components have recently been adapted, including structural parts such as roof frames, under floors, trunk hoods and so on, using sheet molding compound (SMC) and resin transfer molding processes [1-5].
164.

High-energy-density activated carbon electrode for organic electric-double-layer-capacitor using carbonized petroleum pitch

Poo Reum Choi, Sang-Gil Kim, Ji Chul Jung, Myung-Soo Kim 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 8 70-80 (11 pages)

Poo Reum Choi, Sang-Gil Kim, Ji Chul Jung, Myung-Soo Kim 저
...
- 4,000원
Activated carbons (ACs) have been used as electrode materials of electric double-layer capacitors (EDLC) due to their high specific surface areas (SSA), stability, and ecological advantages. In order to make high-energy-density ACs for EDLC, petroleum pitch (PP) precarbonized at 500?1000°C in N2 gas for 1 h was used as the electrode material of the EDLC after KOH activation. As the pre-carbonization temperature increased, the SSA, pore volume and gravimetric capacitance tended to decrease, but...
165.

Synthesis and characterization of carbon doped TiO₂ photocatalysts supported on stainless steel mesh by sol-gel method

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 6 48-59 (12 pages)

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 저
...
- 4,100원
This study synthesized pure anatase carbon doped TiO₂ photocatalysts supported on a stainless steel mesh using a sol-gel solution of 8% polyacrylonitrile (PAN)/dimethylformamide (DMF)/TiCl₄. The influence of the pyrolysis temperature and holding time on the morphological characteristics, particle sizes and surface area of the prepared catalyst was investigated. The prepared catalysts were characterized by several analytical methods: high resolution scanning electron microscopy (HRSEM), energy...
166.

EMI shielding effectiveness and mechanical properties of MWCNTs-reinforced biodegradable epoxy matrix composites

Yoon-Ji Yim, Dong Chul Chung, Soo-Jin Park 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 4 36-41 (6 pages)

Yoon-Ji Yim, Dong Chul Chung, Soo-Jin Park 저
...
- 3,000원
Biodegradable epoxy (B-epoxy) was prepared from diglycidyl ether of bisphenol A and epoxidized linseed oil. The mechanical properties of B-epoxy composites reinforced with multi-walled carbon nanotubes (MWCNTs/B-epoxy) were examined by employing dynamic mechanical analysis, critical stress intensity factor (KIC) tests, and impact strength tests. The electromagnetic interference shielding effectiveness (EMI-SE) of the composites was evaluated using reflection and absorption methods. Mechanical...
167.

Thermo-electrical properties of randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, N. Supriya 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 3 25-35 (11 pages)

Thakur Sudesh Kumar Raunija, N. Supriya 저
...
- 4,000원
The aim of the work was to investigate the thermo-electrical properties of low cost and rapidly produced randomly oriented carbon/carbon (C/C) composite. The composite body was fabricated by combining the high-pressure hot-pressing (HP) method with the lowpressure impregnation thermosetting carbonization (ITC) method. After the ITC method step selected samples were graphitized at 3000°C. Detailed characterization of the samples’ physical properties and thermal properties, including thermal...
168.

Kinetic and multi-parameter isotherm studies of picric acid removal from aqueous solutions by carboxylated multi-walled carbon nanotubes in the presence and absence of ultrasound

Soheila Gholitabar, Hasan Tahermansouri 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 2 14-24 (11 pages)

Soheila Gholitabar, Hasan Tahermansouri 저
...
- 4,000원
Carboxylated multi-wall carbon nanotubes (MWCNTs-COOH) have been used as efficient adsorbents for the removal of picric acid from aqueous solutions under stirring and ultrasound conditions. Batch experiments were conducted to study the influence of the different parameters such as pH, amount of adsorbents, contact time and concentration of picric acid on the adsorption process. The kinetic data were fitted with pseudo-first order, pseudo-secondorder, Elovich and intra-particle diffusion models....
169.

Three-dimensional porous graphene materials for environmental applications

Muruganantham Rethinasabapathy, Sung-Min Kang, Sung-Chan Jang, Yun Suk Huh 한국탄소학회 Carbon Letters 13 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 1 1-13 (13 pages)

Muruganantham Rethinasabapathy, Sung-Min Kang, Sung-Chan Jang, Yun Suk Huh 저
...
- 4,200원
Porous materials play a vital role in science and technology. The ability to control their pore structures at the atomic, molecular, and nanometer scales enable interactions with atoms, ions and molecules to occur throughout the bulk of the material, for practical applications. Three-dimensional (3D) porous carbon-based materials (e.g., graphene aerogels/hydrogels, sponges and foams) made of graphene or graphene oxide-based networks have attracted considerable attention because they offer low...
170.

Thermoelectric Seebeck and Peltier effects of single walled carbon nanotube quantum dot nanodevice

H. A. El-Demsisy, M. D. Asham, D. S. Louis, A. H. Phillips 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 2 8-15 (8 pages)

H. A. El-Demsisy, M. D. Asham, D. S. Louis, A. H. Phillips 저
...
- 3,000원
The thermoelectric Seebeck and Peltier effects of a single walled carbon nanotube (SWCNT) quantum dot nanodevice are investigated, taking into consideration a certain value of applied tensile strain and induced ac-field with frequency in the terahertz (THz) range. This device is modeled as a SWCNT quantum dot connected to metallic leads. These two metallic leads operate as a source and a drain. In this three-terminal device, the conducting substance is the gate electrode. Another metallic gate...

한주간 이슈검색어