학지사 뉴논문

총 265건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

171.

Relationships between dielectric properties and characteristics of impregnated and activated samples of potassium carbonate- and sodium hydroxide-modified palm kernel shell for microwave-assisted activation

Norulaina Alias, Muhammad Abbas Ahmad Zaini, Mohd Johari Kamaruddin 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.24 9 62-72 (11 pages)

Norulaina Alias, Muhammad Abbas Ahmad Zaini, Mohd Johari Kamaruddin 저
...
- 4,000원
a mass ratio of 1.5) exhibited a high loss tangent (tan δ) indicating the effectiveness of these materials to be heated by microwaves. K2CO3 and NaOH can act as a microwave absorber to enhance the efficiency of microwave heating for low loss PKSs. Materials with a high moisture content exhibit a high loss tangent but low penetration depth. The interplay of multiple operating frequencies is suggested to promote better microwave heating by considering the changes in the materials characteristics.
172.

Effect of the surface modification using MWCNTs with different L/D by two different methods of deposition on the IFSS of single carbon fiber-epoxy resin composite

Minerva L. Herrera-Sosa, Alex Valadez-Gonz?lez, Humberto V?zquez-Torres, Pierre G. Mani-Gonz?lez, Pedro J. Herrera-Franco 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2017, Vol.24 3 18-27 (10 pages)

Minerva L. Herrera-Sosa, Alex Valadez-Gonz?lez, Humberto V?zquez-Torres, Pierre G. Mani-Gonz?lez, Pedro J. Herrera-Franco 저
...
- 3,000원
amine surface groups. The MWCNT were deposited on the CF using two methods, by electrostatic attraction and by chemical reactions. The changes in the CF surface morphology after the MWCNT deposition were analyzed using SEM, which revealed a higher density and uniform coverage for the PAMAM-treated CF and the short MWCNTs. The interfacial adhesion of the composite materials was evaluated using the single fiber fragmentation technique. The results indicated an improvement in the interfacial shear...
173.

Capacitance behaviors of conducting polymer-coated graphene nanosheets composite electrodes containing multi-walled carbon nanotubes as additives

Hoe-Seung Kim, Yongju Jung, Seok Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 9 63-68 (6 pages)

Hoe-Seung Kim, Yongju Jung, Seok Kim 저
...
- 3,000원
of fossil fuels. To resolve this problem, various studies on efficient energy storage devices have been undertaken. Electronic technologies are increasingly used in electronic products and systems, and they require effective energy storage [1,2]. Supercapacitors are energy storage devices with high power density and long cycle life, and have been spotlighted in recent years because of their promising applications in portable devices, electric vehicles, transportation systems, digital devices.
174.

Dispersions of partially reduced graphene oxide in various organic solvents and polymers

Hye Min Kim, Seo Gyun Kim, Heon Sang Lee 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2017, Vol.23 8 55-62 (8 pages)

Hye Min Kim, Seo Gyun Kim, Heon Sang Lee 저
...
- 3,000원
ketone. We achieve relatively good dispersion in aprotic and non-polar solvents by controlling the C/O atomic ratio of the PRGOs and applying the two-phase solvent exchange method. There is an increase in the glass transition temperatures with the dispersion of PRGOs into amorphous polymers, in particular a 4.4°C increase for poly(methyl methacrylate) and 3.0°C increase for polycarbonate. Good dispersion of PRGO in a nonpolar polymer, such as linear low density polyethylene, is also obtained.
175.

Fabrication of carbon fiber SMC composites with vinyl ester resin and effect of carbon fiber content on mechanical properties

Haksung Lee, Mongyoung Huh, Jaeyoung Yoon, Dasom Lee, Seonyul Kim, Shinjae Kang 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 11 101-104 (4 pages)

Haksung Lee, Mongyoung Huh, Jaeyoung Yoon, Dasom Lee, Seonyul Kim, Shinjae Kang 저
...
- 1,500원
the automotive industry and other manufacturing fields. Their properties, including high specific stiffness, strength and weight reduction make fiber composite materials an attractive replacement for metal components. The development of composites like carbon fiber reinforced plastic and related production technologies have contributed to the increasing application of fiber composite materials. Many new components have recently been adapted, including structural parts such as roof frames, under...
176.

EMI shielding effectiveness and mechanical properties of MWCNTs-reinforced biodegradable epoxy matrix composites

Yoon-Ji Yim, Dong Chul Chung, Soo-Jin Park 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 4 36-41 (6 pages)

Yoon-Ji Yim, Dong Chul Chung, Soo-Jin Park 저
...
- 3,000원
Biodegradable epoxy (B-epoxy) was prepared from diglycidyl ether of bisphenol A and epoxidized linseed oil. The mechanical properties of B-epoxy composites reinforced with multi-walled carbon nanotubes (MWCNTs/B-epoxy) were examined by employing dynamic mechanical analysis, critical stress intensity factor (KIC) tests, and impact strength tests. The electromagnetic interference shielding effectiveness (EMI-SE) of the composites was evaluated using reflection and absorption methods. Mechanical...
177.

Thermo-electrical properties of randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, N. Supriya 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 3 25-35 (11 pages)

Thakur Sudesh Kumar Raunija, N. Supriya 저
...
- 4,000원
The aim of the work was to investigate the thermo-electrical properties of low cost and rapidly produced randomly oriented carbon/carbon (C/C) composite. The composite body was fabricated by combining the high-pressure hot-pressing (HP) method with the lowpressure impregnation thermosetting carbonization (ITC) method. After the ITC method step selected samples were graphitized at 3000°C. Detailed characterization of the samples’ physical properties and thermal properties, including thermal...
178.

Three-dimensional porous graphene materials for environmental applications

Muruganantham Rethinasabapathy, Sung-Min Kang, Sung-Chan Jang, Yun Suk Huh 한국탄소학회 Carbon Letters 13 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 1 1-13 (13 pages)

Muruganantham Rethinasabapathy, Sung-Min Kang, Sung-Chan Jang, Yun Suk Huh 저
...
- 4,200원
graphene oxide-based networks have attracted considerable attention because they offer low density, high porosity, large surface area, excellent electrical conductivity and stable mechanical properties. Water pollution and associated environmental issues have become a hot topic in recent years. Rapid industrialization has led to a massive increase in the amount of wastewater that industries discharge into the environment. Water pollution is caused by oil spills, heavy metals, dyes, and organic...
179.

Tribological properties of carbon fiber-reinforced aluminum composites processed by spark plasma sintering

Ki Hoon Jung, Seungjin Nam, Sung-Soo Kang, Bon-Cheol Ku, Yun Hyuk Bang, Jun Yeon Hwang 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 14 103-106 (4 pages)

Ki Hoon Jung, Seungjin Nam, Sung-Soo Kang, Bon-Cheol Ku, Yun Hyuk Bang, Jun Yeon Hwang 저
...
- 1,500원
The development of light-weight and high-strength materials have gained attention to meet the evergrowing demands for safer and fuel-efficient automobiles. Thus, the importance and applications of composite materials are gradually increasing [1]. In the field of metal-matrix composite manufacturing, reinforcing agents are added to the metal matrix in the form of powders, whiskers, and fibers to improve the mechanical properties of metals [2]. Fibers have been used since the 1950s as structural...
180.

Activating needle coke to develop anode catalyst for direct methanol fuel cell

Young Hun Park, Ui-Su Im, Byung-Rok Lee, Dong-Hyun Peck, Sang-Kyung Kim, Young Woo Rhee, Doo-Hwan Jung 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 7 47-52 (6 pages)

Young Hun Park, Ui-Su Im, Byung-Rok Lee, Dong-Hyun Peck, Sang-Kyung Kim, Young Woo Rhee, Doo-Hwan Jung 저
...
- 3,000원
Physical and electrochemical qualities were analyzed after KOH activation of a direct methanol fuel cell using needle coke as anode supporter. The results of research on support loaded with platinum-ruthenium suggest that an activated KOH needle coke container has the lowest onset potential and the highest degree of catalyst activity among all commercial catalysts. Through an analysis of the CO stripping voltammetry, we found that KOH activated catalysis showed a 21% higher electrochemical...

한주간 이슈검색어