학지사 뉴논문

총 3,449건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

2571.

In-situ magnetization measurements and ex-situ morphological analysis of electrodeposited cobalt onto chemical vapor deposition graphene/SiO₂/Si

Vin?cius C. De Franco, Gustavo M. B. Castro, Jeaneth Corredor, Daniel Mendes, Jo?o E. Schmidt 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 3 16-22 (7 pages)

Vin?cius C. De Franco, Gustavo M. B. Castro, Jeaneth Corredor, Daniel Mendes, Jo?o E. Schmidt 저
...
- 3,000원
Cobalt was electrodeposited onto chemical vapor deposition (CVD) graphene/Si/SiO2 substrates, during different time intervals, using an electrolyte solution containing a low concentration of cobalt sulfate. The intention was to investigate the details of the deposition process (and the dissolution process) and the resulting magnetic properties of the Co deposits on graphene. During and after electrodeposition, in-situ magnetic measurements were performed using an (AGFM). These were followed by...
2572.

Thermoelectric Seebeck and Peltier effects of single walled carbon nanotube quantum dot nanodevice

H. A. El-Demsisy, M. D. Asham, D. S. Louis, A. H. Phillips 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 2 8-15 (8 pages)

H. A. El-Demsisy, M. D. Asham, D. S. Louis, A. H. Phillips 저
...
- 3,000원
The thermoelectric Seebeck and Peltier effects of a single walled carbon nanotube (SWCNT) quantum dot nanodevice are investigated, taking into consideration a certain value of applied tensile strain and induced ac-field with frequency in the terahertz (THz) range. This device is modeled as a SWCNT quantum dot connected to metallic leads. These two metallic leads operate as a source and a drain. In this three-terminal device, the conducting substance is the gate electrode. Another metallic gate...
2573.

Effects of carbon additives on heat-transfer and mechanical properties of high early strength cement mortar

Dae-Geun Lee, Kyung Hoon Kim, Hyeong Gi Kim, Young-Seak Lee 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 11 72-75 (4 pages)

Dae-Geun Lee, Kyung Hoon Kim, Hyeong Gi Kim, Young-Seak Lee 저
...
- 1,500원
roads are inevitably degraded by deterioration or damage. To save expense during construction and to avoid traffic congestion during repair work, it is very important to reduce construction time as much as possible. In order to reduce construction time, therefore, the setting time of mortars has to be shortened. The mortars which have short setting times are called high early strength cement mortars. These high early strength cement mortars usually have a short working time of under 40 min and a...
2574.

Effect of acid catalysts on carbonization temperatures for ordered mesoporous carbon materials

Jeong Kuk Shon, Xing Jin, Yun Seok Choi, Jong Gu Won, Yoon Kyung Hwang, Dae Jong You, Chengbin Li, Ji Man Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 10 66-71 (6 pages)

Jeong Kuk Shon, Xing Jin, Yun Seok Choi, Jong Gu Won, Yoon Kyung Hwang, Dae Jong You, Chengbin Li, Ji Man Kim 저
...
- 3,000원
order to oligomerize or polymerize the carbon precursors before the carbonization, an aging process should also be carried out in the presence of acid catalysts in low temperature ranges of 100°C?200°C. In the case of sucrose as a carbon source, sulfuric acid (H2SO4) is typically used as an acid catalyst for the dehydration and subsequent oligomerization of the carbon precursor. This is very important for preventing the infiltrated carbon precursors from draining outside the mesopores of the...
2575.

Activating needle coke to develop anode catalyst for direct methanol fuel cell

Young Hun Park, Ui-Su Im, Byung-Rok Lee, Dong-Hyun Peck, Sang-Kyung Kim, Young Woo Rhee, Doo-Hwan Jung 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 7 47-52 (6 pages)

Young Hun Park, Ui-Su Im, Byung-Rok Lee, Dong-Hyun Peck, Sang-Kyung Kim, Young Woo Rhee, Doo-Hwan Jung 저
...
- 3,000원
suggest that an activated KOH needle coke container has the lowest onset potential and the highest degree of catalyst activity among all commercial catalysts. Through an analysis of the CO stripping voltammetry, we found that KOH activated catalysis showed a 21% higher electrochemical active surface area (ECSA), with a value of 31.37 m2/g, than the ECSA of deactivated catalyst (25.82 m2/g). The latter figure was 15% higher than the value of one specific commercial catalyst (TEC86E86).
2576.

Effects of maleic anhydride content on mechanical properties of carbon fibers-reinforced maleic anhydride-grafted-polypropylene matrix composites

Hyun-Il Kim, Woong Han, Woong-Ki Choi, Soo-Jin Park, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 6 39-46 (8 pages)

Hyun-Il Kim, Woong Han, Woong-Ki Choi, Soo-Jin Park, Kay-Hyeok An, Byung-Joo Kim 저
...
- 3,000원
of the CFs/MAPP composites are likely to be different in terms of MA content. Surface characteristics were observed by scanning electron microscope, Fourier transform infrared spectroscopy, and single fiber contact angle method. The mechanical properties of the composites were also measured by a critical stress intensity factor (KIC). From the KIC test results, the KIC values were increased to a maximum value of 3.4 MPa with the 0.1 % of MA in the PP, and then decreased with higher MA content.
2577.

Morphologies and surface properties of cellulose-based activated carbon nanoplates

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 5 32-38 (7 pages)

Seulbee Lee, Min Eui Lee, Min Yeong Song, Se Youn Cho, Young Soo Yun, Hyoung-Joon Jin 저
...
- 3,000원
In this study, cellulose nanoplates (CNPs) were fabricated using cellulose nanocrystals obtained from commercial microcrystalline cellulose (MCC). Their pyrolysis behavior and the characteristics of the product carbonaceous materials were investigated. CNPs showed a relatively high char yield when compared with MCC due to sulfate functional groups introduced during the manufacturing process. In addition, pyrolyzed CNPs (CCNPs) showed more effective chemical activation behavior compared with...
2578.

Nanoporous carbon synthesized from grass for removal and recovery of hexavalent chromium

Shahin A. Pathan, Nancy S. Pandita 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 2 10-18 (9 pages)

Shahin A. Pathan, Nancy S. Pandita 저
...
- 3,000원
to Langmuir isotherm model with maximum monolayer adsorption capacity of 35.335 mg/g. The results indicated that removal obeys a pseudo-second-order kinetic model, and that equilibrium was reached in 10 min. A desorption study was done using NaOH. The results of the present study imply that acid functionalized nanoporous carbon synthesized from grass is an efficient, renewable, cost-effective adsorbent material for removal of hexavalent chromium due to its faster removal rate and reusability.
2579.

Adsorption capability of activated carbon synthesized from coconut shell

Md Shariful Islam, Bee Chin Ang, Samira Gharehkhani, Amalina Binti, Muhammad Afifi 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 1 1-9 (9 pages)

Md Shariful Islam, Bee Chin Ang, Samira Gharehkhani, Amalina Binti, Muhammad Afifi 저
...
- 3,000원
activated carbon. The presence of important functional groups was shown by the Fourier transform infrared spectroscopy spectrum. The adsorption of methyl orange onto the activated carbon reached 100% after 12 min. Kinetic analysis indicated that the adsorption of methyl orange solution by the activated carbon followed a pseudo-second-order kinetic mechanism (R2 > 0.995). Therefore, the results show that the produced activated carbon can be used as a proper adsorbent for dye containing effluents.
2580.

Thermoelectric properties of carbonaceous solids

Francesco Miccio 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 14 107-111 (5 pages)

Francesco Miccio 저
...
- 1,500원

한주간 이슈검색어