학지사 뉴논문

총 654건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

271.

Effect of fiber-matrix adhesion on the fracture behavior of a carbon fiber reinforced thermoplastic-modified epoxy matrix

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 6 47-56 (10 pages)

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 저
...
- 3,000원
In this study, the fracture behavior of a thermoplastic-modified epoxy resin reinforced with continuous carbon fibers for two levels of fiber-matrix adhesion was performed. A carbon fiber with commercial sizing was used and also treated with a known silane, (3-glycidoxy propyl trimethoxysilane) coupling agent. Toughness was determined using the double cantilever test, together with surface analysis after failure using scanning electron microscope. The presence of polysulfone particles improved...
272.

Sorption behavior of slightly reduced, three-dimensionally macroporous graphene oxides for physical loading of oils and organic solvents

Ho Seok Park, Sung Oong Kang 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 4 24-29 (6 pages)

Ho Seok Park, Sung Oong Kang 저
...
- 3,000원
High pollutant-loading capacities (up to 319 times its own weight) are achieved by three-dimensional (3D) macroporous, slightly reduced graphene oxide (srGO) sorbents, which are prepared through ice-templating and consecutive thermal reduction. The reduction of the srGO is readily controlled by heating time under a mild condition (at 1 10?2 Torr and 200°C). The saturated sorption capacity of the hydrophilic srGO sorbent (thermally reduced for 1 h) could not be improved further even though the...
273.

Mechanical interfacial adhesion of carbon fibers-reinforced polarized-polypropylene matrix composites: effects of silane coupling agents

Woong-Ki Choi, Hyun-Il Kim, Shin-Jae Kang, Young Sil Lee, Jong Hun Han, Byung-Joo Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 12 79-84 (6 pages)

Woong-Ki Choi, Hyun-Il Kim, Shin-Jae Kang, Young Sil Lee, Jong Hun Han, Byung-Joo Kim 저
...
- 3,000원
274.

Synthesis, characterization, and toxicity of multi-walled carbon nanotubes functionalized with 4-hydroxyquinazoline

Hasan Tahermansouri, Atieh Mirosanloo, Saeed Heidari Keshel, Mossa Gardaneh 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 7 45-52 (8 pages)

Hasan Tahermansouri, Atieh Mirosanloo, Saeed Heidari Keshel, Mossa Gardaneh 저
...
- 3,000원
The attachment of 2-aminobenzamide to carboxylated multi-wall carbon nanotubes (MWCNTs)- COOH was achieved through the formation of amide bonds. Then, the functionalized MWCNTs, MWCNT-amide, were treated by phosphoryl chloride to produce MWCNT-quin. The products were characterized by Fourier transform infrared spectroscopy, Raman spectroscopy, scanning electron microscopy, thermogravimetric analysis, derivative thermogravimetric, steady-state fluorescence spectroscopy, and solubility testing....
275.

Flexural properties, interlaminar shear strength and morphology of phenolic matrix composites reinforced with xGnP-coated carbon fibers

Jong Kyoo Park, Jae Yeol Lee, Lawrence T. Drzal, Donghwan Cho 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 5 33-38 (6 pages)

Jong Kyoo Park, Jae Yeol Lee, Lawrence T. Drzal, Donghwan Cho 저
...
- 3,000원
In the present study, exfoliated graphite nanoplatelets (xGnP) with different particle sizes were coated onto polyacrylonitrile-based carbon fibers by a direct coating method. The flexural properties, interlaminar shear strength, and the morphology of the xGnP-coated carbon fiber/phenolic matrix composites were investigated in terms of their longitudinal flexural strength and modulus, interlaminar shear strength, and by optical and scanning electron microscopic observations. The results were...
276.

Microwave-assisted pretreatment technologies for the conversion of lignocellulosic biomass to sugars and ethanol: a review

Pradeep Puligundla, Sang-Eun Oh, Chulkyoon Mok 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 1 1-10 (10 pages)

Pradeep Puligundla, Sang-Eun Oh, Chulkyoon Mok 저
...
- 3,000원
Lignocellulosic biomass conversion to biofuels such as ethanol and other value-added bio-products including activated carbons has attracted much attention. The development of an efficient, cost-effective, and eco-friendly pretreatment process is a major challenge in lignocellulosic biomass to biofuel conversion. Although several modern pretreatment technologies have been introduced, few promising technologies have been reported. Microwave irradiation or microwave-assisted methods (physical and...
277.

Catalytic activity and controllable deposition of platinum nanoparticles on ionic polymer-functionalized graphene as catalysts for direct methanol fuel cells

Jiyoung Park, Changyoon Song, Qizhong Sun, Yongju Jung, Seok Kim 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.4 6 260-264 (5 pages)

Jiyoung Park, Changyoon Song, Qizhong Sun, Yongju Jung, Seok Kim 저
...
- 1,500원
278.

Influence of laminated orientation on the mechanical and thermal characteristics of carbon-fiber reinforced plastics

Hee-Jae Shin, Lee-Ku Kwac, Min-Sang Lee, Hong-Gun Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.4 3 241-246 (6 pages)

Hee-Jae Shin, Lee-Ku Kwac, Min-Sang Lee, Hong-Gun Kim 저
...
- 3,000원
Rapid industrial development in recent times has increased the demand for light-weight materials with high strength and structural integrity. In this context, carbon fiber-reinforced plastic (CFRP) composite materials are being extensively used. However, laminated CFRPs develop faults during impact because CFRPs are composed of mixed carbon fiber and epoxy. Moreover, their fracturing behavior is very complicated and difficult to interpret. In this paper, the effect of the direction of lamination...
279.

Manufacturing and characteristics of PAN-based composite carbon fibers containing cellulose particles

Jee-Woo Yang, Da Young Jin, Ji Eun Lee, Seung Goo Lee, Won Ho Park 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.3 7 203-210 (8 pages)

Jee-Woo Yang, Da Young Jin, Ji Eun Lee, Seung Goo Lee, Won Ho Park 저
...
- 3,000원
This study fabricated low thermal conductive polyacrylonitrile (PAN)-based carbon fibers containing cellulose particles while maintaining their mechanical properties. The high thermal conductivity of carbon fibers limits their application as a high temperature insulator in various systems such as an insulator for propulsion parts in aerospace or missile systems. By controlling process parameters such as the heat treatment temperature of the cellulose particles and the amount of cellulose added,...
280.

Characterization and influence of shear flow on the surface resistivity and mixing condition on the dispersion quality of multi-walled carbon nanotube/polycarbonate nanocomposites

Young Sil Lee, Kwan Han Yoon 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 3 86-92 (7 pages)

Young Sil Lee, Kwan Han Yoon 저
...
- 3,000원
Multi-walled carbon nanotube (MWCNT)/polycarbonate (PC) nanocomposite was prepared by direct melt mixing to investigate the effect of the shear rate on the surface resistivity of the nanocomposites. In this study, an experiment was carried out to observe the shear induced orientation of the MWCNT in the polymer matrix using a very simple melt flow indexer with various loads. The compression-molded, should be eliminated. MWCNT/PC nanocomposite sample exhibited lower percolation thresholds (at 0.8...

한주간 이슈검색어