학지사 뉴논문

총 449건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

321.

Adsorption capability of activated carbon synthesized from coconut shell

Md Shariful Islam, Bee Chin Ang, Samira Gharehkhani, Amalina Binti, Muhammad Afifi 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 1 1-9 (9 pages)

Md Shariful Islam, Bee Chin Ang, Samira Gharehkhani, Amalina Binti, Muhammad Afifi 저
...
- 3,000원
Activated carbon was synthesized from coconut shells. The Brunauer, Emmett and Teller surface area of the synthesized activated carbon was found to be 1640 m2/g with a pore volume of 1.032 cm3/g. The average pore diameter of the activated carbon was found to be 2.52 nm. By applying the size-strain plot method to the X-ray diffraction data, the crystallite size and the crystal strain was determined to be 42.46 nm and 0.000489897, respectively, which indicate a perfect crystallite structure. The...
322.

The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 저
...
- 3,000원
Taguchi’s experimental design was employed in the melt spinning of molten mesophase pitch to produce carbon fibers. The textures of the obtained carbon fibers were radial with varied crack angles, as observed by scanning electron microscopy and polarized optical imaging. The diameter, crack angle, preferred orientation, and tensile modulus of the produced samples were examined to investigate the influence of four spinning variables. The relative importance of the variables has been emphasized...
323.

Pitch-based carbon fibers from coal tar or petroleum residue under the same processing condition

Jiyoung Kim, Ui-Su Im, Byungrok Lee, Dong-Hyun Peck, Seong-Ho Yoon, Doo-Hwan Jung 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 9 72-78 (7 pages)

Jiyoung Kim, Ui-Su Im, Byungrok Lee, Dong-Hyun Peck, Seong-Ho Yoon, Doo-Hwan Jung 저
...
- 3,000원
Spinnable pitches and carbon fibers were successfully prepared from petroleum or coal pyrolysis residues. After pyrolysis fuel oil (PFO), slurry oil, and coal tar were simply filtered to eliminate the solid impurities, the characteristics of the raw materials were evaluated by elemental analysis, 13C nuclear magnetic resonance spectrometer, matrix-assisted laser desorption/ionization time-of-flight mass spectrometer (MALDI-TOF-MS), and so on. Spinnable pitches were prepared for melt-spinning...
324.

Effect of fiber-matrix adhesion on the fracture behavior of a carbon fiber reinforced thermoplastic-modified epoxy matrix

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 6 47-56 (10 pages)

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 저
...
- 3,000원
In this study, the fracture behavior of a thermoplastic-modified epoxy resin reinforced with continuous carbon fibers for two levels of fiber-matrix adhesion was performed. A carbon fiber with commercial sizing was used and also treated with a known silane, (3-glycidoxy propyl trimethoxysilane) coupling agent. Toughness was determined using the double cantilever test, together with surface analysis after failure using scanning electron microscope. The presence of polysulfone particles improved...
325.

A review: synthesis and applications of graphene/chitosan nanocomposites

Hui Yuan, Long-Yue Meng, Soo-Jin Park 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 2 11-17 (7 pages)

Hui Yuan, Long-Yue Meng, Soo-Jin Park 저
...
- 3,000원
Recently, with continuous developments in the field of materials science, graphene oxide (GO) has emerged as a promising material with excellent electrical, thermal, mechanical, and optical properties, which play important roles in most fields. Researchers have achieved considerable progress with graphene. Chitosan (CS) is a natural polymer that has been studied intensively owing to its specific formation, high chemical resistance, and excellent physical properties. These outstanding properties...
326.

Microwave-assisted pretreatment technologies for the conversion of lignocellulosic biomass to sugars and ethanol: a review

Pradeep Puligundla, Sang-Eun Oh, Chulkyoon Mok 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 1 1-10 (10 pages)

Pradeep Puligundla, Sang-Eun Oh, Chulkyoon Mok 저
...
- 3,000원
Lignocellulosic biomass conversion to biofuels such as ethanol and other value-added bio-products including activated carbons has attracted much attention. The development of an efficient, cost-effective, and eco-friendly pretreatment process is a major challenge in lignocellulosic biomass to biofuel conversion. Although several modern pretreatment technologies have been introduced, few promising technologies have been reported. Microwave irradiation or microwave-assisted methods (physical and...
327.

Characterization and influence of shear flow on the surface resistivity and mixing condition on the dispersion quality of multi-walled carbon nanotube/polycarbonate nanocomposites

Young Sil Lee, Kwan Han Yoon 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 3 86-92 (7 pages)

Young Sil Lee, Kwan Han Yoon 저
...
- 3,000원
Multi-walled carbon nanotube (MWCNT)/polycarbonate (PC) nanocomposite was prepared by direct melt mixing to investigate the effect of the shear rate on the surface resistivity of the nanocomposites. In this study, an experiment was carried out to observe the shear induced orientation of the MWCNT in the polymer matrix using a very simple melt flow indexer with various loads. The compression-molded, should be eliminated. MWCNT/PC nanocomposite sample exhibited lower percolation thresholds (at 0.8...
328.

Influence of hot-pressing pressure on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 4 25-33 (9 pages)

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 저
...
- 3,000원
The prime objective of this research was to study the influence of hot-pressing pressure and matrix-to-reinforcement ratio on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon-composite. Secondary objectives included determination of the physical and mechanical properties of the resulting composite. The ‘hybrid carbon-fiberreinforced mesophase-pitch-derived carbon-matrix’ composite was fabricated by hot pressing. During hot pressing, pressure was varied from 5...
329.

An overview of new oxidation methods for polyacrylonitrile?based carbon fibers

Hye Kyoung Shin, Mira Park, Hak-Yong Kim and Soo-Jin Park 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 2 11-18 (8 pages)

Hye Kyoung Shin, Mira Park, Hak-Yong Kim and Soo-Jin Park 저
...
- 3,000원
in determining the mechanical properties of the final carbon fibers, but the most commonly used methods, such as thermal treatment (200°C to 300°C), tend to waste a great deal of process time, money, and energy. There is therefore a need to develop more advanced oxidation methods for PAN precursor fibers. In this review, we assess the viability of electron beam, gamma-ray, ultra-violet, and plasma treatments with a view to advancing these areas of research and their industrial application.
330.

Overlook of carbonaceous adsorbents and processing methods for elemental mercury removal

Kyong-Min Bae, Byung-Joo Kim and Soo-Jin Park 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 2 238-246 (9 pages)

Kyong-Min Bae, Byung-Joo Kim and Soo-Jin Park 저
...
- 3,000원
People have been concerned about mercury emissions for decades because of the extreme toxicity, persistence, and bioaccumulation of methyl Hg transformed from emitted Hg. This paper presents an overview of research related to mercury control technology and identifies areas requiring additional research and development. It critically reviews measured mercury emissions progress in the development of promising control technologies. This review provides useful information to scientists and engineers...

한주간 이슈검색어