학지사 뉴논문

총 644건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

401.

Hydrogen storage capacity of highly porous carbons synthesized from biomass-derived aerogels

Yong-Ki Choi, Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 9 127-131 (5 pages)

Yong-Ki Choi, Soo-Jin Park 저
...
- 1,500원
to enhance the specific surface area and microporosity. The micro-structural properties and morphologies were measured by X-ray diffraction and scanning electron microscopy, respectively. The specific surface area and microporosity were investigated by N2/77 K adsorption-desorption isotherms using the Brunauer-Emmett-Teller method and Barrett-Joyner-Halenda equation, respectively. Hydrogen storage capacity was dependent on the activation temperature. The highest capacity of 2.7 wt% at 77 K and 1...
402.

Stabilization of pitch-based carbon fibers accompanying electron beam irradiation and their mechanical properties

Mi-Seon Park, Yoonyoung Ko, Min-Jung Jung, Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 8 121-126 (6 pages)

Mi-Seon Park, Yoonyoung Ko, Min-Jung Jung, Young-Seak Lee 저
...
- 3,000원
Carbon fibers are prepared by stabilizing pitch fibers accompanying electron beam (E-beam) irradiation. The carbon fibers pretreated by E-beam irradiation achieve a higher stabilization index than the carbon fibers that are only heat-stabilized. In addition, the carbon fibers subjected to E-beam irradiation in the stabilization step exhibit a comparable tensile strength to that of general purpose carbon fibers. The carbon fibers pretreated with an absorbed dose of 3000 kGy have a tensile...
403.

Functionalization of graphene nanoplatelets using sugar azide for graphene/epoxy nanocomposites

Saswata Bose, Lawrence T. Drzal 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 5 101-106 (6 pages)

Saswata Bose, Lawrence T. Drzal 저
...
- 3,000원
We report a covalent functionalization of graphene nanoparticles (GnPs) employing 2,3,4-Tri-O-acetyl-β-D-xylopyranosyl azide followed by fabrication of an epoxy/functionalized graphene nanocomposite and an evaluation of its thermo-mechanical performance. Successful functionalization of GnP was confirmed via thermal and spectroscopic study. Raman spectroscopy indicated that the functionalization was on the edge of the graphene sheets; the basal plane was not perturbed as a result of the...
404.

Activated carbons prepared from mixtures of coal tar pitch and petroleum pitch and their electrochemical performance as electrode materials for electric double-layer capacitor

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 2 78-85 (8 pages)

Eunji Lee, Soon Hyung Kwon, Poo Reum Choi, Ji Chul Jung, Myung-Soo Kim 저
...
- 3,000원
Activated carbons (ACs) were prepared by activation of coal tar pitch (CTP) in the range of 700°C-1000°C for 1-4 h using potassium hydroxide (KOH) powder as the activation agent. The optimal activation conditions were determined to be a CTP/KOH ratio of 1:4, activation temperature of 900°C, and activation time of 3 h. The obtained ACs showed increased pore size distribution in the range of 1 to 2 nm and the highest specific capacitance of 122 F/g in a two-electrode system with an organic...
405.

Preparation and characterization of carbon fiber-reinforced thermosetting composites: a review

Fan-Long Jin, Soo-Jin Park 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 1 67-77 (11 pages)

Fan-Long Jin, Soo-Jin Park 저
...
- 4,000원
Carbon fibers (CFs) have a unique combination of properties which allow them to be widely used as reinforcing materials in advanced polymer composites. The mechanical properties of CF-reinforced polymer composites are governed mainly by the quality of interfacial adhesion between the CFs and the polymer matrix. Surface treatments of CFs are generally carried out to introduce chemical functional groups on the fiber surfaces, which provide the ability to control the surface characteristics of CFs....
406.

Influence of Nitrogen moieties on CO2 capture of Carbon Aerogel

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 9 57-61 (5 pages)

Da-Hee Jeon, Byung-Gak Min, Jong Gab Oh, Changwoon Nah and Soo-Jin Park 저
...
- 1,500원
a porous carbon material possessing high porosity and high specific surface area. Nitrogen doping reduced the specific surface area and micropores, but it furnished basic sites to improve the CO2 selectivity. In this work, N-doped carbon aerogels were prepared with different ratios of resorcinol/melamine by using the sol-gel method. The morphological properties were characterized by scanning electron microscopy (SEM). Nitrogen content was studied by X-ray photoelectron spectroscopy (XPS) and the...
407.

Effect of surface treatment of graphene nanoplatelets for improvement of thermal and electrical properties of epoxy composites

Minjae Kim, Yeongseon Kim, Sung Hyeon Baeck and Sang Eun Shim 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 5 34-40 (7 pages)

Minjae Kim, Yeongseon Kim, Sung Hyeon Baeck and Sang Eun Shim 저
...
- 3,000원
In this study, in order to improve the thermal and electrical properties of epoxy/graphene nanoplatelets (GNPs), surface modifications of GNPs are conducted using silane coupling agents. Three silane coupling agents, i.e. 2-(3,4-epoxycyclohexyl)-ethyltrimethoxysilane (ETMOS), 3-glycidoxypropyltriethoxysilane (GPTS), and 3-glycidoxypropyltrimethoxysilane (GPTMS), were used. Among theses, GPTMS exhibits the best modification performance for fabricating GNP-incorporated epoxy composites. The effect...
408.

A study on elemental mercury adsorption behaviors of nanoporous carbons with carbon dioxide activation

Kyong-Min Bae and Soo-Jin Park 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.4 10 295-298 (4 pages)

Kyong-Min Bae and Soo-Jin Park 저
...
- 1,500원
by the self-assembly of polymeric carbon precursors and block copolymer template in the presence of tetraethyl orthosilicate and colloidal silica. The NPCs’ pore structures and total pore volumes were analyzed by reference to N2/77 K adsorption isotherms. The porosity and elemental mercury adsorption of NPCs were increased by activation with carbon dioxide. It could be resulted that elemental mercury adsorption ability of NPCs depended on their specific surface area and micropore fraction.
409.

Excellent field emission properties from carbon nanotube field emitters fabricated using a filtration-taping method

Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 10 214-217 (4 pages)

Dong Hoon Shin, Seung Il Jung, Ki Nam Yun, Guohai Chen, Seok-Gy Jeon, Jung-Il Kim, Cheol Jin Lee 저
...
- 1,500원
good electrical contact, low temperature, organic-free, low cost, large size, and suitability for various CNT materials and substrates. These good features promise an advanced field emission performance with a turn-on field of 0.88 V/mm at a current density of 0.1 mA/cm2, a threshold field of 1.98 V/mm at a current density of 1 mA/cm2, and a good stability of over 20 h. The filtration-taping technique is an effective way to realize low-cost, large-size, and high-performance CNT emitters.
410.

Effect of microporosity on nitrogen-doped microporous carbons for electrode of supercapacitor

Eun-A Cho, Seul-Yi Lee, Soo-Jin Park 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 9 210-213 (4 pages)

Eun-A Cho, Seul-Yi Lee, Soo-Jin Park 저
...
- 1,500원
carbons were prepared using a polyvinylidene fluoride/melamine mixture. The electrochemical performance of the nitrogen-doped microporous carbons after being subjected to different carbonization conditions was investigated. The nitrogen to carbon ratio and specific surface area decreased with an increase in the carbonization temperature. However, the maximum specific capacitance of 208 F/g was obtained at a carbonization temperature of 800°C because it produced the highest microporosity.

한주간 이슈검색어