학지사 뉴논문

총 1,885건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

431.

Synthesis and characterization of carbon doped TiO₂ photocatalysts supported on stainless steel mesh by sol-gel method

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 한국탄소학회 Carbon Letters 12 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 6 48-59 (12 pages)

JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 저
...
- 4,100원
influence of the pyrolysis temperature and holding time on the morphological characteristics, particle sizes and surface area of the prepared catalyst was investigated. The prepared catalysts were characterized by several analytical methods: high resolution scanning electron microscopy (HRSEM), energy dispersive spectroscopy (EDS), X-ray diffraction (XRD), Brunauer-Emmett-Teller (BET), and X-ray photoelectron spectroscopy (XPS). The XRD patterns showed that the supported TiO₂ nanocrystals are...
432.

EMI shielding effectiveness and mechanical properties of MWCNTs-reinforced biodegradable epoxy matrix composites

Yoon-Ji Yim, Dong Chul Chung, Soo-Jin Park 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 4 36-41 (6 pages)

Yoon-Ji Yim, Dong Chul Chung, Soo-Jin Park 저
...
- 3,000원
and epoxidized linseed oil. The mechanical properties of B-epoxy composites reinforced with multi-walled carbon nanotubes (MWCNTs/B-epoxy) were examined by employing dynamic mechanical analysis, critical stress intensity factor (KIC) tests, and impact strength tests. The electromagnetic interference shielding effectiveness (EMI-SE) of the composites was evaluated using reflection and absorption methods. Mechanical properties of MWCNTs/B-epoxy were enhanced with an increase in the MWCNT content,...
433.

Thermo-electrical properties of randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, N. Supriya 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 3 25-35 (11 pages)

Thakur Sudesh Kumar Raunija, N. Supriya 저
...
- 4,000원
was fabricated by combining the high-pressure hot-pressing (HP) method with the lowpressure impregnation thermosetting carbonization (ITC) method. After the ITC method step selected samples were graphitized at 3000°C. Detailed characterization of the samples’ physical properties and thermal properties, including thermal diffusivity, thermal conductivity, specific heat and coefficient of thermal expansion, was carried out. Additionally, direct current (DC) electrical conductivity in both the...
434.

Kinetic and multi-parameter isotherm studies of picric acid removal from aqueous solutions by carboxylated multi-walled carbon nanotubes in the presence and absence of ultrasound

Soheila Gholitabar, Hasan Tahermansouri 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 2 14-24 (11 pages)

Soheila Gholitabar, Hasan Tahermansouri 저
...
- 4,000원
adsorption isotherms of picric acid from aqueous solutions on the MWCNTs were investigated using six two-parameter models (Langmuir, Freundlich, Tempkin, Halsey, Harkins-Jura, Fowler- Guggenheim), four three-parameter models (Redlich-Peterson, Khan, Radke-Prausnitz, and Toth), two four-parameter equations (Fritz-Schlunder and Baudu) and one five-parameter equation (Fritz-Schlunder). Three error analysis methods, correlation coefficient, chi-square test and average relative errors, were applied...
435.

Disorientation angle influence on the thermal residual stresses in carbon multilayered composite plates of different thicknesses

Olga Bitkina, Ki-Weon Kang, Jang-Ho Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 13 98-102 (5 pages)

Olga Bitkina, Ki-Weon Kang, Jang-Ho Lee 저
...
- 1,500원
(generated during the manufacturing process) and operating (generated during the working period) stages. A thorough investigation of the initial stage of the stress-strain state is very important to finding the total stresses and deformations, and determining the correct destruction time of composite structures, and preventing their destruction. Otherwise, if the initial stresses and deformations are not taken into account, the structures may be destroyed long before their expected service life.
436.

Removal of chromium from tannery wastewater by electrosorption on carbon prepared from peach stones: effect of applied potential

Mounir Ziati, Fariza Khemmari, Mohamed Kecir, Sabir Hazourli 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 10 81-85 (5 pages)

Mounir Ziati, Fariza Khemmari, Mohamed Kecir, Sabir Hazourli 저
...
- 1,500원
at 900°C. The characterization of the carbon material resulted in properties comparable to those of many coals industrially manufactured. The study of the dynamic adsorption of chromium on the obtained material resulted in a low removal rate (33.7%) without applied potential. The application of negative potentials of -0.7 V and -1.4 increases the adsorption of chromium up to 90% and 96% respectively. Whereas a positive potential of +1.4V allows desorption of the contaminant of 138%.
437.

A facile green reduction of graphene oxide using Annona squamosa leaf extract

Basavaiah Chandu, Venkata Sai Sriram Mosali, Bhanu Mullamuri, Hari Babu Bollikolla 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 9 74-80 (7 pages)

Basavaiah Chandu, Venkata Sai Sriram Mosali, Bhanu Mullamuri, Hari Babu Bollikolla 저
...
- 3,000원
ultraviolet-visible (UV-Vis), X-ray photoelectron spectroscopy (XPS) and Raman spectroscopic techniques. Removal of oxygen containing moieties from the GO was confirmed by UV-Vis, FT-IR and XPS spectroscopic data. The XRD and Raman data further confirmed the formation of the CRG. TEM images showed the sheet structure of the synthesized CRG. These results show that the phytochemicals present in custard apple leaf extract act as excellent reducing agents. The CRG showed good dispersion in water.
438.

Study of complex electrodeposited thin film with multi-layer graphene-coated metal nanoparticles

Young-Lae Cho, Jung-woo Lee, Chan Park, Young-il Song, Su-Jeong Suh 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 8 68-73 (6 pages)

Young-Lae Cho, Jung-woo Lee, Chan Park, Young-il Song, Su-Jeong Suh 저
...
- 3,000원
The resistivity of the bare-electrodeposited copper thin film (BETF) was 2.092 × 10?6 Ω·cm, and the resistivity of the CETF after the addition of 300 ppm MGCNs was decreased by 2% to ~2.049 × 10?6 Ω·cm. The corrosion resistance of the BETF was 9.306 Ω, while that of the CETF was increased to 20.04 Ω. Therefore, the CETF with MGCNs can be used in interconnection circuits for printed circuit boards or semiconductor devices on the basis of its low resistivity and high corrosion resistance.
439.

Effect of carbonization temperature on crystalline structure and properties of isotropic pitch-based carbon fiber

Jung Dam Kim, Jae-Seung Roh, Myung-Soo Kim 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 6 51-60 (10 pages)

Jung Dam Kim, Jae-Seung Roh, Myung-Soo Kim 저
...
- 3,000원
in the d002 spacing and stacking height of the crystallite (Lc) showed that the structural order perpendicular to the graphene planes got worse in carbonization temperatures from 800 to 1200oC probably due to randomization through the process of gas evolution; however, structural ordering eventually occurred at around 1400oC. For the carbonized pitch powder without stabilization, structural ordering perpendicular to the graphene planes occurred at around 800?900oC indicating that oxygen was...
440.

The impact fracture behaviors of CFRP/EVA composites by drop-weight impact test

Sun-Ho Go, Hong-Gun Kim, Hee-Jae Shin, Min-Sang Lee, Hyun-Gyung Yoon, Lee-Ku Kwac 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 4 23-32 (10 pages)

Sun-Ho Go, Hong-Gun Kim, Hee-Jae Shin, Min-Sang Lee, Hyun-Gyung Yoon, Lee-Ku Kwac 저
...
- 3,000원
of Type 3 through Type 5, in which the role of the EVA sheet is more prominent because it absorbs the impact energy rather than dispersing it, a clear form of puncture failure mode was observed. Based on the above results, it was found that all the observation values decreased as the EVA lamination increased compared with the CFRP lamination. The EVA lamination was thus found to have a very important role in reducing the impact. However, the strain and temperature were inversely propositional.

한주간 이슈검색어