학지사 뉴논문

총 1,166건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

461.

Effects of heat treatment time on aromatic yield of pyrolysis fuel oil-derived pitches

Hye Kyoung Shin, Min-Kang Seo, Yun Hyuk Bang, Soo-Jin Park 한국탄소학회 Carbon Letters 3 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 13 104-106 (3 pages)

Hye Kyoung Shin, Min-Kang Seo, Yun Hyuk Bang, Soo-Jin Park 저
...
- 1,500원
462.

The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 저
...
- 3,000원
Taguchi’s experimental design was employed in the melt spinning of molten mesophase pitch to produce carbon fibers. The textures of the obtained carbon fibers were radial with varied crack angles, as observed by scanning electron microscopy and polarized optical imaging. The diameter, crack angle, preferred orientation, and tensile modulus of the produced samples were examined to investigate the influence of four spinning variables. The relative importance of the variables has been emphasized...
463.

Pitch-based carbon fibers from coal tar or petroleum residue under the same processing condition

Jiyoung Kim, Ui-Su Im, Byungrok Lee, Dong-Hyun Peck, Seong-Ho Yoon, Doo-Hwan Jung 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 9 72-78 (7 pages)

Jiyoung Kim, Ui-Su Im, Byungrok Lee, Dong-Hyun Peck, Seong-Ho Yoon, Doo-Hwan Jung 저
...
- 3,000원
Spinnable pitches and carbon fibers were successfully prepared from petroleum or coal pyrolysis residues. After pyrolysis fuel oil (PFO), slurry oil, and coal tar were simply filtered to eliminate the solid impurities, the characteristics of the raw materials were evaluated by elemental analysis, 13C nuclear magnetic resonance spectrometer, matrix-assisted laser desorption/ionization time-of-flight mass spectrometer (MALDI-TOF-MS), and so on. Spinnable pitches were prepared for melt-spinning...
464.

Phenylethynyl-terminated polyimide, exfoliated graphite nanoplatelets, and the composites: an overview

Donghwan Cho, Lawrence T. Drzal 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 1 1-11 (11 pages)

Donghwan Cho, Lawrence T. Drzal 저
...
- 4,000원
In efforts to characterize and understand the properties and processing of phenylethynyl-terminated imide (LaRC PETI-5, simply referred to as PETI-5) oligomers and polymers as a high-temperature sizing material for carbon fiber-reinforced polymer matrix composites, PETI-5 imidization and thermal curing behaviors have been extensively investigated based on the phenylethynyl end-group reaction. These studies are reviewed here. In addition, the use of PETI-5 to enhance interfacial adhesion between...
465.

Microstructural changes of polyacrylonitrile-based carbon fibers (T300 and T700) due to isothermal oxidation (1): focusing on morphological changes using scanning electron microscopy

Seong-Moon Oh, Sang-Min Lee, Dong-Su Kang, Jae-Seung Roh 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 3 18-23 (6 pages)

Seong-Moon Oh, Sang-Min Lee, Dong-Su Kang, Jae-Seung Roh 저
...
- 3,000원
Polyacrylonitrile (PAN)-based carbon fibers have high specific strength, elastic modulus, thermal resistance, and thermal conductivity. Due to these properties, they have been increasingly widely used in various spheres including leisure, aviation, aerospace, military, and energy applications. However, if exposed to air at high temperatures, they are oxidized, thus weakening the properties of carbon fibers and carbon composite materials. As such, it is important to understand the oxidation...
466.

Mechanical interfacial adhesion of carbon fibers-reinforced polarized-polypropylene matrix composites: effects of silane coupling agents

Woong-Ki Choi, Hyun-Il Kim, Shin-Jae Kang, Young Sil Lee, Jong Hun Han, Byung-Joo Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 12 79-84 (6 pages)

Woong-Ki Choi, Hyun-Il Kim, Shin-Jae Kang, Young Sil Lee, Jong Hun Han, Byung-Joo Kim 저
...
- 3,000원
467.

Effects of an inorganic ammonium salt treatment on the flame-retardant performance of lyocell fibers

Hyeong Gi Kim, Byong Chol Bai, Se Jin In, Young-Seak Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 11 74-78 (5 pages)

Hyeong Gi Kim, Byong Chol Bai, Se Jin In, Young-Seak Lee 저
...
- 1,500원
468.

Ion conducting properties of imidazolium salts with tri-alkyl chains in organic electrolytes against activated carbon electrodes

Kyungmin Kim, Soo-Jin Park, Ji Sun Im, Chul Wee Lee, Yongju Jung, Seok Kim 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 10 70-73 (4 pages)

Kyungmin Kim, Soo-Jin Park, Ji Sun Im, Chul Wee Lee, Yongju Jung, Seok Kim 저
...
- 1,500원
469.

Influence of laminated orientation on the mechanical and thermal characteristics of carbon-fiber reinforced plastics

Hee-Jae Shin, Lee-Ku Kwac, Min-Sang Lee, Hong-Gun Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.4 3 241-246 (6 pages)

Hee-Jae Shin, Lee-Ku Kwac, Min-Sang Lee, Hong-Gun Kim 저
...
- 3,000원
Rapid industrial development in recent times has increased the demand for light-weight materials with high strength and structural integrity. In this context, carbon fiber-reinforced plastic (CFRP) composite materials are being extensively used. However, laminated CFRPs develop faults during impact because CFRPs are composed of mixed carbon fiber and epoxy. Moreover, their fracturing behavior is very complicated and difficult to interpret. In this paper, the effect of the direction of lamination...
470.

Advances in liquid crystalline nano-carbon materials: preparation of nano-carbon based lyotropic liquid crystal and their fabrication of nano-carbon fibers with liquid crystalline spinning

Yong-Mun Choi, in Jung Jun Yeon, Hwang Seung Min, Kim Hyeonsu Jeong, Bon-Cheol Ku, Munju Goh 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.4 1 223-232 (10 pages)

Yong-Mun Choi, in Jung Jun Yeon, Hwang Seung Min, Kim Hyeonsu Jeong, Bon-Cheol Ku, Munju Goh 저
...
- 3,000원
This review presents current progress in the preparation methods of liquid crystalline nanocarbon materials and the liquid crystalline spinning method for producing nano-carbon fibers. In particular, we focus on the fabrication of liquid crystalline carbon nanotubes by spinning from superacids, and the continuous production of macroscopic fiber from liquid crystalline graphene oxide.

한주간 이슈검색어