학지사 뉴논문

총 540건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

491.

High-performance asymmetric supercapacitors based on polyoxometalate-graphene nanohybrids

MinHo Yang, Bong Gill Choi 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 15 84-89 (6 pages)

MinHo Yang, Bong Gill Choi 저
...
- 3,000원
492.

Cellulose-based carbon fibers prepared using electron-beam stabilization

Min Il Kim, Mi-Seon Park, Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 9 56-61 (6 pages)

Min Il Kim, Mi-Seon Park, Young-Seak Lee 저
...
- 3,000원
Cellulose fibers were stabilized by treatment with an electron-beam (E-beam). The properties of the stabilized fibers were analyzed by scanning electron microscopy, Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, and thermogravimetric analysis. The E-beam-stabilized cellulose fibers were carbonized in N₂ gas at 800°C for 1 h, and their carbonization yields were measured. The structure of the cellulose fibers was determined to have changed to hemicellulose and...
493.

The effects of stacking sequence on the penetration-resistant behaviors of T800 carbon fiber composite plates under low-velocity impact loading

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 6 107-115 (9 pages)

Furqan Ahmad, Jung-Wuk Hong, Heung Soap Choi, Soo-Jin Park, Myung Kyun Park 저
...
- 3,000원
Impact damages induced by a low-velocity impact load on carbon fiber reinforced polymer (CFRP) composite plates fabricated with various stacking sequences were studied experimentally. The impact responses of the CFRP composite plates were significantly affected by the laminate stacking sequences. Three types of specimens, specifically quasi-isotropic, unidirectional, and cross-ply, were tested by a constant impact carrying the same impact energy level. An impact load of 3.44 kg, corresponding to...
494.

Preparation and characterization of carbon fiber-reinforced thermosetting composites: a review

Fan-Long Jin, Soo-Jin Park 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.2 1 67-77 (11 pages)

Fan-Long Jin, Soo-Jin Park 저
...
- 4,000원
Carbon fibers (CFs) have a unique combination of properties which allow them to be widely used as reinforcing materials in advanced polymer composites. The mechanical properties of CF-reinforced polymer composites are governed mainly by the quality of interfacial adhesion between the CFs and the polymer matrix. Surface treatments of CFs are generally carried out to introduce chemical functional groups on the fiber surfaces, which provide the ability to control the surface characteristics of CFs....
495.

Influence of hot-pressing pressure on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2015, Vol.16 No.1 4 25-33 (9 pages)

Thakur Sudesh Kumar Raunija and Sharad Chandra Sharma 저
...
- 3,000원
The prime objective of this research was to study the influence of hot-pressing pressure and matrix-to-reinforcement ratio on the densification of short-carbon-fiber-reinforced, randomly oriented carbon/carbon-composite. Secondary objectives included determination of the physical and mechanical properties of the resulting composite. The ‘hybrid carbon-fiberreinforced mesophase-pitch-derived carbon-matrix’ composite was fabricated by hot pressing. During hot pressing, pressure was varied from 5...
496.

Study on lowering the percolation threshold of carbon nanotube-filled conductive polypropylene composites

Seung Bin Park, Moo Sung Lee, Min Park 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 8 117-124 (8 pages)

Seung Bin Park, Moo Sung Lee, Min Park 저
...
- 3,000원
Conductive polymer composites (CPCs) consist of a polymeric matrix and a conductive filler, for example, carbon black, carbon fibers, graphite or carbon nanotubes (CNTs). The critical amount of the electrically conductive filler necessary to build up a continuous conductive network, and accordingly, to make the material conductive; is referred to as the percolation threshold. From technical and economical viewpoints, it is desirable to decrease the conductive- filler percolation-threshold as...
497.

Study on electrochemical performances of sulfur-containing graphene nanosheets electrodes for lithium-sulfur cells

Ki-Soo Son, Seok Kim 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 7 113-116 (4 pages)

Ki-Soo Son, Seok Kim 저
...
- 1,500원
Due to their morphology, electrochemical stability, and function as a conducting carbon matrix, graphene nanosheets (GNS) have been studied for their potential roles in improving the performance of sulfur cathodes. In this study, a GNS/sulfur (GNS/S) composite was prepared using the infiltration method with organic solvent. The structure, morphology and crystallinity of the composites were examined using scanning electron microscopy, transmission electron microscopy, and X-ray diffraction. The...
498.

Fiber surface and electrical conductivity of electroless Ni-plated PET ultra-fine fibers

Woong-Ki Choi, Byung-Joo Kim, Soo-Jin Park 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2013, Vol.14 No.4 7 243-246 (4 pages)

Woong-Ki Choi, Byung-Joo Kim, Soo-Jin Park 저
...
- 1,500원
499.

Carbon nanofiber-reinforced polymeric nanocomposites

Changwoon Jang, John Hutchins, Jaesang Yu 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2013, Vol.14 No.4 1 197-205 (9 pages)

Changwoon Jang, John Hutchins, Jaesang Yu 저
...
- 3,000원
500.

A study on the fracture toughness of seawater-absorbed carbon nanotube/epoxy/basalt composites

Man Tae Kim, Kyong Yop Rhee, Hyun Ju Kim, Dong Ho Jung 한국탄소학회 Carbon Letters 3 Pages

한국탄소학회 Carbon Letters 2013, Vol.14 No.3 9 190-192 (3 pages)

Man Tae Kim, Kyong Yop Rhee, Hyun Ju Kim, Dong Ho Jung 저
- 1,500원

한주간 이슈검색어