학지사 뉴논문

총 784건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

501.

The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 저
...
- 3,000원
Taguchi’s experimental design was employed in the melt spinning of molten mesophase pitch to produce carbon fibers. The textures of the obtained carbon fibers were radial with varied crack angles, as observed by scanning electron microscopy and polarized optical imaging. The diameter, crack angle, preferred orientation, and tensile modulus of the produced samples were examined to investigate the influence of four spinning variables. The relative importance of the variables has been emphasized...
502.

Yield enhancement of matrix precursor in short carbon fiber reinforced randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 7 57-65 (9 pages)

Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 저
...
- 3,000원
Isroaniso matrix precursor synthesized from commercially available petroleum pitch was stabilized in air. The influence of oxygen mass gain during stabilization on the yield of matrix precursor was studied. Additionally, the influence of pressure on the yield of the stabilized matrix precursor in a real system was studied. The fourier transform infrared spectrometry (FTIR), thermogravimetric analysis (TGA), yield, yield rate, and yield impact were used to check the effect of stabilization and...
503.

Effect of fiber-matrix adhesion on the fracture behavior of a carbon fiber reinforced thermoplastic-modified epoxy matrix

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 6 47-56 (10 pages)

H.J. Carrillo-Escalante, A. ?lvarez-Castillo, A. Valadez-Gonz?lez, P. J. Herrera-Franco 저
...
- 3,000원
In this study, the fracture behavior of a thermoplastic-modified epoxy resin reinforced with continuous carbon fibers for two levels of fiber-matrix adhesion was performed. A carbon fiber with commercial sizing was used and also treated with a known silane, (3-glycidoxy propyl trimethoxysilane) coupling agent. Toughness was determined using the double cantilever test, together with surface analysis after failure using scanning electron microscope. The presence of polysulfone particles improved...
504.

Study on urea precursor effect on the electroactivities of nitrogen-doped graphene nanosheets electrodes for lithium cells

Ki-Yong Kim, Yongju Jung, Seok Kim 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 5 40-46 (7 pages)

Ki-Yong Kim, Yongju Jung, Seok Kim 저
...
- 3,000원
Nitrogen-atom doped graphene oxide was considered to prevent the dissolution of polysulfide and to guarantee the enhanced redox reaction of sulfur for good cycle performance of lithium sulfur cells. In this study, we used urea as a nitrogen source due to its low cost and easy preparation. To find the optimum urea content, we tested three different ratios of urea to graphene oxide. The morphology of the composites was examined by field emission scanning electron microscope. Functional groups and...
505.

Effects of electrochemical oxidation of carbon fibers on interfacial shear strength using a micro-bond method

Dong-Kyu Kim, Kay-Hyeok An, Yun Hyuk Bang, Lee-Ku Kwac, Sang-Yub Oh, Byung-Joo Kim 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 4 32-39 (8 pages)

Dong-Kyu Kim, Kay-Hyeok An, Yun Hyuk Bang, Lee-Ku Kwac, Sang-Yub Oh, Byung-Joo Kim 저
...
- 3,000원
In this work, we studied the effects of electrochemical oxidation treatments of carbon fibers (CFs) on interfacial adhesion between CF and epoxy resin with various current densities. The surface morphologies and properties of the CFs before and after electrochemical-oxidation-treatment were characterized using field emission scanning electron microscopy, atomic force microscopy, Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, and single-fiber contact angle. The...
506.

Carbon rich fly ash and their nanostructures

Numan Salah, Sami S. Habib, Zishan H. Khan, Ahmed Alshahrie, Adnan Memic, Attieh A. Al-ghamdi 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 3 23-31 (9 pages)

Numan Salah, Sami S. Habib, Zishan H. Khan, Ahmed Alshahrie, Adnan Memic, Attieh A. Al-ghamdi 저
...
- 3,000원
precursor and catalyst for carbon nanotube growth. This fly ash powder is mostly composed of pure carbon, predominantly present as sp2. In this work, the effect of sonication time on the morphology and structural properties of carbon rich fly ash particles is reported. The obtained results show that ultrasound treatment is an effective tool for producing ultrafine particles/fragments with higher porosity, which might be suitable for the adsorption of gasses. Moreover, carbon nanoparticles (CNPs)...
507.

Investigation of carbon dioxide adsorption by nitrogen-doped carbons synthesized from cubic MCM-48 mesoporous silica

Young-Jung Heo, Minh-Uyen T. Le, Soo-Jin Park 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 10 62-66 (5 pages)

Young-Jung Heo, Minh-Uyen T. Le, Soo-Jin Park 저
...
- 1,500원
508.

Monolithic porous carbon materials prepared from polyurethane foam templates

Jo?o Pires, Andr? Janeiro, Filipe J. Oliveira, Alexandre C. Bastos, Mois?s L. Pinto 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2016, Vol.18 2 11-17 (7 pages)

Jo?o Pires, Andr? Janeiro, Filipe J. Oliveira, Alexandre C. Bastos, Mois?s L. Pinto 저
...
- 3,000원
Monolithic carbon foams with hierarchical porosity were prepared from polyurethane templates and resol precursors. Mesoporosity was achieved through the use of soft templating with surfactant Pluronic F127, and macroporosity from the polyurethane foams was retained. Conditions to obtain high porosity materials were optimized. The best materials have high specific surface areas (380 and 582 m2 g?1, respectively) and high electrical conductivity, which make them good candidates for supports in...
509.

Effects of an inorganic ammonium salt treatment on the flame-retardant performance of lyocell fibers

Hyeong Gi Kim, Byong Chol Bai, Se Jin In, Young-Seak Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 11 74-78 (5 pages)

Hyeong Gi Kim, Byong Chol Bai, Se Jin In, Young-Seak Lee 저
...
- 1,500원
510.

Synthesis, characterization, and toxicity of multi-walled carbon nanotubes functionalized with 4-hydroxyquinazoline

Hasan Tahermansouri, Atieh Mirosanloo, Saeed Heidari Keshel, Mossa Gardaneh 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 7 45-52 (8 pages)

Hasan Tahermansouri, Atieh Mirosanloo, Saeed Heidari Keshel, Mossa Gardaneh 저
...
- 3,000원
Fourier transform infrared spectroscopy, Raman spectroscopy, scanning electron microscopy, thermogravimetric analysis, derivative thermogravimetric, steady-state fluorescence spectroscopy, and solubility testing. MWCNT-quin showed photo-electronic properties, which is due to the attachment of the 4-hydroxyquinazoline groups to them as proved by steady-state fluorescence spectroscopy. This suggests intramolecular interactions between the tubes and the attached 4-hydroxyquinazoline. The toxicity...

한주간 이슈검색어