자료유형
발행기관
- 한국탄소학회(69)
- 한국식물병리학회(14)
- 대한생리학회-대한약리학회(13)
- 인문사회과학기술융합학회(8)
- 대한수의학회(5)
- 물리치료재활과학회(4)
- 경인교육대학교 교육연구원(3)
- 대한치과이식임플란트학회(2)
- 이화여자대학교 교과교육연구소(2)
- 한국교육학회(2)
- 한국항행학회(2)
- 대한약리학회(1)
- 대한조선학회(1)
- 대한치과교정학회(1)
- 한국교육방법학회(1)
- 한국교육행정학회(1)
- 한국구비문학회(1)
- 한국기업교육학회(1)
- 한국노년학연구회(1)
- 한국박물관학회(1)
- 한국습지학회(1)
- 한국음악교육학회(1)
- 한국조형교육학회(1)
- 한국종교교육학회(1)
- 한국청각언어재활학회(1)
- 한국통신학회(1)
- 한국헬스커뮤니케이션학회(1)
- 환태평양유아교육연구학회(1)
간행물
- CARBON LETTERS(69)
- THE KOREAN JOURNAL OF PHYSIOLOGY & PHARMACOLOGY(13)
- THE PLANT PATHOLOGY JOURNAL (10)
- 예술인문사회융합멀티미디어논문지(8)
- JOURNAL OF VETERINARY SCIENCE(5)
- PHYSICAL THERAPY REHABILITATION SCIENCE(4)
- 식물병연구(4)
- THE JOURNAL OF EDUCATION(3)
- JOURNAL OF DENTAL IMPLANT RESEARCH(2)
- 교과교육학연구(2)
- 한국항행학회논문지(2)
- ASIA-PACIFIC JOURNAL OF RESEARCH IN EARLY CHILDHOOD EDUCATION(1)
- AUDIOLOGY AND SPEECH RESEARCH(1)
- THE KOREAN JOURNAL OF ORTHODONTICS(1)
- 교육방법연구(1)
- 교육학연구(1)
- 교육행정학연구(1)
- 구비문학연구(1)
- 기업교육과 인재연구(1)
- 대한약리학잡지(1)
- 대한조선학회지(1)
- 박물관학보(1)
- 음악교육연구(1)
- 정보통신 : 한국통신학회지(1)
- 조형교육(1)
- 종교교육학연구(1)
- 한국교육학회 학술대회논문집(1)
- 한국노년학연구(1)
- 한국습지학회지(1)
- 헬스커뮤니케이션연구(1)
-
Dispersions of partially reduced graphene oxide in various organic solvents and polymers
Hye Min Kim, Seo Gyun Kim, Heon Sang Lee 한국탄소학회 Carbon Letters 8 Pages
한국탄소학회 Carbon Letters 2017, Vol.23 8 55-62 (8 pages)
We report on the dispersion state of partially reduced graphene oxide (PRGO) in organic solvents, namely methyl ethyl ketone, ethyl acetate, methylene chloride, toluene, and xylene, by controlling the carbon to oxygen (C/O) atomic ratio of the PRGOs. A two-phase solvent exchange method is also proposed to transfer PRGO from water to an aprotic solvent, such as methyl ethyl ketone. We achieve relatively good dispersion in aprotic and non-polar solvents by controlling the C/O atomic ratio of the... -
Adsorption of Nile Blue A from aqueous solution by different nanostructured carbon adsorbents
Shahryar Abbasi, Hadi Noorizadeh 한국탄소학회 Carbon Letters 8 Pages
한국탄소학회 Carbon Letters 2017, Vol.23 5 30-37 (8 pages)
Dyes are widely used in various industries including textile, cosmetic, paper, plastics, rubber, and coating, and their discharge into waterways causes serious environmental and health problems. Four different carbon nanostructures, graphene oxide, oxidized multi-walled carbon nanotubes, activated carbon and multi-walled carbon nanotubes, were used as adsorbents for the removal of Nile Blue A (NBA) dye from aqueous solution. The four carbon nanostructures were characterized by scanning electron... -
Hole quality assessment of drilled CFRP and CFRP-Ti stacks holes using polycrystalline diamond (PCD) tools
Dave Kim, Aaron Beal, Kiweon Kang, Sang-Young Kim 한국탄소학회 Carbon Letters 8 Pages
한국탄소학회 Carbon Letters 2017, Vol.23 1 1-8 (8 pages)
Polycrystalline diamond (PCD) tools possessing high hardness and abrasive wear resistance are particularly suited for drilling of carbon fiber reinforced plastic (CFRP) composites, where tool life and consistent hole quality are important. While PCD presents superior performance when drilling CFRP, it is unclear how it performs when drilling multi-stack materials such as CFRP-titanium (Ti) stacks. This comparative study aims to investigate drilling of a Ti plate stacked on a CFRP panel when... -
Adsorption characteristics of heavy metals ions by physical activation on coal tar pitch-based activated carbon fibers
Bo-kyung Choi, Jae-Kyoung Ko, Soo-Jin Park, Min-Kang Seo 한국탄소학회 Carbon Letters 5 Pages
한국탄소학회 Carbon Letters 2017, Vol.22 10 96-100 (5 pages)
Due to the increasing population growth of modern society, along with rapid industrial development and urbanization, environmental pollution continues to worsen and has become an important issue, not only domestically but also worldwide. In particular, toxic substances such as heavy metal ions are present in the wastewater produced by various industries. This wastewater flows into rivers, pollutes water supplies, and can contaminate the drinking water supplied to people [1-3]. Powder or... -
High-energy-density activated carbon electrode for organic electric-double-layer-capacitor using carbonized petroleum pitch
Poo Reum Choi, Sang-Gil Kim, Ji Chul Jung, Myung-Soo Kim 한국탄소학회 Carbon Letters 11 Pages
한국탄소학회 Carbon Letters 2017, Vol.22 8 70-80 (11 pages)
Activated carbons (ACs) have been used as electrode materials of electric double-layer capacitors (EDLC) due to their high specific surface areas (SSA), stability, and ecological advantages. In order to make high-energy-density ACs for EDLC, petroleum pitch (PP) precarbonized at 500?1000°C in N2 gas for 1 h was used as the electrode material of the EDLC after KOH activation. As the pre-carbonization temperature increased, the SSA, pore volume and gravimetric capacitance tended to decrease, but... -
Synthesis and characterization of carbon doped TiO₂ photocatalysts supported on stainless steel mesh by sol-gel method
JO. Tijani, OO. Fatoba, TC. Totito, WD. Roos, LF. Petrik 한국탄소학회 Carbon Letters 12 Pages
한국탄소학회 Carbon Letters 2017, Vol.22 6 48-59 (12 pages)
This study synthesized pure anatase carbon doped TiO₂ photocatalysts supported on a stainless steel mesh using a sol-gel solution of 8% polyacrylonitrile (PAN)/dimethylformamide (DMF)/TiCl₄. The influence of the pyrolysis temperature and holding time on the morphological characteristics, particle sizes and surface area of the prepared catalyst was investigated. The prepared catalysts were characterized by several analytical methods: high resolution scanning electron microscopy (HRSEM), energy... -
Thermo-electrical properties of randomly oriented carbon/carbon composite
Thakur Sudesh Kumar Raunija, N. Supriya 한국탄소학회 Carbon Letters 11 Pages
한국탄소학회 Carbon Letters 2017, Vol.22 3 25-35 (11 pages)
The aim of the work was to investigate the thermo-electrical properties of low cost and rapidly produced randomly oriented carbon/carbon (C/C) composite. The composite body was fabricated by combining the high-pressure hot-pressing (HP) method with the lowpressure impregnation thermosetting carbonization (ITC) method. After the ITC method step selected samples were graphitized at 3000°C. Detailed characterization of the samples’ physical properties and thermal properties, including thermal... -
Formation of nanojoints between carbon nanotubes and copper nanoparticles
Jagjiwan Mittal, Kwang Lung Lin 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2017, Vol.21 11 86-92 (7 pages)
Exceptional properties and a one dimensional structure make carbon nanotubes (CNTs) a promising candidate for future applications in the electronic industry [1-3]. Because of their smaller dimensions and higher conductivity as compared to copper, multi-walled carbon nanotubes (MWCNT) may increase the bandwidth density of global interconnects [4]. They demonstrate charge carrier mean free paths between 500 nm and 10 μm as compared to 40 nm in metals. CNTs can carry exceptionally high current... -
Improving dispersion of multi-walled carbon nanotubes and graphene using a common non-covalent modifier
Youbin Kwon, Wonbo Shim, Seung-Yeol Jeon, Ji-Ho Youk, Woong-Ryeol Yu 한국탄소학회 Carbon Letters 9 Pages
한국탄소학회 Carbon Letters 2016, Vol.20 8 53-61 (9 pages)
The reportedly synergistic effects of carbon nanotubes (CNTs) and graphene hybrids have prompted strong demand for an efficient modifier to enhance their dispersion. Here, we investigated the ability of poly(acrylonitrile) (PAN) to overcome the van der Waals interaction of multi-walled CNTs (MWCNTs) and graphene by employing a simple wrapping process involving ultrasonication and subsequent centrifugation of PAN/MWCNT/graphene solutions. The physical wrapping of MWCNTs and graphene with PAN was... -
Adsorption capability of activated carbon synthesized from coconut shell
Md Shariful Islam, Bee Chin Ang, Samira Gharehkhani, Amalina Binti, Muhammad Afifi 한국탄소학회 Carbon Letters 9 Pages
한국탄소학회 Carbon Letters 2016, Vol.20 1 1-9 (9 pages)
Activated carbon was synthesized from coconut shells. The Brunauer, Emmett and Teller surface area of the synthesized activated carbon was found to be 1640 m2/g with a pore volume of 1.032 cm3/g. The average pore diameter of the activated carbon was found to be 2.52 nm. By applying the size-strain plot method to the X-ray diffraction data, the crystallite size and the crystal strain was determined to be 42.46 nm and 0.000489897, respectively, which indicate a perfect crystallite structure. The...


전체 선택해제

총


