학지사 뉴논문

총 7,334건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

701.

Overlook of current chemical vapor deposition-grown large single-crystal graphene domains

Kyung Tae Park, Taehoon Kim, Chong Rae Park 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.3 1 151-161 (11 pages)

Kyung Tae Park, Taehoon Kim, Chong Rae Park 저
...
- 4,000원
Not only has good monolayer growth of graphene been achieved, but large-area synthesis of graphene sheets has been successful too. However, the polycrystalline nature of CVD graphene is hampering further progress as graphene property degrades due to presence of grain boundaries. This review will cover factors that affect nucleation of graphene and how other scientists sought to obtain large graphene domains. In addition, the limitation of the current research trend will be touched upon as well.
702.

Facile preparation of self-assembled wool-based graphene hydrogels by electron beam irradiation

Mira Park, Bishweshwar Pant, Jawun Choi, Yong Wan Park, Chohye Lee, Hye Kyoung Shin, Soo-Jin Park4, Hak-Yong Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 11 136-141 (6 pages)

Mira Park, Bishweshwar Pant, Jawun Choi, Yong Wan Park, Chohye Lee, Hye Kyoung Shin, Soo-Jin Park4, Hak-Yong Kim 저
...
- 3,000원
gel strength, kinetics-of-swelling analyses and removal of hexavalent chromium (Cr(VI)) from the aqueous solution. X-ray diffraction results confirmed that EBI played a significantly important role in reducing GO to graphene. The adsorption equilibrium of Cr(VI) was reached within 80 min and the adsorption capacity was dramatically increased as the acidity of the initial solution was decreased from pH 5 to 2. Changes in ionic strength did not exert much effect on the adsorption behavior.
703.

Preparation of pitch from pyrolized fuel oil by electron beam radiation and its melt-electrospinning property

Jin-Young Jung, oung-Seak Lee 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 10 129-135 (7 pages)

Jin-Young Jung, oung-Seak Lee 저
...
- 3,000원
aromatic compounds with similar molecular weight. The diameter of melt-electrospun pitch fibers under applied power of 20 kV decreased 53% (4.7 ± 0.9 μm) compared to that of melt-spun pitch fibers (10.2 ± 2.8 μm). It is found that E-beam treatment for reforming could be a promising method in terms of time-savings and cost-effectiveness, and the melt-electrospinning method is suitable for the preparation of thinner fibers than those obtained with the conventional melt-spinning method.
704.

Effect of stacking sequence on the flexural and fracture properties of carbon/basalt/epoxy hybrid composites

Jae Il Lim, Kyong Yop Rhee, Hyun Ju Kim, Dong Ho Jung 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 9 125-128 (4 pages)

Jae Il Lim, Kyong Yop Rhee, Hyun Ju Kim, Dong Ho Jung 저
...
- 1,500원
using scanning electron microscopy (SEM). The results showed that the flexural strength and flexural modulus of the CSBC specimen respectively were ~32% and ~245% greater than those of the BSCC specimen. However, the interlaminar fracture toughness of the CSBC specimen was ~10% smaller than that of the BSCC specimen. SEM results on the fracture surface showed that matrix cracking is a dominant fracture mechanism for the CSBC specimen while interfacial debonding between fibers and epoxy resin is...
705.

Study on lowering the percolation threshold of carbon nanotube-filled conductive polypropylene composites

Seung Bin Park, Moo Sung Lee, Min Park 한국탄소학회 Carbon Letters 8 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 8 117-124 (8 pages)

Seung Bin Park, Moo Sung Lee, Min Park 저
...
- 3,000원
Conductive polymer composites (CPCs) consist of a polymeric matrix and a conductive filler, for example, carbon black, carbon fibers, graphite or carbon nanotubes (CNTs). The critical amount of the electrically conductive filler necessary to build up a continuous conductive network, and accordingly, to make the material conductive; is referred to as the percolation threshold. From technical and economical viewpoints, it is desirable to decrease the conductive- filler percolation-threshold as...
706.

Study on electrochemical performances of sulfur-containing graphene nanosheets electrodes for lithium-sulfur cells

Ki-Soo Son, Seok Kim 한국탄소학회 Carbon Letters 4 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 7 113-116 (4 pages)

Ki-Soo Son, Seok Kim 저
...
- 1,500원
in improving the performance of sulfur cathodes. In this study, a GNS/sulfur (GNS/S) composite was prepared using the infiltration method with organic solvent. The structure, morphology and crystallinity of the composites were examined using scanning electron microscopy, transmission electron microscopy, and X-ray diffraction. The electrochemical properties were also characterized using cyclic voltammetry (CV). The CV data revealed that the GNS/S composites exhibited enhanced specific-current...
707.

Superhydrophobic carbon-based materials: a review of synthesis, structure, and applications

Long-Yue Meng, Soo-Jin Park 한국탄소학회 Carbon Letters 16 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.2 5 89-104 (16 pages)

Long-Yue Meng, Soo-Jin Park 저
...
- 4,500원
Materials with appropriate surface roughness and low surface energy can form superhydrophobic surfaces, displaying water contact angles greater than 150°. Superhydrophobic carbon-based materials are particularly interesting due to their exceptional physicochemical properties. This review discusses the various techniques used to produce superhydrophobic carbon-based materials such as carbon fibers, carbon nanotubes, graphene, amorphous carbons, etc. Recent advances in emerging fields such as...
708.

Effects of pore structures on electrochemical behaviors of polyacrylonitrile-based activated carbon nanofibers by carbon dioxide activation

Hye-Min Lee, Hong-Gun Kim, Kay-Hyeok An, Byung-Joo Kim 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 10 71-76 (6 pages)

Hye-Min Lee, Hong-Gun Kim, Kay-Hyeok An, Byung-Joo Kim 저
...
- 3,000원
and Dubinin-Radushkevich equations. As experimental results, many holes or cavernous structures were found on the fiber surfaces after the CO2 activation as confirmed by scanning electron microscopy analysis. Specific surface areas and pore volumes of the prepared ACNFs were enhanced within a range of 10 to 30 min of activation times. Performance of the porous PAN-based nanofibers as an electrode for electrical double layer capacitors was evaluated in terms of the activation conditions.
709.

Preparation and application of reduced graphene oxide as the conductive material for capacitive deionization

Ayu Tyas Utami Nugrahenny, Jiyoung Kim, Sang-Kyung Kim, Dong-Hyun Peck, Seong-Ho Yoon, Doo-Hwan Jung 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 5 38-44 (7 pages)

Ayu Tyas Utami Nugrahenny, Jiyoung Kim, Sang-Kyung Kim, Dong-Hyun Peck, Seong-Ho Yoon, Doo-Hwan Jung 저
...
- 3,000원
driven by external applied voltage. RGO can be synthesized in an inexpensive way by the reduction and exfoliation of GO, and removing the oxygen-containing groups and recovering a conjugated structure. GO powder can be obtained from the modification of Hummers method and reduced into RGO using a thermal method. The physical and electrochemical characteristics of RGO material were evaluated and its desalination performance was tested with a CDI unit cell with a potentiostat and conductivity meter...
710.

Mechanical and thermal properties of MWCNT-reinforced epoxy nanocomposites by vacuum assisted resin transfer molding

Si-Eun Lee, Seho Cho, Young-Seak Lee 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2014, Vol.15 No.1 4 32-37 (6 pages)

Si-Eun Lee, Seho Cho, Young-Seak Lee 저
...
- 3,000원
strengths of the MWCNT/epoxy composite improved by 59 and 562% with 0.3 phr of MWCNTs, respectively, compared to the epoxy composite without MWCNTs. Thermal stability of the 0.3 phr MWCNT/epoxy composite increased compared to other epoxy composites with MWCNTs. The enhancement of the mechanical and thermal properties of the MWCNT/epoxy nanocomposites is attributed to improved dispersibility and strong interfacial interaction between the MWCNTs and the epoxy in the composites prepared by VARTM.

한주간 이슈검색어