학지사 뉴논문

총 1,194건 검색

본문검색 결과만 보기

정확도순

최신순

등재순

발행기간

전체
최근 1년
최근 3년
직접입력

적용하기

본문검색

포함

제외

10개씩

931.

Thermo-electrical properties of randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, N. Supriya 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2017, Vol.22 3 25-35 (11 pages)

Thakur Sudesh Kumar Raunija, N. Supriya 저
...
- 4,000원
composite. The composite body was fabricated by combining the high-pressure hot-pressing (HP) method with the lowpressure impregnation thermosetting carbonization (ITC) method. After the ITC method step selected samples were graphitized at 3000°C. Detailed characterization of the samples’ physical properties and thermal properties, including thermal diffusivity, thermal conductivity, specific heat and coefficient of thermal expansion, was carried out. Additionally, direct current (DC) electric...
932.

Disorientation angle influence on the thermal residual stresses in carbon multilayered composite plates of different thicknesses

Olga Bitkina, Ki-Weon Kang, Jang-Ho Lee 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 13 98-102 (5 pages)

Olga Bitkina, Ki-Weon Kang, Jang-Ho Lee 저
...
- 1,500원
One of the most acute problems in studying composite stress-strain states is determining the initial residual stresses during the design of layered construction elements. The full stress?strain state of composite constructions consists of the initial (generated during the manufacturing process) and operating (generated during the working period) stages. A thorough investigation of the initial stage of the stress-strain state is very important to finding the total stresses and deformations, and...
933.

Synthesize multi-walled carbon nanotubes via catalytic chemical vapour deposition method on Fe-Ni bimetallic catalyst supported on kaolin

Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 한국탄소학회 Carbon Letters 18 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 5 33-50 (18 pages)

Aliyu A, Abdulkareem AS, Kovo AS, Abubakre OK, Tijani JO, Kariim I 저
...
- 4,700원
characterized using high resolution transmission electron microscope (HRTEM), high-resolution scanning electron microscope (HRSEM), electron diffraction spectrometer (EDS), selected area electron diffraction (SAED), thermogravimetric analysis (TGA), Brunauer-Emmett-Teller (BET), and X-ray diffraction (XRD). The XRD/EDS patterns of the prepared catalyst confirm the formation of a purely crystalline ternary oxide (NiFe2O4). The statistical analysis of the variance demonstrates that the combined...
934.

Mechanical properties of epoxy composites reinforced with ammonia-treated graphene oxides

Mi-Seon Park, Sangmin Lee, Young-Seak Lee 한국탄소학회 Carbon Letters 7 Pages

한국탄소학회 Carbon Letters 2017, Vol.21 1 1-7 (7 pages)

Mi-Seon Park, Sangmin Lee, Young-Seak Lee 저
...
- 3,000원
The effects of ammonia-treated graphene oxide (GO) on composites based on epoxy resin were investigated. Ammonia solutions of different concentrations (14?28%) were used to modify GO. Nitrogen functional groups were introduced on the GO surfaces without significant structural changes. The ammonia-treated GO-based epoxy composites exhibited interesting changes in their mechanical properties related to the presence of nitrogen functional groups, particularly amine (C-NH2) groups on the GO...
935.

Biologically activated graphite fiber electrode for autotrophic acetate production from CO2 in a bioelectrochemical system

Chae Ho Im, Young Eun Song, Byong-Hun Jeon, Jung Rae Kim 한국탄소학회 Carbon Letters 5 Pages

한국탄소학회 Carbon Letters 2016, Vol.20 12 76-80 (5 pages)

Chae Ho Im, Young Eun Song, Byong-Hun Jeon, Jung Rae Kim 저
...
- 1,500원
Recently, microbial electrosynthesis (MESs) has been highlighted for the purpose of biological CO2 reduction with simultaneous production of intermediates and value-added chemicals. The bioelectrochemical system (BES), which employs microorganisms and a bacterial community as a biocatalyst, has been developed to convert CO2, a greenhouse gas, into liquid biofuels, such as ethanol and butanol, as well as platform chemicals [1]. Several bacterial species, called cathodophilic microorganisms (e.g.,...
936.

The effect of the spinning conditions on the structure of mesophase pitch-based carbon fibers by Taguchi method

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 11 89-98 (10 pages)

Zhao Jiang, Ting Ouyang, Xiangdong Yao, Youqing Fei 저
...
- 3,000원
Taguchi’s experimental design was employed in the melt spinning of molten mesophase pitch to produce carbon fibers. The textures of the obtained carbon fibers were radial with varied crack angles, as observed by scanning electron microscopy and polarized optical imaging. The diameter, crack angle, preferred orientation, and tensile modulus of the produced samples were examined to investigate the influence of four spinning variables. The relative importance of the variables has been emphasized...
937.

Adsorptive removal of atmospheric pollutants over Pyropia tenera chars

Heejin Lee, Rae-su Park, Hyung Won Lee, Yeojin Hong, Yejin Lee, Sung Hoon Park, Sang-Chul Jung, Kyung-Seun Yoo, Jong-Ki Jeon, Young-Kwon 한국탄소학회 Carbon Letters 10 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 10 79-88 (10 pages)

Heejin Lee, Rae-su Park, Hyung Won Lee, Yeojin Hong, Yejin Lee, Sung Hoon Park, Sang-Chul Jung, Kyung-Seun Yoo, Jong-Ki Jeon, Young-Kwon 저
...
- 3,000원
As a replacement for activated carbon, biochar was synthesized and used for the adsorptive removal of formaldehyde and nitrogen oxide. Biochar was produced from the fast pyrolysis of the red marine macro alga, Pyropia tenera. The P. tenera char was then activated with steam, ammonia and KOH to alter its characteristics. The adsorption of formaldehyde, which is one of the main indoor air pollutants, onto the seaweed char was performed using 1-ppm formaldehyde and the char was activated using a...
938.

Yield enhancement of matrix precursor in short carbon fiber reinforced randomly oriented carbon/carbon composite

Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 한국탄소학회 Carbon Letters 9 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 7 57-65 (9 pages)

Thakur Sudesh Kumar Raunija, Sharad Chandra Sharma, Anil Verma 저
...
- 3,000원
real system was studied. The fourier transform infrared spectrometry (FTIR), thermogravimetric analysis (TGA), yield, yield rate, and yield impact were used to check the effect of stabilization and pressure on the yield of the matrix precursor and the end properties of the composite thereafter. The results showed that the yield increased with stabilization duration up to 20 h whereas it decreased for stabilization duration beyond 20 h. Further results showed that the stabilized matrix precursor...
939.

Phenylethynyl-terminated polyimide, exfoliated graphite nanoplatelets, and the composites: an overview

Donghwan Cho, Lawrence T. Drzal 한국탄소학회 Carbon Letters 11 Pages

한국탄소학회 Carbon Letters 2016, Vol.19 1 1-11 (11 pages)

Donghwan Cho, Lawrence T. Drzal 저
...
- 4,000원
In efforts to characterize and understand the properties and processing of phenylethynyl-terminated imide (LaRC PETI-5, simply referred to as PETI-5) oligomers and polymers as a high-temperature sizing material for carbon fiber-reinforced polymer matrix composites, PETI-5 imidization and thermal curing behaviors have been extensively investigated based on the phenylethynyl end-group reaction. These studies are reviewed here. In addition, the use of PETI-5 to enhance interfacial adhesion between...
940.

Rate-capability response of graphite anode materials in advanced energy storage systems: a structural comparison

Umer Farooq, Chil-Hoon Doh, Syed Atif Pervez, Doo-Hun Kim, Sang-Hoon Lee, Mohsin Saleem, Seong-Ju Sim, Jeong-Hee Choi 한국탄소학회 Carbon Letters 6 Pages

한국탄소학회 Carbon Letters 2016, Vol.17 No.1 6 39-44 (6 pages)

Umer Farooq, Chil-Hoon Doh, Syed Atif Pervez, Doo-Hun Kim, Sang-Hoon Lee, Mohsin Saleem, Seong-Ju Sim, Jeong-Hee Choi 저
...
- 3,000원
was a detailed comparative study of the electrochemical response exhibited by graphite anodes in Li-ion batteries having different physical features. A comprehensive morphological and physical characterization was carried out for these graphite samples via X-ray diffraction and scanning electron microscopy. Later, the electrochemical performance was analyzed using galvanostatic charge/discharge testing and the galvanostatic intermittent titration technique for these graphite samples as negative...

한주간 이슈검색어