발행기관
- 한국식물병리학회(32)
- 테크노프레스(14)
- 대한수의학회(11)
- 대한기계학회(9)
- 대한생리학회-대한약리학회(6)
- 한국탄소학회(5)
- 한국소음진동공학회(2)
- 대한생리학회(1)
- 대한안전경영과학회(1)
- 인문사회과학기술융합학회(1)
- 한국농공학회(1)
- 한국정밀공학회(1)
간행물
- THE PLANT PATHOLOGY JOURNAL (26)
- STRUCTURAL ENGINEERING AND MECHANICS : AN INTERNATIONAL JOURNAL(9)
- JOURNAL OF VETERINARY SCIENCE(8)
- THE KOREAN JOURNAL OF PHYSIOLOGY & PHARMACOLOGY(6)
- 식물병연구(6)
- CARBON LETTERS(5)
- JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY(4)
- 대한기계학회논문집(3)
- KOREAN JOURNAL OF VETERINARY RESEARCH(구 대한수의학회지)(2)
- KSME INTERNATIONAL JOURNAL(2)
- STEEL & COMPOSITE STRUCTURES : AN INTERNATIONAL JOURNAL(2)
- WIND & STRUCTURES(2)
- 소음진동(2)
- GEOMECHANICS & ENGINEERING(1)
- INTERNATIONAL JOURNAL OF THE KOREAN SOCIETY OF PRECISION ENGINEERING(1)
- 대한생리학회지(1)
- 대한수의학회 학술대회발표집(1)
- 대한안전경영과학회지(1)
- 예술인문사회융합멀티미디어논문지(1)
- 한국농공학회지(1)
전체 선택해제
총 84건 검색
본문검색 결과만 보기
-
Flexural, electrical, thermal and electromagnetic interference shielding properties of xGnP and carbon nanotube filled epoxy hybrid nanocomposites
Young Sil Lee, Yeon Ho Park, Kwan Han Yoon 한국탄소학회 Carbon Letters 6 Pages
한국탄소학회 Carbon Letters 2017, Vol.24 6 41-46 (6 pages)
The microstructure, flexural properties, electrical conductivity, thermal conductivity and electromagnetic interference (EMI) shielding effectiveness (SE) of epoxy composites filled with multi-walled carbon nanotubes (CNTs), exfoliated graphite nanoplatelets (xGnPs) and CNT-xGnP hybrid filler were investigated. The EMI SE of the CNT-xGnP hybrid composite was higher than 25 dB at 100 MHz while that of the xGnP based composite was almost zero. The flexural modulus of the CNT-xGnP based epoxy... -
Biocomposite membranes based on poly(3-hydroxybutyrate-co-3-hydroxyvalerate) and multiwall carbon nanotubes for gas separation
Mongyoung Huh, Hye Min Lee, Young Soo Park, Seok Il Yun 한국탄소학회 Carbon Letters 6 Pages
한국탄소학회 Carbon Letters 2017, Vol.21 17 116-121 (6 pages)
The development of gas separation membranes is currently an active research area because of the rapidly increasing interest in carbon dioxide capture and hydrogen recovery, which are two of the most important solutions for problems related to energy and the environment [1-4]. Polymer membranes show selectivity in the separation of gases due to differences in the permeability of individual gases through the polymer film [3,4]. Even though advantageous in terms of low cost, the segmental... -
Characterization and influence of shear flow on the surface resistivity and mixing condition on the dispersion quality of multi-walled carbon nanotube/polycarbonate nanocomposites
Young Sil Lee, Kwan Han Yoon 한국탄소학회 Carbon Letters 7 Pages
한국탄소학회 Carbon Letters 2015, Vol.16 No.2 3 86-92 (7 pages)
Multi-walled carbon nanotube (MWCNT)/polycarbonate (PC) nanocomposite was prepared by direct melt mixing to investigate the effect of the shear rate on the surface resistivity of the nanocomposites. In this study, an experiment was carried out to observe the shear induced orientation of the MWCNT in the polymer matrix using a very simple melt flow indexer with various loads. The compression-molded, should be eliminated. MWCNT/PC nanocomposite sample exhibited lower percolation thresholds (at 0.8... -
Preparation and characterization of carbon fiber-reinforced thermosetting composites: a review
Fan-Long Jin, Soo-Jin Park 한국탄소학회 Carbon Letters 11 Pages
한국탄소학회 Carbon Letters 2015, Vol.16 No.2 1 67-77 (11 pages)
Carbon fibers (CFs) have a unique combination of properties which allow them to be widely used as reinforcing materials in advanced polymer composites. The mechanical properties of CF-reinforced polymer composites are governed mainly by the quality of interfacial adhesion between the CFs and the polymer matrix. Surface treatments of CFs are generally carried out to introduce chemical functional groups on the fiber surfaces, which provide the ability to control the surface characteristics of CFs.... -
광탄성법을 이용한 인장판의 경사균열 응력확대계수 측정
백태현, 이춘태, 김영철 인문사회과학기술융합학회 예술인문사회융합멀티미디어논문지 8 Pages
인문사회과학기술융합학회 예술인문사회융합멀티미디어논문지 2015, 제 5권 제 2호 24 215-222 (8 pages)
본 논문에서는 중앙에 경사 균열이 있는 시편을 원형편광기에 설치하여 인장하중을 가한 후 나타 나는 등색프린지로부터 디지털 영상처리기법을 사용하여 광탄성 프린지를 2배로 증식하여 세선처리 한 후, 이로부터 응력확대계수를 측정하였다. 경사균열 시편으로부터 광탄성 법을 이용하여 응력확대 계수를 구한 후 이론식으로 계산한 값과 비교하였다. 실험 결과는 이론값에 근접하였으며 광탄성 법 으로 응력확대계수를 정밀하게 측정할 수 있는 가능성을 제시하였다. -
웨이퍼 가공기에서 회전 원판의 동특성에 미치는 불균일 장력의 영향 분석
한국소음진동공학회 소음진동 1998, Vol.8 No.2 324-330 (7 pages)
-
원판이 결합된 외팔 원통셸의 고유진동 특성
임정식, 이영신, 손동성 한국소음진동공학회 소음진동 15 Pages
한국소음진동공학회 소음진동 1997, Vol.7 No.2 331-345 (15 pages)
-
任意의 境界條件을 갖는 鐵筋콘크리트 扇形板의 解析(II) - 第 2報 鐵筋比 및 邊長比의 影響 -
조진구, Jo. Jin-Gu 한국농공학회 한국농공학회지 9 Pages
한국농공학회 한국농공학회지 1992, Vol.34 No.1 78-86 (9 pages)
