The author has developed the computer program in order to calculate the optimum alignment condition of marine propulsion shafting by linear programming method. The input of program was calculated by the matrix method of three-moment. He compared the calculated values with the experimental values measured by the strain gage on the model shaft, and the values of calculation on actual propulsion shafting with those of Det norske Veritas. The computer program of optimum alignment has been applied to the actual shaft. The results obtained are as follows: 1. To obtain the reaction of supporting points in the straight line necessary to the optimum alignment and the reaction influence number, after the computer program had been developed and then adapted, the result of experimental values and calculated values agreed with each other and the values of the actual shaft were also approximately similar to the values of other program. 2. In this paper, the measuring method on model shaft by strain gage can be effectively used at the time of adjusting alignment condition of actual shaft. 3. The supporting bearing should be considerably readjusted to the vertical direction in order to satisfy some limited condition.