The binders introduced in Korea were originally designed to be used for Japonica varieties which have realtively long stem and are highly resistant to shattering. In order to use it for Tongil varieties which are short and easy to be shattered, mechanical modifications are necessary to reduce a grain loss incurred during its operation. This study was intended to investigate the binding unit, one of the major factors affecting grain losses. The binding parts of three binders used in Korea were analyzed and the grain loss was experimentally assessed for these binders. The results obtained from this study are summarized as follows: 1. From the motion analysis of discharge mechanism, the trajectory of the discharge arm appeared to be either circular or skewed elliptic. The velocity of a circular path mechanism was constant and smaller than that of a skewed elliptic path mechanism. The discharge grain loss of the former was about twice less than that of the latter. 2. It was found that the grain loss incurred due to the collision of the paddy bundles and ground was considerably high for Tongil varieties. The auxiliary discharge bar gave a significant influence on the motion and posture of the bundles, and the degree of impact on ground. 3. The installation of an auxiliary bar, which guides the paddy bundles smoothly to ground in order to reduce impact when the bundles fall down on ground, appeared to be very effective since the grain losses could be decreased by about 1.6 percentage point. However, the guide bar should be installed after some mechanical modification to reduce the velocity of discharge arm has been made.