The purpose of this experiment was to evaluate the effect of the drum structures and crop moisture contents on the performance of newly developed throw-in type axial thersher. Sachun No.2 malting barley with four different crop moisture levels was used as the testing material. Four different types of threshing drum; the cylindrical drum-equipped with teeth or rubber bars and the conical drum-equipped with teeth or rubber bars were tested. The results are summarized as follows; 1. The threshing efficiency of cylindrical drum was higher than that of the conical one, and the drum with teeth was more effective in threshing than the one with bars. However, the higher the threshing efficiency over the whole range of moisture levels and drum speeds given, the more the rapid and unexpectable variations in threshing efficiencies 2. The separation efficiency of the conical drum was decreased as drum speed was increased and was not so much influenced as crop moisture content. But in case of the cylindrical drum, the result was shown in opposite way to that of the conical one. The separation efficiency of the drum with teeth was higher than that of the drum with bars and no significant decrease in separating efficiency was found at wet crop condition. 3. Foreign matters other than grain passing through the concave sieve was decreased as crop moisture content was increased, and the purity was increased at middle range of drum speed regardless of drum types. 4. Minimum grain loss was found at 700 rpm to 800 rpm of drum speed for all types of drums. The effect of crop moisture content on total grain loss was varied with drum types. As far as the grain loss is concerned, the conical drum having teeth was not so greatly influenced by various crop moisture contents and drum speeds as compared with the other types of drum. 5. Generally, the crop moisture content has more relevant effect on the germination than the drum speed regardless of drum types. The germination percentage of grain threshed by the conical drum and the bar attached drum were higher than those of cylindrical one and teeth attached one, respectively.