To investigate stability for the quality of selected ginseng products, their sorption properties were clarified in red ginseng extract(RGEP), and red ginseng extract powder(RGEP), and red ginseng extract tea(RGET). Simultaneously, the BET monolayer value of each product was determined in order to inquire out the possibility of establishment as a criterion for the optimum moisture content of the ginseng products. Based on the BET monolayer moisture level of spray dried RGEP which ranged from 4.08 to 4.65%, it would be desirable to establish the optimum moisture content of the products at 4.4${pm}$0.3%. This is 1.3 to 1.9% lower than the criter on, "less than 6.0%". The optimum moisture level for RGET of which monolayer value ranged 0.93 to 1.37% would be 1.2${pm}$0.17%. In this case, the maximum permissible limit of moisture content could presumably be raised up to 1.37% in place of current criterion, "less than l.2%". From the results of a study on the growth of molds, the optimum moisture content for RGE assumed to be extended up to 40.0${pm}$1.07 despite 36.0${pm}$1.0% of the present criterion. On the other hand, a storage study under the maltreated condition, $48{pm}2^{circ}C$ 75%RH, was also carried out in order to make it clear whether the BET monolayer values were able to be used as indices for optimum moisture level of the products. In all samples tested adsorption occurred at even higher levels of moisture than the monolayer values. However, since there are many other possible factors affecting the quality of products the optimum moisture content is preferable to be reduced to the monolayer value. As a result, it was proved that the optimum level of moisture for both RGEP and RGET could be established by the monolayer values.