본 연구에서는 공구(bite)의 형상에서 상면경사각을 변화시켜 이에 따른 절삭 저항의 3분력을 측정하여 그 값에 대한 합력과 비절삭저항 그리고 거칠기 등 3값을 normalization 과정으로 energy method에 의하여 이들 SM20C 및 SM45C 재료를 구분하 여 각각의 절삭저항과 그 특성을 규명하고져 하였으며 아울러 재료별 최적조건을 찾고 자 한다.
The optimum cutting condition of rake angle in turning was investigated in SM45C and SM20C. Results of experiments in SM45C and SM20C are as follow. Specific cutting resistance became higher as the depth of cutting, feed or cutting velocity decreases at same rake angle and resistance became low value at 20.deg.(SM45C), 10.deg.(SM20C). The optimum cutting condition for SM45C is depth of cutting 0.7mm, rake angle 30.deg., cutting velocity 200mm/min, feed 0.1mm/rev, and for SM20C is depth of cut 0.5mm, rake angle 10.deg., cutting velocity 150mm/min, feed 0.1mm/rev.The rake angle for good roughness is 15.deg for SM45C, and that for SM20C is 25.deg. The roughness is influenced by feed and it has the lowest value at 0.1mm/rev and the cutting condition is closely related with the change of cutting velocity and feed.
