본 연구에서는 이러한 경우를 대상으로 하여, 채터발생의 주원인이 공구가 되도록 돌출길이를 충분히 길게 한 상태에서 공구체결부에 점탄성재료를 삽입하고 채터진동 억제 효과를 검토하였다. 또한 점탄성 재료 삽입으로 인한 공구 고정부의 강성 및 감쇠의 변화를 공구고정부에 대한 유한요소해석(FEA) 및 충격실험 등을 수행 하여 알아보았으며, 정적 강성의 저하로 인해 안정절삭조건에서 발생할 수 있는 정밀 도저하를 검토하여 보았다.
This work is concerned with the chatter suppression by inserting viscoelastic materials into tool clamping area. Chatter was observed with and without the viscoelastic materials during cutting tests, where the overhang of the tool was made long so that the tool may be a major cause for the chatter. Two viscoelastic materials were used and the effects of thickness and prestrain were investigated. impact tests were performed on the tool in cases where the tool post was set on the cross slide and was free from any boundary conditions. Material properties of the viscoelastic materials were also obtained from resonance test results. The effects on the chatter suppression by the type of the viscoelastic material and prestrain are discussed in relation with the measured material properties.
