In order to achieve the autimation and untended system of manufacturing process, it is necessary that the monitoring system check up the disorder of machine tool or the conditions of tool wear for the maximum use of cutting tool. In the metal cutting Process, AE signal is detected by AE sensor, then amplified and transmitted to an Locan-AT. The experiment was performed to SM25C and STS304 steels at uniform feedrate, cutting speed and depth of cut, The results of experimental data apparently showed emission intensity vary due to increasing of tool wear at the 165kHz, 200kHz in the SM25C and 140kHz, 165kHz, 200kHz, in the STS304 respectively Therefore, it is possible to predict the tool wear. This study is intended to suggest the way to the automation and untended system of machine tool through the system monitoring tool wear by using AE signal