In this study power requirements to saw shoots with circular saw were determined by measuring and analyzing the required maximum torque to provide the information for the mechanization of Korean pine cone harvest. Two levels of feed rate of shoots, 10.4mm/s and 20.8mm/s, three levels of sawing speed 5.8㎧, 11.6㎧, and 17.4㎧, and 14 levels of shoot diameter from 7.7 to 18.1mm were used as variables. 1) The maximum torques were significantly affected by all three variables. The average maximum torque, 18.2 N-cm for feed rate of 20.Bmm/s was greater as much as 80% of 10.1 N-cm for feed rate of 10.4mm/s. 2) As the sawing speed was increased from 5.8㎧ to 11.6㎧ and 17.4㎧, the maximum torques were decreased to 14.8N-cm, 8.5N-cm, and 7.IN-cm, respectively when the feed rate was 10.4mm/s. The maximum torque ranged from 4.5 to 19.3N-cm as shoot diameter increased from 7.7 to 18.1mm. The minimum power requirements to saw shoots of 18.1mm with circular saw was 30W for the feed rate of 10.4mm/s. 3) The maximum torques were 28.6N-cm, 14.6N-cm, and 11.4N-cm when sawing speeds were 5.8㎧, 11.6㎧, and 17.4㎧, respectively when the feed rate was 20.8mm/s and these torques were increased as much as 93%, 36%, and 61% of those for the feed rate of 10.4mm/s. The maximum torque increased from 9.7N-cm to 30.7N-cm as shoot diameter increased from 7.7 to 18.1mm. The minimum power requirements to saw shoots of 18.1mm was 54W which was 1.8 times of 30W for the feed rate of 10.4mm/s.