The pretreatment of bark powder with sodium hydroxide and formalin showed the most excellent adsorption ratio, but this method could not practically be used because of the occurrence of dark-colored pigments in filtrates during pretreatment. Instead, acid and formalin were the most affirmative and effective among the pretreatment methods tested, and could be used for this purpose. Among tested species, Quercus acutissima and Robinia pseudo-accacia showed the largest amount of metal adsorption, and $Pb^{2+}$ was the best(83 to 96%) among the four heavy metals tested. The order of adsorption ratios other metals was as follows; $Cu^{2+}$ > $Zn^{2+}$ > $Cd^{2+}$, and the ratio was approximately 45 to 55%. In addition, as the substrate amount increased, the amount of adsorbed heavy metals in subtrates gradually increased, but the adsorbed amount was not proportional to the substrate amount. The order of heavy metal adsorption was as follows; $Pb^{2+}$ > $Cu^{2+}$ > $Cd^{2+}$ > $Zn^{2+}$. Depending on flow rate and column size, pine bark power adsorbed more heavy metals in the 5ml/min flow rate and 3.5cm column size rather than the 10ml/min and 2.0cm. However, oak bark power showed contrary results compared with pine bark powder. The adsorption of $Pb^{2+}$ occurred rapidly in the incipient stagte. Even though bark powders were repeatedly used three times, there was no change in the adsorption ratio(45%), but after four times, the adsorption ratio was significantly reduced to 35%.