In the process of car body design, various surfaces are generated from the given boundary curves. Depending upon the method of the surface generation and the quality of the boundary curves provided, the resulting surfaces may have global or local irregularities in many cases. Thus it would be necessary for the designer to evaluate the surface quality and to modify the surface or to use the different generation method based on the evaluation results. This capability is very important because the defect of the surface quality detected in the production stage will require the rework of the dies and will cause a big loss in cost and time. A method of surface interrogation using reflection line is introduced. In this paper, We applied reflection mapping to generate reflection lines on the trimmed NURBS surface. Since reflection lines are obtained from reflection mapping that uses simple and physically acceptable mapping algorithm, they can be efficiently used to simulate the reflection test on the real part in the production line.