The sulfonamide is one of potentiative antimicrobial agents which is being used widely in veterinary medicine for control of several animal diseases such as mastitis as well as for promotion of growth. However, the misusages of sulfonamides in food producing animals, especially cattle produce several considerable problems in human health caused from residues of this antibiotic in milk product. To determine the most effective analytical methods for residual sulfonamides in raw milk, this study was performed comparatively using by some applicable screening detecting method such as TTC, Charm II test (sulfonamides), and Lactek tests (sulfamethazine kit). The positive result from screening tests was confirmed by HPLC method. Milk samples (540 raw milks) were collected from dairy farms. Results of this study are summariezed as follorrs ; 1. All samples (540 raw milks) showed negative response from TTC test, however, 18 raw milks of those samples responded positively to Charm II test. 2. By Lactek test, residual sulfamethazine was detected from 4 raw milks. Fifteen raw milks of 18 samples which were classified as positive one by Charm II test, showed positive response 3. Retention time of sulfonamides added at the level of 100ppb into sklm milk was ranged from 1.55 minute to 23.3 minute. Recovery rates of sulfonamides were variable from 6.7% upto 94.2% depended on the types of sulfonamlde. 4. Single type of sulfonamides was detected from 10 raw milk samples, 2 types of sulfonamides from 3 samples and 3 types from 2 raw milks by HPLC. 5. Sulfonamides was detected in this study were 5 types : 11 samples for sulfisomidine, 5 samples for sulfamethazine, 3 samples for sulfadlmethoxine, 2 samples for sulfathiazole and 1 sample for sulfadiazine. 6. The highest levels of residual sulfonamides was 210.3 ppb of sulfamethazine but the lowest concentration of residue was 2.2 ppb of sulfamethazine and sulfisomidine, respectively. Number of samples detected positively in this experiment were belows : above 100 ppb for 1 sample (4.5%) (sulfamethazine), 50~100 ppb for 4 samples (18.1%) (each 2 samples for sulfamethazine and sulfisomidine, respectively), 25~50 ppb for 6 samples (27.1%) (2 sulfisomidine, each 1 sample for sulfadiazine, sulfadimethoxine, sulfamethazine and sulfathiazole, respectively), 10~25ppb for 3 samples (13.7%) (3 sulfisomidine), and below 10ppb for 8 samples (36.4%) (4 sulfisomidine, 2 sulfadimethoxine and each 1 for sulfamethazine and sulfathiazole).