In this study. a traveling control system was developed to transfer a machine without an operator in the working zone. The dimension of the system was modelized to design and construct smaller than that of real configuration of a greenhouse. For this system, the fixed path type was used to detect exact position during operating a manless machine. and the X-Y table actuator type to escape a unique path, which had the disadvantage in a fixed path type environment. Based on the results of this research the following conclusions were made : 1. This system used two screws to move toward horizontal direction, and a Plate to reach at any points in the working zone. 2. The software combined the functions of path selection and motor operation to control into one program. The path selection program was a menu driven program written in Visual Basic, and the motor operation program was written in Borland C++ for actuating motors. 3. The path-select mode of the program was used by selecting the desired paths, and the user path-create mode by selecting a random path in the path-selection program. 4. The system proved to be a reliable system for operating a manless machine, since accuracy and precision to reach the positions were less than 1%.