This study investigated the effects of resin surface primers for rebase resins on the surface texture of denture base resins by the use of scanning electron microscopy. This study also evaluated the bond strength of rebase resins to denture base resin. The denture base resin in this study was Vertex RS (Dentimex Co., Ltd., Holland). The rebase resins used were Tokuso Rebase (Tokuyama Co., Ltd., Japan), Metabase (Sun Medical Co., Ltd., Japan), New True Liner(Harry J, Bosworth Co., Ill.), and Reverse (Nissin Co., Ltd., Japan). The test samples were divided into four parts: Group 1 : Treated with primer with brush. Group 2 : Immersed in the primer for 5 seconds. Group 3 : Immersed in the primer for 10 seconds. Group 4 : Immersed in the primer for 30 seconds. Control group : not treated with primer The results were as follows; 1. The bond strength of rebase resins to denture base resin is increased by application of primers. 2. Regardless of the rebase resin type, there was no significant difference among the bond strength in groups G1, G2, G3, G4. There was a significant difference with the control. (P<0.05) 3. Regardless of each group, the bond strength according to the rebase resin type was decreased in the following order: Tokuso Rebase, New Tru Liner, Reverse and then Metabase. 4. Under the scanning electron microscope, brush application produced a softening of the denture base surface. After immersion, all primers produced a spongelike structure on the denture base resin surface. The results of this study suggest that primers produce a significant effect by means of brush application, therefore it is recommended as the most convenient and logical procedure for application of the primers.