Solidification simulation of gray cast iron sheave product was conducted with the consideration of graphite precipitation during solidification, and of casting processes such as post-inoculation method, treatment and rate, the result of which was aimed to be adopted in the field. In risering design(I), shrinkage cavities were predicted to occur in the part below the risers and center part of the product. While the former defect was considered to be due to the solidification behaviour of riser neck, the latter was due to the feeding channel. In design(II), the length of the riser neck was reduced and one top open riser was attached in the center of the product to prevent the formation of shrinkage cavities, whereby defect-free product was produced.