Effectiveness of corrective machining algorithm is verified experimentally in this paper by performing corrective machina work practically to single side and double sides hydrostatic tables. Lapping is applied as machining method. Machining information is calculated from measured motion errors by applying the algorithm, without information on rail profile. It is possible to acquire 0.13$mu$m of linear motion error, 1.40arcsec of angular motion error in the case of single side table, and 0.07$mu$m of linear motion error, 1.42arcsec of angular motion error in the case of double sides table. The experiment is performed by an unskilled person after he experienced a little of preliminary machining training. Experimental results show that corrective machining algorithm is very effective, and anyone can improve the accuracy of hydrostatic table by using the algorithm.