Bi-2223 superconducting wires with 55 filaments were fabricated by stacking, drawing process with different heat-treatment histories. Two kinds of powders were prepared. One was pre-annealed at 760-820 $^{circ}C$ and low oxygen partial pressure, and the other was only calcined state. Before rolling process, round wires were pre-annealed at 760 -820 $^{circ}C$ and in a low oxygen partial pressure. We confirmed that pre-annealing step was to transform Bi-2212 orthorhombic structure from Bi-2212 tetragonal structure and to reduce the formation of second phases at superconducting wire. However Bi-2223 phases were formed at higher pre-annealing temperature. Bi-2223 conductor was needed frequently annealing at low temperature because pre-annealing at precursor powder brought about decrease in workability. We could achieve highest Je of 6500 A/$ extrm{cm}^2$ at the tape using Bi-2212 orthorhombic phase by introduced slightly overheating at the 1st sintering process.