Distributed Network Protocol Version 3.0 (DNP3.0) is the communication protocol developed for the interoperability between a RTU and a central control station of SCADA in the power utility industry. In this paper DNP3.0 is implemented by using HDL with FPGA and C program on Hitachi H8/532 processor. DNP3.0 is implemented from physical layer to network layer in hardware level to reduce the computing load on a CPU. Finally, the ASIC for DNP3.0 has been manufactured from Hynix Semiconductor. The commercial feasibility of the hardware through the communication test with ASE2000 and DNP Master Simulator is performed. The developed protocol becomes one of IP, and can be used to implement SoC for the terminal device in SCADA systems. Also, the result can be applicable to various industrial controllers because it is implemented in HDL.