The injection-molded plastic parts have many surface defects: warpage, weldline, flowmark, zetting, scratching, shading and so on. As weldline was one of the major surface defects in the case of desktop monitor, warpage and surface shrinkage are the bigger problems of LCD monitor in the pursuit of light weight and thinner thickness of parts. Some measures to improve these defects were introduced in this paper. Based on these, the laboratory work to find out the optimum processing conditions and to get the best parts was repeated injection moulding try-out after reflecting these improvements. The defects of warpage and surface shrinkage was significantly improved after the improvements in the case of the 20.1 inch even if in the 15 and 17inch case the warpage size was a lttle over the allowed specification because of not taking the measure for parts design within the allowable limits from the required specification in the cause of cost down