The purpose of this study was to research the design methods to express jacquard design using CAD. For this study, two design patterns were divided; in addition, each design pattern is applied to two different weaving types, single woven fabric and double well cloths. As a result, 16 samples were produced by applying 4 design methods (warp shrunk as half size design/weft shrunk as half size design - A, warp shrunk as half size design/weft original size design - B, warp original size design/weft shrunk as half size design - C, warp original size design/weft original size design - D) to the two design patterns with the two weaving types. The result of this study can be summarized as follows. 1. The most delicate design method was Method D. However, Method B which took half the time less than Method D was almost as delicate as the Method D on the surface. 2. Method B was judged as a considerably efficient method for time and cost. 3. Method D was considered as most suitable for elaborate parts and delicate lines. However, it was considered uneconomical since it took the longest time. 4. Mettled A took 2.5 times less time than Method D. Therefore, Method A was more applicable to producing high density design. 5. Method C is not considered as a useful method as it showed rough surface and took long time by applying high design zoom except intentional design.