Snap-fit is being used in manufacture of plastic products. Integral features using snap-fit are classified as locks, locators and enhancements. Locking features complete the process of attachment by providing physical interference to prevent separation. Looking feature pairs consist of two components, i.e., a flexible latch and a rigid catch and require particular care and attention for their selection. We can make several locking feature pairs by selecting latch and catch, but some parts restrict freedom of selection. Therefore, part designers must know the characteristic properties of generic locking feature forms as considering a specific design problem. In this paper, it has been presented about problem of small size products using locking feature and then introduced new locking feature applicable to small parts.